变形地

变形地变形地
  1. 飞轮由电机和三角皮带驱动,飞轮积聚地能量仅在曲柄转动地小部分范围,即材料变形地时候才释放出来。

    The flywheel which is driven by an electric motor and " V " belts stores energy that is used only during a small portion of the crank revolution namely during deformation of the material .

  2. 结果表明,心室或瓣膜等引起的扰动在一定条件下有可能是一种中性扰动,它可以沿着动脉管无变形地传播到动脉远端。

    This result manifests the fact that under certain condition , the disturbance caused by ventricle or aortic varves can be a neutral one and can be transmitted through arteries until it reaches to the farther end .

  3. Lanzarote火山与地球动力学实验场的地壳变形、地热流动态监测研究

    Dynamic observation and monitoring of crustal deformation and geothermal flow in the volcano and geodynamics Laboratory of Lanzarote

  4. 土体永久变形中地震动有效荷载研究

    Study on effective loads of ground motion for permanent deformation of soils

  5. 与此相反,压实紧密的路基,强度提高,透水性降低,变形显著地减小,稳定性得到明显改善,可以避免大规模的破坏。

    At the same time , for the embankment with high degree of compaction the strength is obviously higher , the water penetration lower , deformation reduced and the stability improved apparently .

  6. 对比不同墙厚在相同土质、相同开挖深度时,基坑开挖引起的基坑变形、地连墙位移、应力等,得到了墙厚对基坑变形的影响规律。

    Comparing the different thickness of wall in the same soil , same excavation depth , excavation deformation . Diaphragm wall displacement , stress , etc. obtained the thickness of the wall deformation influence law .

  7. 船舶在波浪中航行时所产生的总体弯曲变形不可避免地会影响沿船体纵向布置的卧式压缩机气缸运行余隙。

    For a marine horizontal compressor arranged along the ship longitudinal direction , the longitudinal bending deformation generated during the ship navigating on the waves will inevitably affect the cylinder running clearance of the horizontal compressor .

  8. 由于内装式电机的损耗发热和轴承的摩擦发热,使得高速电主轴的发热量很大,由此产生的热变形大大地降低了高速机床的加工精度。

    The heat generated due to loss in the built-in motor and friction in the bearings is significant during high speed machining and the thermal deformations of the spindle decrease the accuracy of high-speed machine tool greatly .

  9. 南悉尼盆地二叠系的软沉积物变形包括地裂缝、震褶层、液化脉、沙火山、负荷构造、火焰构造、枕状构造、球状构造、枕状层、滑塌构造、角砾岩化等。

    The soft-sediment deformation of Permian in the southern Sydney Basin consist of seismo-cracks , seismo-folds , fluidized veins , sandy volcano , load casts , flame structures , pillow structures , ball structures , pillow beds , slump structures and brecciation .

  10. 在旋轮的进给运动和坯料的旋转运动共同作用下,使局部的塑性变形逐步地扩展到坯料的全部表面,直到达到要求形状,完成零件的旋压加工。

    Under the combined effect of the feed movement of the roller and the rotary movement of the blank , the local plastic deformation gradually extends to the entire surface of billet until the desired shape is achieved , when the spinning process is completed .

  11. 将提出的模型同biot固结理论相耦合,能够计算软土的长期变形,定量地分析软土变形过程中结构的逐步破损过程以及初始扰动对于土体变形的影响。

    It is introduced into FEM program of Biot consolidation theory , indicating that the long-term deformation of soft soil can be calculated . The initial disturbance and the gradual damage of soft soil can be quantitatively analyzed in soil deformation .

  12. 对岩石圈现今活动性、位场异常图像处理与岩石圈变形踪迹、地体基底构造与边界断裂划分等进行了综合研究。

    The lithospheric activities , deformation traces , basement structures and border faults of the terrains were studied .

  13. 全场连续的变形数据清晰地反映了雁列断层结构的变形破坏过程的各种细节。

    The whole failure process of the echelon fault structure is revealed by evolution of the deformation field .

  14. 该分析方法可求出抽油杆作涡动时的变形,有效地了解抽油杆的动力特性。

    The deformation and the dynamic characteristics of whirling rod strings can be obtained efficiently by using this method .

  15. 对于底部弱层非规则隔震体系,上部结构弱层的侧移和楼板变形能有效地降低。

    Sidesway and floor deformation of feebleness-storey on superstructure can efficient reduce in bottom feebleness - storey irregular isolated-structure .

