和晶

和晶和晶
  1. 铝酸钠溶液温度、αk和晶种添加量升高,这种作用降低;

    The effect is decreased as the temperature , a k and seed amount increased .

  2. 基于DSP和晶闸管投切的低压快速动态无功补偿滤波装置

    An dynamic Var Compensation Filter Based on DSP and Thyristor in Low Voltage Power System

  3. 结果表明温度和晶种以及溶液pH值是影响铁矾沉淀的重要因素。

    The temperature , pH and crystal seeds were found to be critical for Fe precipitation as jarosite .

  4. 纳米/纳米型和晶间型ZTM/Al2O3复相陶瓷抗热震性能的研究

    Study of resistance to thermal shock of inter-type and nano / nano-type ztm / al_2o_3 composite ceramic

  5. TiAl金属间化合物的定向凝固和晶向控制

    Directional solidification and lamellar orientation control of TiAl intermetallics

  6. 扩散火焰法控制TiO2纳米晶粒径和晶型的研究

    Control of Size and Crystal Form of TiO_2 Nanocrystalline Synthesized by Co-flow Diffusion Flames

  7. 研究了煅烧温度对TiO2粒子晶粒尺寸和晶相组成的影响。

    The effect of calcining temperature on the particle size and crystalline phase composition of TiO2 powders has been studied .

  8. 研究发现,适量Si的掺杂可以在优化TiO2纤维的表面织构,增强热稳定性和晶型稳定性的同时显著提高其光催化活性。

    It was found that the proper addition of Si could improve the surface texture and enhance the thermal stability and crystal stability .

  9. 近藤化合物Ce2CuxNi(1-x)Ge6的磁性和晶场模拟

    Magnetism and Crystalline Electric Field Simulation of Kondo Compound Ce_2Cu_xNi_ ( 1-x ) Ge_6

  10. 超细ZrO2催化剂的织构和晶相结构对合成甲醇、异丁醇的影响

    Relations between ZrO 2 crystal structure and its catalytic activity to methanol and isobutanol

  11. SPS制备牙科可加工长石瓷粉体粒度和晶相含量对断裂韧性影响的研究

    Effect of Particle Size and Crystallin Phase Content on Fracture Toughness of Feldspathic Porcelain Prepared by SPS

  12. 认为ITO玻璃基片表面活性位和晶核的形成是均一致密CdS纳米膜形成的关键。

    Active sites on the surface of ITO are critical to the formation of crystal nucleus and uniform compact CdS nano-film .

  13. 用XRD、SEM及TEM等测试手段对产物的粒度和晶型进行分析;

    The TG was used to analyze the processor , the XRD , SEM and TEM were used to characterize the size of crystal type of products .

  14. 高压下Na5Eu(WO4)4的光谱和晶场参数

    High pressure spectra and crystal parameters of na_5 eu ( wo_4 ) _4 microcrystal

  15. 同时,此方法也克服了传统横向外延生长技术(LEO)工艺复杂和晶向倾斜高的缺点。

    The shortcomings of procedure complexity and high crystallographic tilt in conventional lateral epitaxial overgrowth are overcome by using the new method .

  16. PVF和CaHPO4对Nylon6的热行为和晶型的影响

    The Effect of Amorphous PVF and CaHPO_4 Additive on the Thermal Behaviour and Crystalline Conformation of Nylon 6

  17. 并且,过冷度(TEN-TEU)越大,则产生石墨畸变和晶间碳化物的程度也越严重。

    And the greater undercooling ( TEN-TEU ) is measured , the more seriously degeneration of normal spheroidal graphite and intercellular carbides are obtained .

  18. 型HMX微细颗粒。考察了压力、温度、溶液初始浓度及溶液膨胀速率对GAS重结晶过程、晶粒大小和晶型的影响以及晶体的增长。

    Effects of pressure , temperature , initial feed concentration of HMX solute , expansion speed of solution and growth of crystal on the GAS process have been studied .

