时效处理

固溶/时效处理对奥氏体耐热钢组织与性能的影响高超音速湍流底部热的实验研究

Effect of Solid Solution / Aging Treatment on Microstructure and Properties of Austenitic Base Heat Resistant Steel

CuAgCr合金经时效处理后，显微硬度和电导率都有很大的回升。

The microhardness and conductivity of the dilute solute Cu-Ag-Cr alloy is notably enhanced due to aging treatment .

时效处理对埃林瓦合金γf和Q值影响

Aging Effect on γ _f and Q Values of Elinvar Alloy

化学镀Ni-P合金P含量及时效处理工艺对镀层组织及硬度的影响

Effect of P Content and Heat Treatment on Microstructure and Hardness of Electroless Ni-P Coating

时效处理对SiCp/AZ61镁基复合材料显微组织和力学性能的影响

Effect of Ageing Treatment on SiC_p / AZ61 Composite Microstructure and Mechanical Properties

热挤压和时效处理对SiCw/LD2复合材料拉伸性能的影响

Influence of Hot-extrusion and Ageing Treatment on Properties of SiCw / LD2 Composites

时效处理对Nb微合金化钢筋屈服的影响

Effect of Aging on Nb Micro-alloyed Reinforced Bar 's Yield

时效处理对铸态Mn-Cu一Al一Ni合金的影响

The Effect of Aging on a Mn - Cu - Al - Ni Alloy

分析了快速凝固与常规固溶处理后，Cu－0.8Cr合金导电性的差异及时效处理对合金导电性的影响。

The differences of electrical conductivity in rapidly solidified and conventional solid solution treated Cu Cr alloy have been analysed in this article .

时效处理可显著提高Ni（Cu）PPTFE复合涂层的硬度和磨损性能，聚四氯乙烯起到良好的减摩效果。

With aged treatment , they will be improved obviously in hardness and wear resistance and enjoy good result of PTFE solid lubrication .

喷射成形及时效处理对Cr（12）MoV钢组织及性能的影响

Effect of Spray Forming and Aging Treatment on Cr_ ( 12 ) MoV Steel

最佳时效处理工艺为480℃，4h。

The best ageing treatment is 480 ℃ , 4h .

应采用低C、N含量和高Al的化学成分，采用低温出炉、高温卷取的热轧温度制度及更优的过时效处理。

Chemical composition of low C and N and high Al , HR temperature system for low-temperature tapping and high-temperature coiling , and a better ageing treatment should be adopted .

双级时效处理可提高合金的延伸率、电导率和抗应力腐蚀（SCC）性能。

The two-stage aging can improve elongation , conductivity and the resistance of stress corrosion cracking .

高温退火和时效处理对Ni（47）Ti（44）Nb9合金显微组织和马氏体相变的影响

Effects of Annealing at High Temperature and Aging on Microstructure and Martensitic Transformation of Ni_ ( 47 ) Ti_ ( 44 ) Nb_9 Alloy

合金均经T6时效处理，达到峰值时效状态。

Both of the alloys were T6 tempered to peak status .

Cu-Cr合金时效处理工艺及其强化机制的定量探讨

Study on the Aging Treatment of Cu-Cr and Quantitative Relation of Strengthening Mechanism

在时效处理试样中，马氏体相和R相的阻尼性能高于母相（B2）；

In the aged specimen , the internal friction of martensite phase or R phase are higher than that of parent phase ( B2 ) .

时效处理对快速凝固Cu-Cr合金显微组织和显微硬度的影响

Effect of Ageing Treatment on the Microstructures and Microhardnesses of Rapidly Solidified Cu-Cr Alloy

含Sc超高强Al-Zn-Mg-Cu-Zr合金的回归再时效处理制度

Optimum retrogression and reaging heat treatment of super-high strength Al-Zn-Mg-Cu-Zr alloy containing Sc

加氢和时效处理可促进固溶组织中B2相的转变，尤其是促进B2→O相变。

Additionally , hydrogenation and aging treatment can promote B2 phase transformation , especially B2 → O transformation .

加工工艺及时效处理对Cu-Cr-Zr合金性能的影响

Effects of Process Technology and Aging Treatment on Properties of Cu-Cr-Zr Alloy

喷射沉积超高强Al-Zn-Mg-Cu合金的回归再时效处理

Retrogression reaging treatment of spray deposited Al-Zn-Mg-Cu alloys

研究表明：在合金中加入Zr、V元素、提高合金纯度、进行退火及固溶时效处理均能够提高5083铝合金的超塑性能。

We realized the super plasticity can be improved by improving the purity of alloy , adding element of Zr , V. , and performing solution ageing treatment .

利用碳黑催化法制备了新金刚石粉末，并通过粉末X射线衍射（XRD）对不同时效处理后的新金刚石样品进行表征。

After the synthesis of new-diamond by using a method of catalyzed carbon black , the crystal structure of the new-diamond after various aging-treatment time was investigated by X-ray diffraction ( XRD ) .

合金元素及时效处理对Sn-Zn无铅钎料组织和钎焊界面的影响

Effect of Alloying Elements and Aging on Microstructure and Solder Interface of Sn-Zn Lead-free Solders

通过固溶时效处理，研究冷变形、时效温度等因素对微合金元素V，Ti，Nb的碳氮化物沉淀析出行为和组织演变过程的影响。

This paper studies the effect of such factors as cold-deformation and aging on carbonitride precipitation and structural evolution in microalloyed steels bearing V , Ti and Nb by the solution ageing treatment .

时效处理对Sn-Bi系无铅焊料的影响研究

Effect of aging on Sn-Bi lead-free solder

动力学数据证明GNPs的时效处理过程是一个CHIT诱导的自催化生长过程；

Kinetic results suggested that the GNPs growth during aging should be a CHIT-mediated autocatalytic process .

应用取向分布函数（ODF）研究了3104铝合金经不同温度固溶及时效处理后的冷轧织构组态。

The cold rolling textures of3104 aluminium alloys after solution and aging were studied by means of orientation distribution functions ( ODFs ) .