炉身

lú shēn
  • stack;furnace shaft;furnace stack;furnace shell
炉身炉身
炉身[lú shēn]
  1. 高炉模块式炉身温度场的研究

    Research into Temperature Field in Modular Stack of Blast Furnace

  2. 重点分析炉身破损的原因。

    Emphasis is laid on analyzing the causes of the stack damage .

  3. 梅钢150t转炉炉身压缩空气射流冷却装置的研制

    Development of compressed airjet cooling set in meishan 's 150 t converter vessel

  4. 炉身下部采用低的热负荷来保护。低的热负荷是通过PaulWurth的无料钟布料设备来控制。

    Lower shaft of the furnace was protected with lower thermal heat load by burden distribution control with Paul Wurth bell-less top charging facility .

  5. 该模型描述了炉缸和炉身内温度场的分布和变化、炉顶溢出SiO浓度的变化和工艺参数、设备参数对Si回收率的影响。

    The model describes the variety of the temperature in the furnace hearth and shaft and the variety of SiO-outflow from the furnace top and the effect of technical parameters and device parameters on the Si recovery .

  6. 结果表明,在炉身中下部和炉腹、炉腰部位炉衬内表面到冷却板前端的100mm范围内是炉衬耐材易损区和渣皮形成区;

    The results show that the vulnerable zone of lining refractory and formation zone of slag skull are in a 100 mm range on lining 's inner surface from the middle / lower part of furnace stack and bosh to the front-end of cooling plate .

  7. 高炉炉身煤气自动取样及成分分析系统在攀钢1号高炉上的应用

    Automatic gas sampling and analysing system of Panzhihua blast furnace No.1

  8. 模块式炉身冷却控制的研究

    Study on cooling control of blast furnace with a block stack

  9. 鞍钢7号高炉炉身破损原因剖析

    Investigation of shaft with the damage condition at AISC No. 7 BF

  10. 包里斯炉能定量描述炉身生产情况,是模拟高炉生产的理想设备。

    Bolis furnace is an ideal apparatus for simulation of BF operation .

  11. 用于大中型高炉炉体冷却壁与炉壳之间的压入灌浆,常用于炉身下部。

    Used for injection between cooling walls and furnace shell .

  12. 广钢4~高炉进入晚期,炉身冷却壁破损,炉皮变形严重。

    The cooling wall of the furnace stack of GISE No.

  13. 620m~3高炉炉身冷却系统的改进

    Improvement of the shaft cooling system of 620m  ̄ 3 blast furnace

  14. 高炉炉身水冷模块浇注料的研制与应用

    Development and application of castable for water-cooled die block of blast furnace stack

  15. 高炉炉身煤气取样机结构分析与探讨

    The structural analysis and study on the stack gas sampler of blast furnace

  16. 高炉炉身喷吹转炉煤气的可行性探讨

    Feasibility research of ejecting converter-gas on blast furnace stack

  17. 从炉身喷吹预热气体时氧气高炉内冶炼过程的数学模型

    Mathematical Model of Oxygen Blast Furnace with Preheating Gas Injection into Upper Shaft

  18. 高炉炉身煤气流运动的研究

    Investigation of gas - flow in the furnace shaft

  19. 试论无内衬的高炉炉身结构

    Discussion on structure of blast furnace shaft without lining

  20. 转炉炉身应力的变化规律

    Change rule of converter shaft section shell stress

  21. 首钢高炉炉身上部损坏因素及对炉况的影响

    Analysis of damage factors of upper shaft of BF and its influence on operation

  22. 烧结矿在高炉炉身上部会发生低温还原粉化现象。

    The phenomenon of sinter degradation takes place in the upper shaft of blast furnaces .

  23. 镁碳砖是一种极普通的耐火砖,主要用于钢厂钢包的炉身、炉底。

    The captioned bricks are very common bricks for the body and bottoms of ladles .

  24. 延长高炉炉身寿命的实践

    Practice to prolong blast furnace stack life

  25. 高炉炉身下部及炉腰采用软水闭路冷却系统生产实践

    Practice of close cycled soft water cooling system for lower shaft and breast of blast furnace

  26. 不锈钢炉身配前后高效透视玻璃,4个吊篮可烤12至16只鸡。

    All stainless steel body with front and back visual glasses , 4 baskets for12-16 chickens .

  27. 高炉炉身下部内衬用耐火材料的研究及较为合理的评价方法和应用

    More reasonable study and test method of refractory used in lining of BF and its application

  28. 鞍钢7号高炉炉腰和炉身下部冷却管破损研究

    Study on cooling water pipe damage at low part of shaft and belly for No.7 BF at Angang

  29. 邯钢4高炉炉身上部及炉喉喷补造衬实践

    Practice of gunning lining making in the upper part and throat of4 # blast furnace of Han steel

  30. 炉身内衬由粘土砖、高铝砖到碳化硅砖或铝炭砖;

    In stack lining , from clay brick , high alumina brick to silicon carbide brick or alumina carbon brick ;