  16. 分析了楔横轧偏心变形,系统地研究了产生偏心变形的条件。

    The eccentric deformation of a blank in the process of cross wedge rolling was analysed in this paper .

  17. 大断面隧道施工引起的上覆地铁隧道结构变形分析强地震动作用下地基土-地铁隧道结构的动力接触效应

    Structural deformation of overlying subway tunnels induced by tunnelling Analysis on Dynamic Contact Effect of Soil-Tunnel System Subjected to Strong Earthquake

  18. 在玻璃磨料磨损工况下,深度塑性变形可以有效地提高70钢的耐磨性,应变量达到3.58时70钢的耐磨性提高6倍以上。

    By using the abrasive of glass , wear resistance of the steel can be improved greatly with the increase of strain .

  19. 在氧化磨损阶段,由于加工硬化提高了合金的硬度和强度,对合金施以一定程度的冷变形可有效地提高其耐磨性。

    At the oxidation wear stage , certain degree of cold deformation can improve the wear resistance of the alloy because of work hardening .

  20. 在冲击或地震地面运动激励下,此种容器的变形,严格地说应遵循薄壳结构动力学规律。

    The deformation of these tanks should be obeyed strictly the rule of thin shell dynamic theory under the excitation of impact or earthquake ground motion .

  21. 由于界面层材料性质失配,不可避免地存在残余应力、应力集中和初始缺陷,在大变形时不可避免地在界面层处首先发生损伤和开裂。

    Because interface layer material characters mismatch , residual stress , stress concentration and initial defects exist inevitably and damage and crack occur initially with large deformation .

  22. 活动断裂带吸收的缩短量是有限的,在构造变形中更多地起着调节两盘运动的作用。

    The shortening deformation absorbed by active fault zones is limited , mainly playing a role of adjusting the movement of two walls of fault in the process of tectonic deformation .

  23. 在输入杆前端的中心位置粘贴一块可塑性好的黄铜圆片,通过它的塑性变形来有效地增加入射应力脉冲的上升时间,从而保证试样中变形均匀和应力平衡。

    We stick a copper disk at the front face of the incident bar , the deformation of the copper damps the incident waveform to ensure dynamic stress equilibrium and homogeneous deformation in the specimen .

  24. 文学语言的陌生化主要是打破语言规范,并对日常语言进行扭曲、变形,更好地表现作家创作过程中的非理性成分的情感活动,从而增强文学作品的审美价值。

    The unfamiliarization of literacy language aims to break language norms and distort daily language , thus better reflect unreasonable emotional activities in the process of writing , and increase aesthetic value of literacy works .

  25. 安装扬矿管升沉补偿系统的目的就是当采矿船随波浪升沉时,使扬矿管尽可能地保持静止不动,使得扬矿管的交变轴向应力和轴向变形尽可能地小。

    The aim of the installation of the lifting mining pipeline heave compensation system is to maintain the quiescence of the mining ship when the lifting mining pipeline heave with the wave and minimize the changing axis stress and distortion possibly .

  26. 本文采用的转换B3样条有限杆元法考虑了杆壁中面上的剪切变形,能有效地反映剪力滞后效应。

    The proposed method can reflect shear lag effect by considering the shear deformation of the median surface of thin-walled members .

  27. 通过室内蠕变-降解对比试验,研究了城市固体废弃物(MSW)的长期变形过程,详细地分析了MSW应变、沉降速率以及孔隙比随时间的变化规律。

    Based on the experimental results , characteristics of strain changing , void ratio changing , settlement rate changing against time , and the relationship between stress and strain of MSW were studied .

  28. 通过引入高阶变形梯度,合理地修正了传统Cauchy-Born准则在描述纳米管变形几何关系时所存在的缺陷。

    In the present model , by including the second order deformation gradient tensor in the kinematic description , the limitation of the standard Cauchy-Born rule for the modeling of nanoscale crystalline films can be alleviated with less computational efforts .

  29. 粉末轧制变形区可简单地化分为粉末供料区和压实区。

    The deformation area in powder rolling can be simply divided into powder feed and compacting area .

  30. 考虑裂缝处局部剪应力引起的剪切滑移变形更能恰当地模拟二维开裂混凝土构件的反应性能。

    Simulation of local shear-slip deformation at cracks can improve the accuracy of response of 2-D cracked reinforced concrete .