首页 / 词典 / good

slenderness

美 [ˈslɛndərnəs]英 [ˈslɛndənəs]
  • 网络细长;纤细;长细比;细长度;名词
slendernessslenderness

noun

1
the property of an attractively thin person
Synonym: slightness slimness
2
relatively small dimension through an object as opposed to its length or width
the tenuity of a hair
the thinness of a rope
Synonym: thinness tenuity
3
the quality of being slight or inadequate
he knew the slenderness of my wallet
the slenderness of the chances that anything would be done
the slenderness of the evidence

数据来源:WordNet

  1. In the parametric analysis , the effects of the pile stiffness , pile slenderness and pile spacing on the equivalent stiffness and load distribution of pile group characteristics were investigated .

    在参数分析中,研究了桩身刚度、桩长细比和桩间距对群桩等效刚度以及群桩中各桩桩顶荷载分担特性的影响。

  2. A review of great slenderness ratio projectile elastic effect research

    大长细比弹箭弹性效应研究综述

  3. Comparative analysis of critical slenderness ratio of concrete filled steel tubular column

    钢管混凝土柱临界长细比的比较分析

  4. A calculation method for equivalent slenderness ratio by a graphical method is presented .

    给出了应用图表法的换算长细比计算方法。

  5. Design of Die Used for Bigger Slenderness Ratio Half Hollow Aluminium Profile

    具有较大舌比的半空心铝型材模具的设计

  6. The product purity increases with the bed slenderness ratio increasing .

    产品气的纯度随着吸附塔高径比的增大而增大。

  7. Great Slenderness Ratio Imitative Projectile Mode Analysis and Theories Calculation

    大长细比模拟弹模态分析与计算

  8. The approach of equivalent slenderness ratio is recommended for calculation purpose .

    计算方法宜采用换算长细比法。

  9. Study on Wind-induced Vibration Characteristics of Two Classes of Bridge Components with Large Slenderness Ratio

    两类大长细比桥梁构件的风振特性研究

  10. Economical Analysis on Slenderness Ratio of Aluminum Alloy Holding Pole

    铝合金抱杆长细比的经济性分析

  11. Based on model experiment and simulated experiment , the formula of equivalent slenderness ratio was established .

    在模型试验和仿真试验的基础上,提出了单边连接高强角钢等效长细比公式。

  12. Tests show that the strength of column decreases as its slenderness ratio increases .

    试验表明,这种柱子的承载能力随长细比的增大而显著下降。

  13. Experimental Investigation of Aft End Ignition for High Slenderness Ratio and Small Size Solid Motor

    大长细比小型固体发动机后点火试验研究

  14. Computation Method for the Slenderness Ratio and Calculated Length of Steel Latticed Shells

    钢网壳结构杆件计算长度及容许长细比的确定

  15. Bearing behavior of cast-in-place piles with similar slenderness ratios in deep soil layer

    深厚土层中长径比相近灌注桩承载性状

  16. And the effect of slenderness ratio of CNT on sensing property was studied .

    同时研究了长径比对材料敏感特性的影响。

  17. Research on Determining slenderness ratio of members of superhigh voltage transmission steel tubular towers

    特高压钢管输电塔构件长细比取值研究

  18. According to the slenderness ratio and the maximum windward area , four experiments are designed .

    按不同的长细比和不同的最大迎风面积设计了四个实验。

  19. Interactive buckling and plates ' slenderness of T section under axial compression

    轴压T形钢的相关屈曲及板件宽厚比

  20. Volumetric efficiency , slenderness , span over length ratio increase with the cone angle .

    体积率、细长比和展长比都随着基本流场圆锥角的增大而增大。

  21. We try to combine slenderness with strength .

    我们力图将苗条和力量完美结合。

  22. Fine Singular Points Cervical radiculopathy Uniaxial Compression Characteristic of Rock Specimen in Different Slenderness Ratio

    不同长细比岩柱单轴压缩特性试验研究

  23. Laws of bearing capacity and mechanical property affected by slenderness ratio and load eccentricity ratio were investigated .

    根据试验结果,总结了长细比、偏心率对试件承载力和力学性能的影响规律。

  24. It is shown that the nonlinear frequency ratio increases with the vibration amplitude and the slenderness ratio .

    计算结果表明非线性频率与线性频率之比随振动幅值的增大和梁长细比的增大而增大;

  25. But the slenderness of that base also means that insolvency threatens when bad times arrive .

    但这个基数的微薄程度也意味着,在市况不好的时候,资不抵债的危险就会出现。

  26. The experimental results show that the bearing capacity of the specimens decreases with the increase of the slenderness ratio .

    结果表明,加固构件的承载力随着长细比的增大而降低。

  27. Bounds slenderness ratio among axial compression short columns , middle long columns and long columns were determined .

    确定了钢管煤矸石混凝土轴心受压短柱与中长柱以及中长柱与长柱的界限长细比;

  28. The parameters used in the analyses include rise to span ratio , slenderness ratio , steel ratio and load conditions .

    分析的参数有矢跨比、长细比、含钢率以及加载方式。

  29. Limit slenderness ratios of steel beam-columns under cyclic load

    循环荷载下钢压弯构件的长细比限值

  30. Oil Perforating Cartridge with Small Slenderness Ratio

    小长径比石油射孔弹