氩气
- 网络argon;argon gas;a r;Ar argon
-
他把这种气体叫作氩气。
He termed the gas argon .
-
氩气MAP技术在樱桃保鲜包装中的应用
Application of Argon MAP Technology in Packaging of Fresh Cherries
-
氩气分压与膜厚对溅射Al膜微结构及应力的影响
Effect of Ar pressure and film thickness on the microstructure and stress properties of Al films
-
氩气精炼对铝硅合金Ti、B、Sr残留量的影响
Effects of Remain Content of Ti , B , Sr on Al-Si Alloys by Ar Gas Refinement
-
氩气雾化制备Al(82)Ni(10)Y8非晶态结构粉末
Fabrication of Al_ ( 82 ) Ni_ ( 10 ) Y_8 Amorphous Structured Powders by Argon Gas Atomization
-
原料组成和氩气流量对铁尾矿合成SiC粉末的影响
Effects of Raw Materials Composition and Ar Flux on SiC Powder Synthesized from Iron Ore Tailings
-
氩气ICP中电荷迁移激发机理的研究
A Study on the Mechanism of Charge Transfer in Argon ICP
-
小功率空气-氩气混合气冷却ICP中电子密度的测定
Determination of Electron Density in Ar air Mixed Coolant Gas ICP
-
选取了NiAl系3种成分的包晶合金,采用氩气保护电弧熔炼的方法得到试样。
Three kinds of normal solidification Ni-Al series binary peritectic alloys were prepared by electric arc smelting with Ar protection .
-
Al2O3与BN在氩气中合成AlN粉末
Synthesis of AlN powder by reaction of Al 2O 3 and BN in Agron
-
空气-氩气冷却ICP-AES测定环烷酸镍中的镍、铁、镁和钙
Determination of Elements in Nickel Naphthenate by Air-Argon ICP-AES
-
LF炉氩气串级模糊控制
Cascade fuzzy control of argon stirring in LF
-
溅射气体中氩气含量对Y1Ba2Cu3O(7-δ)薄膜结构和Tc的影响
Influence of Ar Ratio in Sputtering Gas on Structure and T_c of Y_1Ba_2Cu_3O_ ( 7 - δ) Thin Film
-
AOD的吹氧速度对氩气耗量的影响
The influence of oxygen blowing speed in AOD on argon consumption
-
Mo-N共渗时氮气和氩气的流量比N2/Ar是影响改性层的重要工艺参数。
The flux ratio N2 / Ar is an important parameter for fabricating Mo-N modification layer .
-
氩气中灼烧ZnS和卤化钾混合物制备ZnS基蓝光粉的研究
Preparation of ZnS Based Blue Phosphors by Sintering ZnS With Kalium Halide as Additive in Argon Gas
-
用直流等离子喷射法,以甲烷、氢和氩气的混合气体为原料,在钼基体上合成了较高质量的CVD金刚石薄膜。
CVD diamond films made from methane-hydrogen-argon gas mixture have been synthesized on molybdenum substrate by direct current plasma jet apparatus .
-
应用透射电镜观察不同氦气和氩气流量比对Ti膜微观结构及氦泡形貌和分布的影响,并研究退火温度对氦泡聚集和长大行为的影响。
The influence of He-Ar flux ratio on the Ti film microstructure was studied , and the influence of temperature on the evolution of helium bubbles was analyzed .
-
氩气在直流PCVD镀硬膜中的作用
Effect of Argon on Hard Coatings in PCVD
-
1400℃氩气中处理1h后,抗拉强度是原始强度的95%以上;
The initial tensile strength of the fibers remains 95 % after heat treatment at 1 400 ℃ for 1 h in argon .
-
以高纯ZnO为靶材,氩气为溅射气体,利用射频磁控溅射技术在石英衬底上生长出纤锌矿结构的富锌ZnO薄膜。
A Zn-rich ZnO film with wurtzite structure is deposited on quartz substrate by radio-frequency magnetron sputtering technique using high pure ZnO as target and Ar as sputtering gas .
-
氩气虽然可以提高Ti(CN)膜的沉积速率,但降低了膜-基的结合牢度。
Argon can increase the depositing rate of Ti ( CN ) coatings , but it decreases the adhesion strength of Ti ( CN ) coatings .
-
在基底不加热的条件下,用对向靶反应溅射法在氩气和氧气的混合气氛中制备了多晶Fe3O4薄膜。
The polycrystalline Fe_3O_4 film was prepared in O2 and Ar mixed atmosphere by facing-target reactive sputtering without substrate heating during the deposition .
-
文中用微波等离子体炬(MPT)为激发光源,氩气为等离子体工作气体,用气动雾化进样,研究了微波消解微波等离子体炬原子发射光谱法(MPTAES)测定葡萄酒中的铅元素的方法。
Microwave plasma torch atomic emission spectrometry ( MPT-AES ) was used to determine lead in wine after digestion .
-
采用氩-氮混合气体代替纯氩气作为焊接的离子气,SiC颗粒烧损和团聚可在一定程度上得到抑制。
However , the decrease as well as the aggregation of SiC particles can be somewhat restricted as argon-nitrogen mixture rather than pure argon has been employed as plasma gas .
-
介绍了在60t国产LF-VD精炼炉精炼高压气瓶钢的工艺改进,改进内容包括LF脱氧节奏、LF造渣、VD氩气控制、模铸铸温和铸速的改进等。
This paper introduces the craft improvement of high-pressure bottle steel in 60t domestically produced LF-VD refining furnace .
-
DHP型氩气纯度分析仪的特点及改进
Characteristics of model DHP argon analyzers and some improvements
-
使用4传感器阵列结合主成分分析(PCA)的方法,实现了对纯氩气、SF6、氮气、二氧化碳的定性检测。
Utilizing Principle Component Analysis ( PCA ) method and a four-sensor array , we could detect pure Ar , SF6 , N2 , and CO2 .
-
考察了氩气气压和射频功率对Marcus型激发源溅射玻璃样品的溅射率的影响。
The effects of gas pressure and RF power on sputtering rates of Marcus-type source is investigated when glass samples are sputtered .
-
APC通过氩气离子流(氩气等离子区)传导单极电外科高频电流到生物组织对其产生凝血作用。
APC conducts monopolar electro surgical high frequency current to tissue via an ionized argon gas stream ( argon plasma ) to coagulate the tissue .