  19. 用XPS、XRD、TEM、TED和SEM研究了热处理温度和压力对薄膜结晶质量和晶型的影响。

    The influence of temperature and pressure on the crystallinity and polytype of the film was investigated by XPS , XRD , TEM , TED and SEM analysis .

  20. 用扫描电镜(SEM)、X射线衍射(XRD)等方法对膜的形貌和晶相组成进行了表征,以苯酚为模型污染物考察了膜的活性。

    The film characterization was carried out by scanning electron microscope ( SEM ) and X-ray diffraction ( XRD ) analysis . The photocatalytic activity was evaluated using phenol as model pollutant .

  21. 利用硫酸钡和晶种低KH配料生产水泥的研究

    Research on the Production of Cement with BaSO_4 and Seed Crystal by Low KH Batch Mixing

  22. 研究结果表明:在快速凝固条件下,Ni-8%Pb亚偏晶合金的凝固组织由(Ni)枝晶和晶间(Pb)相组成。

    It shows that : Under rapid solidification conditions , the microstructure of Ni-8 % Pb hypomonotectic alloy consists of ( Ni ) dendrite and ( Pb ) in the grain boundary .

  23. TiN和晶内铁素体有很低的晶格错合度,所以MnS表面析出的TiN相通过降低表面能促进晶内铁素体的形核。

    TiN has low misfit ratio with IGF , so TiN precipitated on the MnS surface also promote the formation of IGF because of decreasing interfacial energies .

  24. 第二章介绍了几类常用的SVC设备,主要包括固定电容器(FC)、晶闸管控制电抗器(TCR)和晶闸管投切电容器(TSC)三种设备。

    Chapter 2 explains the structures and the operating principle of three common kinds of SVC devices , including FC , TCR and TSC .

  25. 通过SEM、激光粒度分析和XRD等技术,研究了PAM和微波处理对材料的形貌、粒度和晶相结构的影响。

    The effects of PAM and microwave treatment on the morphology , particle size and crystal structure of the material were characterized by SEM , laser particle size analysis and XRD techniques .

  26. 键稀疏,晶场稀疏和晶场,偶极与偶极相互作用和交换相互作用的比率(α)之间的相互影响使BEG模型展示出一些新颖的现象。

    Some new phenomena are presented due to the interplay between bond and crystal field dilution , crystal field and the ratio of biquadratic and exchange interaction (α) .

  27. 首先,采用共沉法和溶胶-凝胶法制得磁载光催化剂TiO2/Al2O3/γ-Fe2O3,并对该催化剂分别用TEM和XRD进行了形貌和晶相表征。

    Finally , TiO_2 / Al_2O_3 / γ - Fe_2O_3 photocatalyst was successfully prepared by sol-gel method . The surface morphology and crystal structure of the catalyst were characterized by TEM and XRD respectively .

  28. 天合光能有限公司(TrinaSolarLtd.ADS,TSL)和晶科能源(JinkoSolar)都在规模最大的太阳能面板企业之列。后者在经过多个季度的亏损之后刚刚恢复赢利。

    Trina Solar and Jinko Solar , who just started returning to profitability after many quarters of losses , are among the biggest panel players .

  29. 结果表明:光强、甲基橙的初始浓度、TiO2的浓度和晶型、溶液pH以及掺杂离子等对降解效率都有较大的影响。

    The results indicate that the initial concentration of methyl orange , catalyst loading , pH , the light intensity , and transition metal doping on TiO2 , have obvious effects on the degradation rate .

  30. 氧化锌含量较高的样品分两种情况:低温焙烧的样品由ZnxAl2O(3+x)(x<1)和晶相ZnO构成;

    There are two situations for the samples with more ZnO : The samples calcined at lower temperature consist of Zn_xAl_2O_ ( 3 + x ) and crystalline ZnO .