摩擦磨损试验机

MHK-500环块摩擦磨损试验机智能测控系统的研制

Study of Intelligent Testing System of MHK-500 Ring-Block Tribometer

利用现代测控技术和计算机技术研制了MHK-500环块摩擦磨损试验机的智能化测控系统。

An intelligent testing system of MHK-500 ring-block tribometer was developed by using the modern measure and control technology and computer-aided technology .

EMC在摩擦磨损试验机研制中的影响及对策

Influence of Electromagnetic Compatibility in Developing Frictional Wear Test Machine and Its Countermeasures

用端面摩擦磨损试验机考察了锡青铜镶嵌聚四氟乙烯（PTFE）自润滑轴承材料的摩擦学特性。

The tribological properties of PTFE-embedded tin bronze bearing material were studied using a pin-on-disk friction and wear tester .

在销盘摩擦磨损试验机上建立了一套摩擦噪声测试系统，研究了具有相变特征的TRIP钢在单向连续滑动的摩擦试验过程中，摩擦噪声的强度的变化规律。

In the process of friction testing in which the TRIP steel with transformation characteristics is continuously sliding in unilateralism , variety rule of the friction noise intensity was studied .

通过金相显微镜和X射线衍射仪观察了化合物层的显微组织和微观结构及在MPX200型盘销式摩擦磨损试验机上进行纯滑动干磨损试验。

Then the microstructure of the compound layer is observed through the microscope and the X rays diffractometer . In addition the pure sliding wear test has been done with the MPX-200 wear test machine .

并利用XRD、TEM、TG-DSC及摩擦磨损试验机对改性树脂及其摩擦材料的试件进行性能表征和测试。

The resin modified and friction material specimens are characterized and tested by means of XRD , TEM , TG-DSC and friction and Tear Testing Machine .

用栓盘式端面摩擦磨损试验机在干摩擦条件下考察了环境温度对热压成型的聚间苯二甲酰间苯二胺（PMIA）摩擦磨损性能的影响。

The effect of ambient temperature on the friction and wear properties of poly ( m phenylene isophalamide )( PMIA ) prepared by hot pressing method were studied using a pin on disc wear tester .

首先利用球盘式摩擦磨损试验机研究了纳米硬质合金的摩擦系数、耐磨损性，然后利用SEM观察了磨损表面，研究了磨损机理。

The coefficient of friction and hard-wearing of nano cemented carbide are studied by ball-on-disk friction and wear tester , the worn surface is observed by SEM , and the wear mechanism is studied .

采用玄武三号栓-盘式摩擦磨损试验机研究了纳米TiO2和硅烷偶联剂改性玻璃纤维织物的摩擦磨损性能；

The friction and wear properties of the glass cloths reinforced with nano-TiO_2 and modified with silicon coupling agent ( KH560 ) were studied using a pin-on-disk friction and wear tester .

在此基础上，设计了基于虚拟仪器技术的端面摩擦磨损试验机CAT系统，并对系统进行了分析。

Based on the above technology , we designed the end-face friction and wear testing machine CAT system based on the virtual instrumentation technology , at the same time , carried on analysis of the system .

MM-200摩擦磨损试验机摩擦系数动态测试系统的实现

The implementation of dynamic testing friction coefficient system for MM-200 friction and wear tester

WFM型往复式摩擦磨损试验机的研制

Development of WFM reciprocating friction wear testing machine

HQ-1型摩擦磨损试验机的研制与应用

Development and application of model HQ-1 friction and wear testing machine

在球盘式摩擦磨损试验机上，采用阶梯加载方式，测定了润滑条件下钢／钢滑动摩擦副的临界载荷－速度（P－V）图，分析了P－V图各区域的摩擦磨损特性。

This paper investigated the P-V digram for steel / steel rubbing pair under lubrication on a " ball-on-disc " testing machine , using the stepwise loading method , and analysed the behavior or friction and wear in various regions of the diagram .

