受热面

shòu rè miàn
  • Heating surface;hot area
受热面受热面
  1. W火焰锅炉受热面超温原因分析及对策

    Cause Analysis of Exceeded Temperature on Heat Surface of W-Flame Boiler

  2. 基于Solidedge的三维加热炉余热锅炉受热面设计软件的开发

    The R & D of 3D Software to Heating Surface of the Waste Heat Boiler for Heat Furnace Design Based on Solid Edge

  3. 大型CFB锅炉受热面过热保护

    Superheating Protection of Heat Surface of Large-scale CFB Boiler

  4. 烟气中水分对循环流化床受热面上CaO碳酸化特性的影响

    Influence of Flue Gas Moisture Content on CaO Carbonation on Heat Surfaces of CFB Boilers

  5. 根据额定工况下不同受热面进出口烟温差,建立了基于BP网络的污染诊断模型。

    A contamination diagnosis model is built according to the difference of inlet and outlet gas temperatures of different surfaces in normal condition .

  6. 根据上述A、B二线所确定的区域得到超(超)临界锅炉高温受热面安全经济运行温度控制域。

    According to the areas determined by the A , B lines ,( ultra - ) supercritical boiler heating temperature safe and economic operation temperature control field is got .

  7. 主要内容如下:本文基于电厂DCS系统的监测数据,提出了一套完整的电站锅炉受热面结渣积灰监测方法,用以在线监测锅炉结渣和积灰的程度。

    In this paper a slagging and fouling monitoring system is put forward to monitor the degree of boiler .

  8. 135MWCFB锅炉局部受热面防磨优化方案

    Optimization on Anti-abrasion of Local Heating for 135 MW CFB Boiler

  9. 正确计算锅炉的半辐射式受热面运用ANSYS软件对注塑机调模板进行有限元分析

    A Study on the Heat Transfer Calculation of Rear Platen Heating Surface The finite element analysis of the rear platen of injection molding machine with ANSYS software

  10. 600MW燃煤锅炉受热面污染特性试验研究

    Experimental research on fouling characteristics of heating surfaces in a 600 MW boiler

  11. YG130/3.82M型锅炉受热面改造

    Heating Surface Transformation in YG-130 / 3.82-N Boiler

  12. 330MW机组锅炉受热面污染特性的试验研究

    Experimental research on slagging characteristic of heating surface of 330 MW boiler

  13. 根据YG130/3.82M型流化床锅炉的实际运行情况,对该炉存在的制约生产的问题进行了分析,提出了受热面改造方案,并对改造前后的相关运行参数进行了比较。

    According to the actual movement situation , this paper analyses the reasons restricting the production and proposed the heating surface transformation plan .

  14. 结合旺隆电厂设备结构现状,脱硝技改分为低氮燃烧系统改造、锅炉尾部受热面改造、SCR系统改造三个部分。

    Wang Long structure with the status quo of power plant equipment , technical transformation into low-NOx combustion system , nitrogen transformation , transformation of boiler heating surface of the tail , SCR system transformation in three parts .

  15. 电站锅炉受热面小径管射线探伤通常使用X射线或192Irγ射线进行探伤,都有其局限性。当前,一些工业发达国家在小径管的射线探伤中应用了75Se射线源。

    Owing to the limitations of small bore tube radiographic examination of utility boiler heating surface by X or 192 Ir γ rays , 75 Se radiographic source is now applied for this purpose in some industrially developed countries .

  16. 超细煤粉燃烧不仅有降低NOx排放的作用,在燃烧特性方面也表现出着火温度低、燃尽率高、减弱或消除飞灰在炉内受热面上的沉积与结渣等特点。

    Combustion of micro-pulverised coal has not only the function of decreasing NOX emission , but also represents some combustion characteristics such as low ignition temperature , high burn-off rate , reduction or removal of settling and slag-off made of fly ash on heating surface in furnace .

  17. 研究表明,烟气中SO3的形成和硫酸蒸汽的凝结是工业锅炉运行时低温段受热面管道腐蚀发生的根本原因。

    The test results show that the basic reasons of the corrosion of the piping at low temperature zone heated side of industrial boiler are the formation of SO 3 in the smoke and the coagulation of the sulphuric acid vapour on the metals in operation .

  18. 通过对哈尔滨锅炉厂300MW、600MW锅炉设备等受热面管子管端缩口工艺的研究和对管端缩口基本原理、工艺设计原则的分析,提出了缩口工艺新方法及工艺参数。

    Through study on pipe end shrink mouth technology of 300 MW , 600 MW boiler heated surfaces made in Harbin Boiler Works as well as analysis of principle of pipe end shrink mouth and technology design , a new method of shrink mouth technology and parameters are proposed .

  19. 大容量电站锅炉受热面管子的可靠性设计与寿命评定

    Reliability Design and Life Assessment of Large Capacity Station Boiler Tubes

  20. 对锅炉受热面管子管端缩口工艺的研究

    Study on Pipe End Shrink Mouth Technology of Boiler Heated Surfaces

  21. 锅炉高温受热面温度超限在线监测和诊断

    On-line monitor and diagnosis systems for boilers ' heating surface over-temperature

  22. 角管式热水锅炉尾部受热面严重腐蚀探讨

    Research on Tail-heating Surface Corrosion of Corner Tube Hot Water Boiler

  23. 流化床锅炉受热面销钉焊接缺陷的处理

    Welding Defect Disposal of Stainless Steel Pins in the CFB Boiler

  24. 草浆低压碱炉尾部受热面布置

    Arrangement of Tail Heating Surfaces of Straw Black Liquor Recovery Boiler

  25. 锅炉受热面管的复合涂层防护的研究

    Study on composite coating protection for heating surface tubes in boilers

  26. 锅炉受热面焊接时缺陷的产生原因及对策

    Reasons for Welding Defects of Boiler Heated Surface and Preventing Measures

  27. 开封火电厂3号炉尾部受热面改造

    Retrofitting heat recovery surface of boiler No.3 at Kaifeng power plant

  28. 电厂锅炉受热面管子爆漏的结构因素

    The Structure Factor of Power Station Boiler Heating Surface Pipes Splitting

  29. 电站锅炉两类受热面通用动态计算模型

    A General Dynamic Mathematical Model to Simulate Boiler 's Heat-Transfer Surfaces

  30. 火电厂锅炉尾部受热面检修技术

    The Overhaul Technology of Rear Heating Surface in Power Plant Boiler