永磁同步电动机

  • 网络PMSM;permanent magnet synchronous machine;IPMSM;Permanent Magnet Synchronous Motor, PMSM
永磁同步电动机永磁同步电动机
  1. 介绍了该永磁同步电动机控制系统的硬件、软件设计与调试。

    Hardware and software design and debugging of the PMSM control system are mentioned .

  2. 研制高性能的永磁同步电动机伺服系统是机电工作者所面临的一项重要任务。

    It is an important task for the mechanical and electrical engineers to research and manufacture the PMSM servosystems of high performance .

  3. 稀土永磁同步电动机CAD系统

    The CAD System for the Rare Earth Permanent Magnet Synchronous Electromotor

  4. n相逆变器&永磁同步电动机系统的通用仿真模型

    A General Simulation Model of n-phase Permanent Magnet Synchronous Motor Driven by Inverter

  5. 增安型稀土永磁同步电动机tE时间的研究

    Research on the t_E of Increased-safety Rare Earth Permanent Magnetic Synchronous Motor

  6. 永磁同步电动机的矢量控制及其在DSP上的实现

    Vector Control for Permanent Magnet Synchronous Motor on DSP

  7. 永磁同步电动机驱动系统数字PI调节器参数设计

    Design of PMSM Drive System Digital PI Adjuster Parameters

  8. 基于变参数PI的永磁同步电动机矢量控制系统

    Vector Control System of Permanent Magnet Synchronous Motor based on Variable Arguments PI Controller

  9. 推导出永磁同步电动机(PM电机)的数学模型。

    The mode of PM motor is derived .

  10. 为提高永磁同步电动机控制系统的抗扰性能,设计了一种新型的模糊PI控制器。

    In this paper , a novel control strategy of fuzzy-PI control is presented for single-phase SPWM inverter .

  11. SPWM电源供电下低速大扭矩永磁同步电动机设计研究

    Study on Low Speed and High Torque PMSM Design with SPWM Power Supply

  12. 自适应Backstepping在永磁同步电动机速度跟踪控制中的应用

    Speed Tracking Control of Permanent Magent Synchronous Motor with Adaptive Backstepping

  13. 基于主动Backstepping方法的永磁同步电动机混沌运动的控制

    Controlling chaos in permanent magnet synchronous motor based on the active Backstepping method

  14. 并利用MATLAB软件搭建了整个控制系统的仿真模型,研究了基于滑模观测器的永磁同步电动机伺服控制系统。

    And using of MATLAB software built a simulation model of the whole control system , servo control system of based on the sliding-mode observer of PMSM is studied .

  15. 介绍了PWM控制技术的特点,并在MATLAB环境下,构造永磁同步电动机PWM控制的仿真模型。

    This paper introduces the characteristics of PWM control technology , and it found the simulating model for interior permanent magnet synchronous motor PWM control in MATLAB environment .

  16. 在Matlab仿真平台下建立了永磁同步电动机矢量控制系统的仿真模型,并在此基础上进行PID控制器和滑模变结构控制器的对比仿真分析,及死区效应补偿方法仿真分析。

    Using the Matlab software , the simulation model for PMSM vector control system is established . In addition , the comparative study of the PI controller and sliding mode controller are carried out .

  17. 通过对永磁同步电动机的动态过程进行仿真,分析永磁同步电动机采用PWM控制技术的瞬态运行特征以及瞬态过程中各电磁量的变化规律。

    Via the simulation of dynamic process for interior permanent magnet synchronous motor , it analyzes the instantaneous characteristics and change law of PWM control technology for interior permanent magnet synchronous motor .

  18. 针对五相永磁同步电动机,构建了三电平逆变器供电的变频调速系统,对五相三电平逆变器的空间矢量PWM控制算法进行了研究。

    For five-phase permanent magnetism synchronous motor ( PMSM ), the variable-frequency variable-speed system is set up supplied with three-level inverter . Space vector PWM control algorithm of five-phase three-level inverter is studied .

  19. 介绍一种基于Halbach阵列的多盘式无铁心永磁同步电动机。

    This paper introduces a multi-disc coreless permanent magnet synchronous motor based on Halbach array .

