Oxygen making machine

Feasibility Discussion of Using Molecular Sieve Oxygen Making Machine in the Hospital

医院采用分子筛制氧机的可行性探讨

Emergent Treatment of Two Failures of the Oxygen Making Machine

连续两起制氧机故障的应急处理

Application of Electronic Water Processor in the Circulating Cooling Water System of Oxygen Making Machine

制氧机循环冷却水系统电子水处理器的应用

Control of Lower Tower Pressure of Total Low Pressure Oxygen Making Machine and Energy Saving

全低压制氧机下塔压力的控制与节能闪速熔炼中制氧的节能

Application of DCS and PLC Technology in the Control System of 9 # Oxygen Making Machine

DCS与PLC技术在莱钢9~制氧机控制系统中的应用

Application of PSA Oxygen Making Machine in Electric Furnace Steelmaking

PSA制氧设备在电炉炼钢的应用

Analysis of Production Increasing of 5000m ~ 3 / h Oxygen Making Machine

5000m~3/h制氧机增产分析

Review of Commissioning of 10000 m ~ 3 / h Oxygen Making Machine

10000m~3/h制氧机投产综述

Start Process of " Liquid Return " and Operating Methods for All Low Pressure Large Oxygen Making Machine

全低压大型制氧机液体回灌启动流程及操作方法

Fluctuation of Low pH in the Open Circulation Water System of Oxygen Making Machine and the Solutions

制氧机敞开式循环水系统低pH值波动及处理

Noise Administering State of No.3 Oxygen Making Machine

临钢3~制氧机的噪声治理状况

Application of PLC in Expansion Machine of 10000m ~ 3 / h Oxygen Making Machine

10000m~3/h制氧机膨胀机应用PLC

Optimizing Operation of 12000m ~ 3 / h Oxygen Making Machine to Enhance Extraction Rate

优化12000m~3/h制氧机操作，提高提取率

Cleaning of Air Separation Tower of 6500m ~ 3 / h Oxygen Making Machine

6500m~3/h制氧机组空分塔的清洗

Characteristics and Improvement of KDO-6500 - ⅰ Type Low-Purity Oxygen Making Machine

KDO6500Ⅰ型低纯制氧机特点及改进

Characteristics of the Process and the Brief Introduction of Engineering Design of 35000 m ~ 3 / h Oxygen Making Machine Introduced

马钢引进35000m~3/h制氧机工艺流程特点及工程设计简介

Application of Honeywell TPS in No.5 Oxygen Making Machine

HONEYWELLTPS在本钢5~制氧机上的应用

Analysis of Water Intake Accident of the Cold Accumulator of 15000 m ~ 3 / h Oxygen Making Machine

15000m~3/h制氧机蓄冷器进水事故分析

Unit Heating Treatment of Plate Exchanger Blocked in 6000m ~ 3 / h Oxygen Making Machine

6000m~3/h制氧机板式换热器堵塞后的单体加热处理

Analysis of Problems Occurred in Commissioning of 12000m ~ 3 / h Oxygen Making Machine and Solutions

12000m~3/h制氧机调试中的问题分析及解决办法

The Operation Method for the Argon Refining Tower of 35000 m3 / h Oxygen Making Machine in High Nitrogen Content

35000m3/h制氧机精氩塔精氩含氮高时的操作方法

Based on analysis of problems in old oxygen making machine , necessary measures for local transformation are adopted and expected effect is achieved .

分析了老制氧机存在的问题，有针对性地采取了必要的局部改造措施，达到了预期目的。

Disposal of Leakage Fault of Main cooler for 10000 m ~ 3 / h Oxygen Making Machine and Emergent Measures for Production

武钢10000m~3/h制氧机主冷泄漏故障处理及应急保产方式

Causes of increased temperature difference and unusual operation of the main heat exchanger of 6 000 m 3 / h oxygen making machine are analyzed .

分析了6000m3/h制氧机主换热器温差扩大、工况异常的原因。

An introduction was made on characteristics , matching state and performance test results of the 10000 m3 / h oxygen making machine of Sanming Iron & Steel Co. Problems in the engineering construction and the solutions were also presented .

介绍了三明钢铁公司10000m3/h制氧机的特点、配套情况、性能考核结果以及在工程建设中遇到的一些问题及其解决方法。

Causes of two water intake accidents of the cold accumulator of 15 000 m 3 / h oxygen making machine made by the former Soviet Union are analyzed , and corresponding measures are used so as to avoid similar accidents .

对苏制15000m3/h制氧机连续两起蓄冷器进水事故的原因进行了分析，并采取相应措施，以防类似事故的重复发生。

The plate heat exchangers of 10000m3 / h oxygen making machine was damaged . After maintenance of it cold air releasing in the heat-end was serious and oxygen amount made decreased . The working state of the oxygen making machine deteriorated .

10000m3／h制氧机板式换热器损坏修复后，热端跑冷严重，氧气取出量不足，制氧机工况恶化，通过分析找出了原因是因某单元氧通道堵塞，并采取了处理措施。

This contribution presents the characteristics of the first set of KDO - 6500 - ⅰ type low-purity oxygen making machine made by HangZhou Oxygen Making Ma - chine Manufacturer . It analyzes its shortcomings in operation and proposes actual improving measures for system equipments and operation .

分析了杭氧制造的国内首套KDO&6500一Ⅰ型低纯制氧机的特点及运行过程中暴露的一些问题，并针对这些缺陷从系统设备和操作方面提出了具体的改进措施。

Comprehensive technology of noise control for oxygen - making machine

制氧机组噪声综合治理技术