溶质浓度

  • 网络solute concentration
溶质浓度溶质浓度
  1. 溶质浓度对Al-Cu合金中PLC效应的影响

    Influence of solute concentration on PLC effect in Al-Cu alloys

  2. 生长面上一个亚微观层厚的具有高溶质浓度(k<1时)的熔体B;

    Melt B which is in front of the growing interface with the thickness of submicroscopic layer of crystallization and high solute concentration ( when k < 1 );

  3. 在数字中,增强因子R是阴谋反对脱附率N和各种溶质浓度在液相中。

    In the figure , the enhancement factor R is plotted against the desorption rate N for various solute concentrations in the liquid phase .

  4. 溶质浓度周期分布的LiNbO3晶体中Bragg衍射

    Bragg Diffraction in LiNbO_3 Crystal with Periodic Distribution of Solute Concentration

  5. 由此建立了数学模型,讨论了表面活性剂浓度、溶质浓度、pH值等因素对萃取率的影响。

    On the basis of experiments , a model was proposed , which predicated extraction yield as a function of surfactant concentration , solute concentration and pH of system .

  6. 生长条纹是TiC枝晶在自由生长过程中由于周围温度和溶质浓度梯度的波动而产生的。

    It is considered that the growth strip is due to the fluctuation of temperature and solute concentration gradient during the free growth process of TiC dendrite .

  7. 温度及溶质浓度对Mullite短纤维增强的Al-Cu复合材料及其基体合金时效行为的影响

    Effects of Temperature and Solute Content on the Ageing Behaviour of the Al-Cu Composite Reinforced by Short Mullite Fibers and Its Base Alloy

  8. 通过活化漂珠对废水中COD的静态吸附试验,研究分析了活化温度、漂珠用量、吸附时间、废水中有机溶质浓度及PH值等影响活性漂珠吸附性能的各种主要因素;

    Through the static adsorption experiment of COD in wastewater on activated Fly Ash Floating Beads , the main influential factors that affected adsorption property ( activated temperature ? amounts of Fly Ash Floating Beads > adsorption time ^ PH and the concentration of solute ) were analyzed ;

  9. 枝晶凝固过程中的溶质浓度分布模拟

    Modelling of the redistribution of solute concentration in dendrite solidification process

  10. 水平铸型溶质浓度分布的数学分析

    Mathematical Analysis for Solute Density Distribution in Level Mold Casting

  11. 对流效应和溶质浓度对KNbO3晶体界面形貌稳定性的影响

    Effect of Convection and Solute Concentration on the Morphological Instability of KNbO_3 Crystal

  12. 超临界流体萃取过程中溶质浓度的非稳态现象

    Unsteady State of Solute Concentration in Supercritical Extraction Process

  13. 各体系的混合热均随温度和溶质浓度的增加而增大。

    The enthalpy of mixing increased with the increase of temperature and solute concentration .

  14. 不透水层上均质土壤中溶质浓度分布的解析解

    An Analytical Solution for Solutes Concentration Distribution Model in Impermeable Stratum in Homogeneous Soil

  15. 而当溶质浓度超过临界浓度值时,溶液电导率的增加缓慢。

    The conductivity increases slowly when the concentration is larger than the moderate value .

  16. 最后得到孔隙压力,溶质浓度和应力在井孔周围的分布。

    The distribution of pore pressure , solute concentration and stresses around borehole are obtained .

  17. 溶质浓度分布对焊接熔池凝固结晶的影响

    The effect of distribution of solute concentration on the solidification and crystallization in the weld pool

  18. 本文就对土壤水动力系统中两个重要的研究对象-土壤含水量和溶质浓度进行了讨论分析。

    In this paper , water flow and solute density in soil hydrodynamics have been studied .

  19. 糖苷键[合],苷键[合]氢键受体与供体数目比与溶质浓度的关系

    The Relation between the Ratio of Hydrogen Bonding Acceptor Number to Donor Number and Solute Concentration

  20. 电子束表面熔凝处理钛镀镍合金的组织与溶质浓度分布

    Microstructure and Solute Concentration Distribution of Solidified Layer in Electron Beam Surface Solidification Treating Ni-Plated Ti Alloy

  21. 结果显示,在凝固过程中界面速度和界面溶质浓度都存在着很大的波动。

    And the fluctuation of the interface velocity and solute concentration during the solidification is also predicted .

  22. 目的:考察中药提取液浓缩过程中沸点变化与溶剂组成和溶质浓度的关系。

    AIM : To observe the change of boiling point in the concentration of medical herb 's extract liquor .

  23. 通过计算获得了界面温度、速度、溶质浓度及非平衡分配系数随界面位置的变化。

    The interface temperature , velocity , solute concentration and non-equilibrium partition coefficient varying with interface location are calculated .

  24. 首次选取乙醇作为喹啉萃取的超临界溶剂,研究了温度、压力、溶质浓度对粗喹啉产物的超临界萃取过程的影响。

    The influence of temperature , pressure , density of quinoline , cosolvents was studied in the supercritical extraction proceeding .

  25. 被动扩散在被动扩散过程中,跨细胞转运依赖于溶质浓度梯度。

    Passive diffusion : In this process , transport across a cell membrane depends on the concentration gradient of the solute .

  26. 总的来说,位错的运动速度随着溶质浓度和体积膨胀的增加而减小,钉扎力却随着二者的增加而增大。

    On the whole , the velocity decrease with increasing solute concentration and dilation , while pinning force increases with their increasing .

  27. 萃取速率与相界面积、两相中的溶质浓度差和滴内流体力学状态有关。

    Extraction velocity had a relation with interface areas , concentration gradient of solute and the status of fluid kinetics in the globelet .

  28. 计算结果表明,钢液的紊流流动显著改变了薄板坯内温度场形状及溶质浓度的分布。

    Calculated results show that the turbulent fluid flow intensively alters the shapes of temperature field and the solute distribution in thin slab .

  29. 通过选取不同的参数,我们研究了弥散、吸附对溶质浓度的影响。

    The effects of dispersion and adsorption on the concentration of the solute are investigated by choosing different parameters in this two - dimensional model .

  30. 气液相际间传质过程中,由溶质浓度梯度产生的表面张力梯度可以导致相界面湍动现象。

    In the gas liquid mass transfer processes , solute concentration gradients may produce surface tension gradients , resulting in interfacial turbulence at the interface .