  20. 其次在深入研究永磁同步电动机矢量控制理论的基础上,建立了基于电流滞环PWM、SPWM和SVPWM三种调制策略的永磁电动机矢量控制仿真模型,并对模型进行了仿真分析与比较。

    Then based on the theory of PMSM Vector Control , the simulation model which use the modulation strategy of current hystersis PWM , SPWM and SVPWM have been established .

  21. 通过分析永磁同步电动机PI控制的不足,在对传统模糊-PI混合控制策略进行改进的基础上,介绍参数模糊自整定PI控制策略。

    A novel fuzzy control strategy is proposed to control PMSM speed servo system . This scheme based on the analysis of traditional PI control and the Improvement of traditional fuzzy-PI mix control scheme .

  22. 采用永磁同步电动机作为推进装置的驱动单元,选用的矢量控制作为控制策略并结合SVPWM技术,完成驱动系统的设计。

    PMSM was chosen for the driving unit of the propulsion system . The driving system was designed under the theory of vector control and the SVPWM technology .

  23. 为实现永磁同步电动机的低速无传感器控制,采用了高频信号注入法,同时将EKF引入到高频信号注入法的滤波环节当中,避免了传统滤波器带来的相位滞后等问题。

    Meanwhile , EKF was introduced into the filtering aspects of the high-frequency signal injection method . This method avoided the phase lag of traditional filter .

  24. 随着DSP的问世和永磁电动机及其控制技术的快速发展,以永磁同步电动机为推进电机、采用高性能控制策略的全数字化电力推进技术显示出广阔的应用前景。

    With the coming out of DSP and the rapid development control technology with Permanent Magnet Synchronous Motors ( PMSM ), digital controlled electric propulsion technology will have a wide foreground , which uses PMSM as power units and adopts high quality control strategy .

  25. 以风力发电项目为背景,应用电压空间矢量脉宽调制技术(SVPWM)的控制方法,分析了永磁同步电动机矢量控制原理并研究了永磁同步电机的控制策略。

    A novelty space vector pulse width modulation ( SVPWM ) technique for the two-phase inverter-fed asynchronous motors system is proposed , which can be widely used in the low or middle power level field .

  26. 本论文首先分析并推导了永磁同步电动机的数学模型,得到了永磁同步电动机dq坐标系下电压方程、磁链方程以及转矩、功率和效率特性方程。

    The paper originates from the PMSM itself , the math model of PMSM was deduced and obtained , and the torque character of PMSM , power character and efficiency were analyzed .

  27. 介绍应用于混合动力汽车上的永磁同步电动机的结构、工作原理、控制方法。并对永磁同步电动机在丰田prius轿车上的应用进行分析。

    S : Taking Toyota Prius as the case , it presents the configuration , working principle and control methods of the permanent magnet synchronous motor used on hybrid power vehicle .

  28. 最后,利用MATLAB仿真软件对永磁同步电动机的直接转矩控制系统进行了建模并对系统进行了仿真,其中详细介绍了各个仿真模块的构建,通过仿真结果初步验证了直接转矩控制方法的合理性。

    Finally , with the help of MATLAB simulation software , the direct torque control system of permanent magnet synchronous motor is modeled and simulated , in which the construction of all simulation modules are described . The results show that the method of direct torque control is reasonable .

  29. 同时,为了提高平面倒立摆系统的控制性能,本文在考虑永磁同步电动机驱动性能的情况下,分别采用模糊自适应PID和完全模糊控制进行平面倒立摆系统的稳定和跟踪控制。

    In order to improve the control performance of planar inverted pendulum , by considering the drive performance of permanent magnet synchronous motor , we adopt the fuzzy adaptive PID and the full fuzzy control to carry out the stability and tracking control of planar inverted pendulum system respectively .

  30. 在硬件电路基础上,结合系统的仿真研究,完成了包括永磁同步电动机矢量控制算法、SVPWM生成、相关量检测等模块的系统软件设计。

    Based on the hardware design and the simulation experiments , the software design was accomplished . The whole program contains lots of modules like PMSM vector control algorithm module , SVPWM module , detection module and so on .