中冷器

  • 网络intercooler;Inter Cooler;AFTERCOOLER
中冷器中冷器
  1. 对中冷器传热系数K值进行误差分析表明,K值误差是换热量测量误差的3倍以上。

    Error analysis of intercooler ′ s heat transmission coefficient K indicates that the error of the value of K is more than 3 times as big as the error of measured value of the heat exchange capacity .

  2. 中冷器内流动与传热的试验研究

    Experimental study on heat transfer and fluid flow in an intercooler

  3. 通过延迟喷油正时延迟3.6度,NOX的比排放大幅降低。通过采用空空中冷器、选用改进型2增压器和第一次延迟喷油正时,NTC-330达到了GB17691-2001第一阶段限值的要求。

    The NOx reduced significant by delaying injection timing for 3 . 6 degrees .

  4. 改性EPDM中冷器出气胶管的开发及应用

    Development and Application of EPDM Rubber Tubes for Intercooler

  5. 介绍了汽车柴油发动机中冷器出气胶管的特点,比较了硅橡胶与三元乙丙橡胶(EPDM)的性能特征。

    The characteristics of diesel engine intercooler rubber tubes are introduced , and the performances of silicone rubber and EPDM rubber are compared in the paper .

  6. 试验结果显示:(1)通过重新设计制造的空气-空气中冷器替代原水套中冷器,额定点进气温度从106℃降低到55℃,额定点NOX的浓度大幅下降。

    The result of experiment shows that : ( 1 ) The intake manifold temperature drops from 160 ℃ to 55 ℃ by change water jacket aftercooler into a new designed air to air aftercooler and have a great NOx reduction .

  7. 热管在增压内燃机中冷器上的应用研究

    Study of Heat Pipe Application on Intercooler for Internal Combustion Engines

  8. 机车柴油机行驶风中冷器初探

    A preliminary study of running wind intercoolers for locomotive diesel engines

  9. 介绍了冷轧翅片管式中冷器的特点,导出了该种形式的中冷器冷却元件几何参数的计算公式;

    The characteristics of cold rectifying fin tubular intercooler are introduced .

  10. 东风4型机车中冷器热应力分析

    The Analysis of Thermo-stress in After-cooler of Diesel Engine on DF_4 Locomotive

  11. 车用增压柴油机中冷器模型及其性能预测

    Inter-Cooler Model and Prediction of Performance on a Vehicle Turbocharging Diesel Engine

  12. 内燃机车中冷器热负荷计算与设计

    Thermal load calculation and design of intercooler for diesel locomotive

  13. 空压机中冷器化学清洗试验研究及现场应用

    The Research and Application of Chemical Cleaning of the Air Compressor Middle-Cooling

  14. 本文主要研究冷凝器、中冷器、水箱散热器和风扇这些冷却部件位置的改变对发动机舱内流场空气流动和散热的影响。

    Which affect on air flow and cooling of the engine compartment .

  15. 内燃机车中冷器模糊优化设计探讨

    Discussion about Fuzzy Optimized Design of Intermediate Cooler in Locomotive

  16. 冷轧翅片管式中冷器的设计计算方法

    Cold Rectifying Fin Tubular Intercooler and Its Design Calculation Method

  17. 用模糊理论诊断中冷器故障的研究

    Fault Diagnostics for Charger - Air Cooler Using Fuzzy Theory

  18. 一种多孔介质蒸发冷却中冷器性能的初步研究

    A Preliminary Study of the Performance of a Porous-medium Evaporative Cooling-based Intercooler

  19. 顺排圆管涡产生器式中冷器研究

    Study of in-line finned tube banks inter-cooler with vortex generators

  20. 圆管百叶窗翅片中冷器结构参数的确定

    Determination of Structure Parameters of Louvered Fin-and-round-tube inter Cooler

  21. 其中,关键部件为中冷器。

    Among them , the key partis the intercooler .

  22. 中冷器位置对柴油发电机冷却组性能的影响

    Wind Tunnel Investigation on the Performance of Cooling Package of Diesel Engine Generator

  23. 建立中冷器模型,使得中冷器进出口的温度降和压力降符合试验结果;

    The inter-cooler model was calibrated for the desired temperature and pressure drop .

  24. 车用柴油机相继增压系统研究及中冷器流场计算

    The Study of Vehicle Diesel Sequential Supercharging System and Intercooler Flow Field Computation

  25. 新型中冷器板芯设计及试验研究

    Design and test research of new type intercooler core

  26. 我国船用涡轮增压器和中冷器的标准系列

    The Standard Series of Marine Turbo-charger and Intermediate Cooler

  27. 中冷器引起的离心式空气压缩机的喘振及防范措施

    Surge resulting from intercoolers of centrifugal air compressor and the methods of antisurge

  28. 从中冷器断开压力管。

    Disconnect pressure pipe from the charge air cooler .

  29. 对中冷器、散热器清洗方法的探讨

    Study of the cleaning method for intercooler and radiator

  30. 对抽换中冷器散热单节焊接工艺的探讨

    The Shopping List A study of welding process after replacement of intercooler cooling section