木浆纤维

  • 网络Wood pulp fiber;TENCEL;lyocell;Modal;FORMOTEX
木浆纤维木浆纤维
  1. CP/MAS~(13)cNMR技术对木浆纤维微观结构的研究

    CP / MAS ~ ( 13 ) C NMR Spectroscopy Study of the Ultrastructure of Wood Pulp Fiber

  2. 在喷气织机上开发木浆纤维纯纺织物的实践

    Development of pure wool pulp fiber fabric on air-jet loom

  3. 木浆纤维加入量对造纸法再造烟叶物理指标的影响

    Effects of amount of ligneous fiber on physical properties of paper-making tobacco sheet

  4. 芬宝浆与北木浆纤维特性对滤嘴棒纸掉毛掉粉的影响

    Influence of fibre character on cigarette filter paper

  5. 木浆纤维的流失率随水针能量增加而增大。

    The loss of wood pulp fiber increases with the increase of water energy .

  6. 利用半干法制备木浆纤维增强水泥板是可行的。

    The semi-dry process can be used for the production of the fiber reinforced cement board .

  7. 木浆纤维与水泥具有较好的相适性,可直接用于纤维水泥板的制备。

    Wood-pulp fiber and cement has better compatibility . It can be directly used for production of cement fiberboard .

  8. 处理后的涤纶纤维与木浆纤维混抄时有较好的分散性能和抄造性能,纸页的匀度指数、抗张强度、撕裂指数、耐破指数都有较大程度提高。

    As a result , its dispersion behavior and the ability of paper-forming mixing with wood fiber were improved .

  9. 考虑到湿巾日常使用中对强度的要求,木浆纤维含量应控制在75%以内。

    Considering the requirements of strength for daily use , wood pulp content must be 75 % or less in control .

  10. 本文研究合成胶乳在改性涤纶纤维&木浆纤维混合抄造过程中的增强作用。

    The strengthening function of synthetic latexes on the sheet of blended modified polyester fibers and wood fibers was studied in this paper .

  11. 采用原子力显微镜和低温氮吸附法研究了桉木浆纤维的孔隙结构,并运用分形理论对孔隙结构进行了分析。

    The pore structure of eucalyptus pulp fibers was investigated by means of atomic force microscopy ( AFM ) and low-temperature nitrogen adsorption .

  12. 本文用超声波对速生材木浆纤维为原料的纤维素纤维进行预处理以提高纤维素纤维的可及度和化学反应性能。

    Ultrasonic wave has been applied in the pretreatment of the fast-growing wood pulp cellulose fibers in order to increase the accessibility and reactivity of cellulose .

  13. 主要目的是确定不同的漂白方法对硫酸盐针叶木浆纤维表面特性的影响,包括老化前和老化后。

    The aim of this study was to determine the influence of different bleaching sequences on the fibre surface properties of softwood kraft pulp before and after ageing .

  14. 浆粕气流成网技术是以木浆纤维为主要原料,通过气流成网及不同固结方法生产非织遣布的一种新方法。

    Pulp air-lay technology is a new nonwoven production method , in which raw materials , mainly wood pulp , are formed into web by using air-laid process and then bonded via different methods .

  15. 但是在水刺加固过程中,木浆纤维极短易流失,进入水循环过滤系统,不仅对水过滤系统造成困难,而且使纤维浪费,成本增加。

    But in the process of hydro-entanglement , wood pulp fiber is extremely short so it is easy to lose , and enter the water filtration system . It not only creates difficulty for water filtration system , but also creates fiber waste , and increases cost .

  16. DN30杂交白杨&高强度阔叶木浆的纤维资源

    The DN 30 Hybrid Poplar-A Fiber Source for High Strength Hardwood Pulps

  17. 桉木浆细小纤维表面化学特性

    Study on the Surface Chemical Characteristics of the Fines of Eucalyptus Pulp

  18. 进口绝缘木浆的纤维分析

    Fiber Analysis on Imported Insulation Wood Pulps

  19. 纤维素纤维,以木浆等天然纤维为原料。

    Cellulose fibers to wood pulp and other natural fiber as raw materials .

  20. 玉米秸皮粘胶纤维浆粕仿生预处理工艺和蠕动发酵罐研究碳酸钙在天然木浆-聚酯纤维复合膜上的仿生合成

    Bionic Pretreatment Process of Viscose Fiber Pulps for Cornstalk s Skin and Peristaltic Fermentor Design ; Biomimetic Synthesis of Calcium Carbonate on Cellulose-polyester Fibrous Film

  21. 麦草化学浆含有杂细胞及细小纤维组分,这些组分在一定程度上和机械木浆的细小纤维组分相似,但麦草浆的主要性质的发展规律主要和化学木浆相似。

    Non-fiber elements and fines existing in chemical wheat straw pulps , though to a certain extent much similar to the fine fractions in mechanical wood pulp , behave more closely to those found in chemical wood pulps .

  22. 利用纤维质量分析仪研究针、阔叶木浆打浆后的纤维形态,观察打浆后的纤维粗度及测定手抄片的性能。

    Fiber shapes of refined chemical pulp from softwood and hardwood were studied by the Fiber Quality Analyzer ( FQA ) . Fiber coarseness of refined pulp and properties of handsheet were examined and tested .