热震稳定性

  • 网络thermal shock resistance;heat shock stability
热震稳定性热震稳定性
  1. 该产品抗腐蚀、热震稳定性好,适用于陶瓷行业、电力锅炉行业。

    This product has good corrosion resistance and thermal shock resistance , it is suitable for ceramic industry , electricity industry and boiler industry .

  2. 不同含量Y2O3的ZrO2对Al2O3复合陶瓷热震稳定性的影响

    Effect of Y_2O_3 Contents in ZrO_2 on Thermal Shock Resistance of Al_2O_3 Composites

  3. SiO2微粉结合镁质浇注料的热震稳定性研究

    Study on thermal shock stability of sio_2 breeze bonded mg casting material

  4. 碱性耐火材料对钢水增氧作用小,镁质耐火材料是最常见的碱性耐火材料,但其热震稳定性差。本研究希望加入SiC以提高其热震稳定性。

    The Base refractories has little effect on the total oxygen content of steel but has poor thermal shock property .

  5. 800℃烧后以及1400℃烧后热震稳定性随着SiC粉料引入量的增加先提高,后下降。

    Thermal shock resistance of samples sintered at 800 C and 1400 C were improved at first then decrease with increasing SiC content .

  6. 加入AlON或SiAlON对Al2O3-MgO钢包浇注料热震稳定性的影响

    Effect of adding AlON or SiAlON on thermal shock resistance of Al_2O_3-MgO ladle castable

  7. αAl2O3加入量为10%~15%时浇注料具有最佳的热震稳定性;

    By adding 10 % ~ 15 % of w_ α - Al_2O_3 , the thermal shock resistance of the castable is the best .

  8. 第三部分是SiC含量对MgO-SiC复合材料热震稳定性的影响。

    The third part is effects of different SiC content on thermal shock property of MgO-SiC composites ;

  9. 研究了锆荚石和氧化铝的加入量对镁质浇注料常温物理性能、热震稳定性、高温抗折强度(145℃,1h)及抗渣性能的影响。

    Effects of zircon and alumina additions on physical properties at room temperature , thermal shock resistance , hot modulus of rupture and slag resistance of MgO-based castables were investigated .

  10. 在第三部分工作中,作者探讨了SiC含量对MgO-SiC复合材料热震稳定性的影响。

    In the third part the author studied the effect of the content of the SiC on the resistance of MgO-SiC composite to thermal shock .

  11. 以刚玉、尖晶石、纯铝酸钙水泥和氧化铝微粉为主原料,研究了氧化锆对刚玉-尖晶石浇注料热震稳定性的影响,并采用X射线衍射和扫描电镜分析了试样的相组成和显微结构。

    The influence of zirconia on thermal shock stability of corundum-spinel castables was studied by using corundum , spinel , calcium aluminate cement and ultra-fine alumina powder as main starting materials , the phase compositions and microstructure were studied by using XRD and SEM .

  12. 以氧化铝空心球为骨料,基质中加入适量的SiO2及硅线石,生产出了热震稳定性好、重烧线变化率小的氧化铝空心球砖。

    Using alumina bubble as aggregate and adding an amount of silica and sillimanite in the matrix , an alumina bubble brick with good thermal shock resistance and low reheating linear change has been developed .

  13. 对于已经添加了红柱石的试样,随着SiC细粉引入量的增加,烘后以及1100℃烧后强度下降,1400℃烧后强度上升,1100℃烧后热震稳定性提高。

    For the castable with andalusite , MOR of samples dried and soaked at 800 C decreases and that of samples sintered at 1400 C was improved with increasing SiC content , and thermal shock resistance was improved with increasing SiC content .

  14. 在实验室工作基础上于工业氮化炉内于1450℃左右氮化烧成,生产出强度高,热震稳定性和抗渣性能良好的SiAlON结合刚玉质透气砖。

    The SiAlON-bonded corundum purging plugs with high strength , good thermal shock resistance and slag resistance were produced fired at 1450 ℃ in industrial nitriding furnace based on the laboratory experiment .

  15. 该材料耐压强度大于50MPa,导热系数小于0.6W/(m·K),热震稳定性>150次。

    The material 's crushing strength > 50MPa , coefficient of heat conductivity < 0 . 6W / ( m. K ), resistance to thermal shock > 150 cycles .

  16. 研究了水玻璃、磷酸二氢铝、硫酸铝及磷酸二氢铝+硫酸铝复合结合剂对Al2O3-SiO2系浇注料强度和热震稳定性的影响。

    Effects of water glass , aluminum dihydrogen phosphate , aluminum sulfate and compound binder containing aluminum sulfate and aluminum dihydrogen phosphate on strength and thermal shock resistance of Al 2O 3-SiO 2 system castables were studied .

  17. 铝碳材料热震稳定性影响因素的分析

    Study on factors affecting thermal shock resistance of alumina carbon-based refractory

  18. 硅酸铝质喷补料热震稳定性研究

    Thermal Shock Resistance of Gunning Refractory Composed of Aluminium Silicate

  19. 粒度组成对莫来石窑具热震稳定性的影响

    Effect of Grain Composition on Thermal Shock Resistance of Mullite Kiln Furniture

  20. 窑具材料显微结构与热震稳定性相关性研究

    The study on Microstructure and thermal shock resistance of kiln furniture materials

  21. 氧化锆对刚玉-尖晶石浇注料热震稳定性的影响

    Influence of zirconia on thermal shock stability of corundum-spinel castables

  22. 改善耐火制品热震稳定性的方法

    The way to improve thermal shock resistance of refractory product

  23. 锆质定径水口热震稳定性的研究

    Study on Thermal Shock Resistance of Zirconia Metering Nozzle

  24. 试样在1100℃时具有良好的抗氧化、抗碱和热震稳定性。

    Samples has good anti-oxidation , anti-alkali and thermal shock resistance at 1100 ℃ .

  25. 含锆刚玉-尖晶石浇注料热震稳定性提高的机理为微裂纹增韧。

    The improved mechanism is micro crack toughening .

  26. 主要特性:耐压强度高、热震稳定性好、抗侵蚀、气孔率底。

    Function : The product has fine structure , can resist heat-shocking , chemical eroding etc.

  27. 探讨了硅微粉的加入对浇注料的热震稳定性、抗渣侵蚀性和热膨胀性的影响。

    The influences of microsilica on thermal shock resistance , slag resistance and thermal expansion of castables are investigated .

  28. 该炉衬材料热震稳定性好、抗渗透性强、施工周期短和使用寿命长。

    This crucible refractory has the advantage of good hot-shock resistance , high slag penetration resistance , short building period and long life span .

  29. 与直接结合镁铬砖相比,镁铁铝尖晶石砖在热震稳定性方面更优于直接结合镁铬砖,而在粘挂窑皮性能方面与其相近。

    Compared with the direct-bonded magnesia-chromite brick , the magnesia-hercynite brick has the superior thermal shock resistance and the similar adhesive strength ( coatability ) .

  30. 本系列材料采用符合结合剂,热震稳定性号,使用寿命长及整体密封性好等优点。

    The materials in this series are provided with excellent features such as suitable bonding agent , good thermal shock stability , long service life and well-sealed integration etc.