供热机组

  • 网络heat supply unit
供热机组供热机组
  1. 200MW空冷供热机组末级叶片的优化设计

    The Optimum Design of Final Blade of 200 MW Air Cooling and Heat Supply Unit

  2. 二次再热超临界供热机组热力系统经济性定量分析方法

    Economic-quantitative Analysis Method Used for the Thermodynamic System of a Supercritical Heat Supply Unit with a Double Reheat

  3. 真空供热机组PLC控制系统

    PLC Control System of Vacuum Heater

  4. 解耦技术在200MW供热机组DEH中的应用

    Application of Uncoupling Technology to DEH of 200 MW Heat-supply Unit

  5. 300MW供热机组主厂房布置方案论证

    Demonstration on Installation Draft for Main Building of 300 MW Heat-supply Unit

  6. 太原一电厂300MW供热机组性能在线监测系统的开发。

    On-line performance monitoring system for300MW heat-supply unit in Taiyuan NO.

  7. 东方1000MW超超临界等大型供热机组DEH控制及保护设计

    DEH Control and Protection Design of Ultra-supercritical Large Steam Turbine for Cogeneration

  8. 300MW纯凝机组改造为供热机组的控制研究及应用

    Research and application of control strategies for 300 MW co-generation power unit reconstructed from condensing unit

  9. 200MW供热机组热力系统优化设计

    Optimization on Thermodynamic System Layout for 200 MW Heating Power Unit

  10. 国产200MW供热机组供热调峰能力的试验研究

    Testing of Regulating Capacity of Heat Supply for 200 MW Heating Unit

  11. 200MW凝汽机组改为采暖供热机组方案的设计

    Design on Program of Transforming 200 MW Condensing Units into Heating Units

  12. 200MW供热机组循环水泵双速节能改造

    Two-speed Energy-saving Alteration for Circulating Water Pump of 200 MW Thermal Power Unit

  13. 供热机组热力系统热经济性分析的EEDM方程

    EEDM Equation of the Thermo-economic Analysis for Cogeneration Unit

  14. 分析了国产200MW供热机组运行实际状况。

    The real situation in operation of domestic 200 MW cogeneration sets is analyzed .

  15. 200MW抽汽供热机组甩负荷试验及分析

    Load Rejection Test and Analysis of 200 MW Heat - Supply Unit with Extraction Steam

  16. 并用该方法对我国三北地区20个城市,装设200MW供热机组热化系数最优值的分布及合理变化范围进行了计算。

    In addition , it is employed in the calculation of the optimal distribution and the range of the distribution coefficient of 200 MW generating - heating sets which are located in twenty cites of North China .

  17. 太原第二热电厂扩建2×200MW空冷供热机组基建施工期间,使用HP-2A新型除锈剂,在电厂空冷循环水大型管内壁除锈、防腐,得到良好效果。

    During extending the air-cooling assembly unit of 2 × 200 MW in Taiyuan Sec-ond Electric Power Plant , a good result was acquired in applying the new type of HP-2A rust-removal agent to rust removal and anticorrosion of the inwall in the large-size piping with air-cooling circulation water .

  18. 供热机组多重循环及其耦合系数研究

    Study of Multiple Cycle and Its Coupling Factor of Heat-supply Unit

  19. 供热机组热经济性分析通用软件的开发

    Programming a generalized software for economic analysis of heat supplied plants

  20. 详细介绍供热机组的能损分析理论和方法,以及性能监测和运行优化管理系统的具体结构和主要功能。

    The method of energy-loss analysis has been presented in detail .

  21. 供热机组低真空供热改造安全性校核研究

    Research on safe assessment low vacuum thermal dilation of heating unit

  22. 供热机组-海水淡化联产系统的经济性分析

    Economic Analysis of a Heat-Power Cogeneration Set Integrated with a Desalination Plant

  23. 旋膜除氧器在供热机组大量补水工况中的应用

    Application of revolving water film deaerator under a large water makeup condition

  24. 大型供热机组性能在线监测系统的研究与开发

    Research on the On-Line Performance Monitoring System in Heat-Supply Units

  25. 供热机组智能控制器的设计

    The design of intelligent controller for concentrate offering heat set

  26. N600MW纯凝汽机组改造为供热机组的可行性研究

    The discussion of the alteration from condensing power plant to cogeneration unit

  27. 供热机组真空变化对经济指标影响的诊断方法

    Economic Diagnosis Method of Exhaust Pressure Change for Heating Unit

  28. 大容量抽汽供热机组分缸压力的合理确定

    Rational Choice of Pressure Split Between Cylinders or Large Extraction Steam Turbines

  29. 供热机组调峰运行中的最小出力分析

    Analysis on Minimal Load of Thermal Power Unit during Peaking Adjustment Operation

  30. 供热机组间热电负荷最佳分配的研究

    Research on Heat and Power Load Optimizing Distribution for Heat Supply Unit