利用RFT－Ⅲ往复摩擦磨损试验机测试了Cu粉（200目）及纳米Cu粉填充聚甲醛所形成复合材料的摩擦磨损性能，并利用电镜、XPS和AES研究了其磨损机理。

Cu ( nanometer ) / POM , Cu ( 125 μ m ) / POM composites were tested by RFT ⅲ reciprocating friction tester and their friction and wear behaviors were studied .

采用往复式摩擦磨损试验机研究了10%（质量分数计）Al2O3增强四方氧化锆多晶Y-TZP陶瓷材料（简称10ADZ）在不同载荷下的磨损行为与机制。

Wear properties of alumina strengthen yttria stabilized tetragonal zirconia polycrystal ( Y-TZP ) ceramic ( ADZ ) under different loads were investigated using a block-on-block tribometer .

利用HQ-1摩擦磨损试验机：考察了纳米TiO2的自修复性能，并探讨了其自修复机理。

HQ-1 friction and wear test machine was used to research self-repairing characteristics of surface modified nano-TiO_2 as additive in base oil .

采用MM-200型摩擦磨损试验机考察了石墨对Al2O3/Cu基金属陶瓷复合材料摩擦磨损性能和硬度的影响；

The influence of graphite on the hardness and tribological behavior of the Al_2O_3-Cu cermet composite was investigated .

用四球摩擦磨损试验机评价了油溶性γFe2O3纳米颗粒作为润滑油添加剂对液体石蜡减摩抗磨作用的影响。

The effect of the synthetic product as additive in liquid paraffin on its friction-reducing and antiwear ability was evaluated on a four-ball machine .

采用油酸对纳米TiO2粒子进行了表面修饰，利用HQ-1摩擦磨损试验机和四球试验机考察了纳米TiO2的摩擦学性能，并探讨了其减摩抗磨机理。

Oleic acid was used to modify the surface of Nano-TiO 2 . HQ-1 test machine and four-ball machine were used to study the tribological performance of Nano-TiO 2 and its anti-wear mechanism .

HDM-10端面摩擦磨损试验机数字化智能测控技术研究

Study of Digital Intelligent Testing Control Technology of HDM-10 End-Face Friction Wear Experiment Machine

利用荷重传感器、PCI数据采集卡将MM200型摩擦磨损试验机改造成具有动态测试功能。

This paper explain how to transform MM200 friction and wear tester to dynamical testing friction coefficient testing machine by loading sensor ? PCI data acquisition card .

MMU-5型流体润滑摩擦磨损试验机设计及其性能的研究

Study on the Design and Performances of MMU - 5 Wear Tester

MM1∶1000摩擦磨损试验机的改进

Improvement of MM1 ∶ 1000 Friction-wear Tester

MPX-2000型盘销式摩擦磨损试验机的改装

A Refit of the MPX 2000 Pin on Disk Tester for Friction and Wear Testing

对MPX－2000盘销式摩擦磨损试验机进行改装，增添了加热及相应的控制和冷却系统。

A MPX 2000 pin on disk tester used for friction and wear testing was refitted with adding heating and cooling systems .

采用原位修饰方法制备了双烷基二硫代磷酸盐（DDP）表面修饰的ZrO2纳米颗粒，利用四球摩擦磨损试验机考察了ZrO2/DDP复合纳米微粒用于添加剂的摩擦学行为。

ZrO_2 nanoparticles surface-modified by dialkyldithiophosphate ( DDP ) was synthesized . A four-ball machine was used to investigate the tribological behavior of ZrO_2 / DDP complex nanoparticles as an additive in liquid paraffin .

合成了基础油中分散性良好的油酸（OA）修饰PbS纳米粒子，并用四球摩擦磨损试验机考察了其作为润滑油添加剂的摩擦学行为。

Oleic acid ( OA ) capped PbS nanoparticles with good dispersion capacity in lubricating oils were prepared using surface modification methods . Four-ball wear test was used to evaluate the tribological behaviour of the capped nanoparticles as oil additives .

采用MQ-800型四球摩擦磨损试验机考察了纳米铜均匀分散的绿色润滑油的摩擦学性能。

The friction behavior of the green lubricant was researched by MQ-800 four ball experimental machine of friction and wearing .