磁钢

cí gāng
  • magnet steel;magnetic steel;steel magnet
磁钢磁钢
磁钢[cí gāng]
  1. 钕铁硼磁钢在壳芯盒中的应用

    Application of the Nd-Fe-B Magnet Steel in Shell Core-Box

  2. 铸造铝镍钴磁钢的冶金质量分析

    Metallurgical Quality Analysis of Casting Al-Ni-Co Magnet steel

  3. 本文研制了单组份环氧胶粘剂SE8用作粘结磁钢的粘结剂。

    One-component Epoxy Adhesive SE-8 which is used as the binder of bonded magnetic steel has been developed .

  4. Nd-Fe-B电机磁钢材料的研究

    Research on Motor Magnetic Steel Material of Nd-Fe-B

  5. 该系统采用微波通过同轴开口电介质空腔产生表面波,由NdFeB永磁磁钢形成高强磁场,通过共振磁场区域内的电子回旋共振效应产生大面积、均匀、高密度等离子体。

    This system generates surface wave by means of the transmission of microwave in the open coaxial dielectric chamber and high magnitude magnetic field by Nd Fe B permanent magnets .

  6. 基于SVPWM永磁同步电机磁场定向控制算法的仿真永磁同步电动机磁钢的多目标微粒群算法优化

    Simulation of PMSM Field-Oriented Control Based on SVPWM Multi-objective particle swarm optimization of alnico in permanent magnet synchronous motor

  7. Fe-Mn基奥氏体无磁钢在节能电力金具上的应用研究

    The Research of Fe-Mn Based Austenitic Nonmagnetic Steels Applied to Energy Saving Electrical Fittings

  8. 此钢采用析出硬化机理,由于V的碳化物在奥氏体基体中弥散地析出,可以得到高的硬度、高的强度,所以是一种高锰-钒系高强度的无磁钢。

    It has high strength and hardness owing to the precipitation of fine vanadium carbides in austenite matrix , so it is a non-magnetic high strength steel of high manganese-vanadium series .

  9. 基于HALBACH阵列的永磁同步盘式无铁心电机磁钢设计

    The Design of Disk Type Coreless PM Synchronous Motor Based on Halbach

  10. 极间隔断Halbach型磁钢的永磁同步电机多目标优化设计

    Multi-Objective Optimization of Permanent Magnet Synchronous Motor With Partition Between Poles Halbach Magnet

  11. 采用盘形磁钢作为引导点,HALL器件构成的阵列位置偏差传感器组成走行偏差检测系统,进行了仿真计算和实验研究。

    The ferrite magnetic disks are used as guide points . Also , the simulating calculation and test study are made of the array position consisting of HALL units and the measuring system for detecting walking error making up of sensors .

  12. 该电机的定子上内嵌高性能永久磁钢,电机的转矩/体积比、效率均较相同功率等级的传统SRM要高。

    It has high perfomance PM inside the stator , which leads to the higher torque / volume ratio and higher efficiency as compared to the traditional SRM with the same output .

  13. 探讨了气隙δ恒定情况下欲保持气隙磁密Bδ不变时极对数p与磁钢厚度hm之间的关系,研究了气隙δ、漏磁通?

    First , under constant air gaps , the relationship between pole number and magnet thickness was presented when air gap flux density is kept constant , also the relationship between pole pairs and thickness of non-magnetism bush was given when leakage flux is kept constant .

  14. Al-TRIP钢、无磁钢、电工钢等高铝钢中Al含量一般超过0.5%,在浇铸过程中活泼元素Al易与保护渣中的SiO2发生反应。

    The high aluminium steels , such as alumina-containing TRIP steels , non-magnetic steel , electrical steel , and so on , generally contain more than 0.5 % Al , whose chemical property is so lively that can react easily with SiO2 in mould fluxes during casting .

  15. 从对无铁心绕组及Halbach阵列永磁磁钢自身性能特点的分析出发,分析了无铁心Halbach阵列对永磁同步电机控制性能的影响,并与传统永磁同步电机进行了对比分析。

    Through analyzing characteristics and performance of coreless Halbach disk type motor the study has gotten its effect to motor control . Then it has been compared with tradition PMSM .

  16. 本文主要报道快淬Nd-Fe-B粘结磁体在36BY(02)型永磁式步进电机中作为24极转子磁钢的应用研究,分析磁体性能与工作点设计及电机性能参数关系。

    Application of melt-spun Nd-Fe-B bonded magnet as a 24-pole rotor in the PM type of 36BY_ ( 02 ) stepping motor has been described and the relationship between magnetic properties and the design of its operating point as well as the performance of the motor have been analyzed .

  17. 提出一种带永久磁钢的新型开关磁阻电动机(PMSRM),对其基本结构、运行原理及电机性能等作了分析。

    Proposes a novel SRM with permanent magnet ( PMSRM ) ( and analyses of the basic structure , operation principle as well as the performance of such a kind of machine ) .

  18. 该技术只利用4只霍尔传感器A3144和4片磁钢,就可对16种转子进行识别,简单易行,安全可靠。

    Using only four pieces of magnetic chips and four Hall sensors ( A3144 ) to achieve the recognition of 16 kinds of rotors is provided . This technique is quite simple and reliable .

  19. 双气隙共磁钢两自由度电动机及其运动学分析

    An Double-air-gap Common-permanent-magnet Two-degree - of-Freedom Motor and its Kinematics Analysis

  20. 永磁同步电动机与磁钢性能的关系

    The Relationship between PM Synchronous Motor and Permanent Magnet Material function

  21. 铸造铝镍钴磁钢的定向凝固

    Directional Solidification of Cast Al - Ni - Co Magnetic Steel

  22. 铜离子选择电极测定磁钢中钴

    Determination of Cobalt in Magnetic Steel by Copper ion Selective Electrode

  23. 永磁同步电动机磁钢的多目标微粒群算法优化

    Multi-objective particle swarm optimization of alnico in permanent magnet synchronous motor

  24. 永磁电机磁钢设计中的曲线拟合

    Curvefitting Method in Designing Magnetic Steel of Permanent Magnet Electrical Machine

  25. 强磁钢轴向斥力的分析及简易计算

    An Approximate Analysis of Vertical Repulsive Force between Strong Magnetic Poles

  26. 用复合涂层改善防磁钢生产中的化学粘砂

    Improving on Chemical Scab of Antimagnetic-Steel Castings Using Composite Coating

  27. 高锰无磁钢的组织形态

    Microstructure and morphology of high manganese non - magnetic steel

  28. 空芯杯转子和高性能的稀土磁钢的直流电机。

    DC motors with moving coil rotor and high performance permanent magnets .

  29. 提高磁钢电火花线切割加工速度的实验研究

    The study of raising race of wire cut EDM of magnetic steel

  30. 稀土永磁磁钢可控电磁成型取向器的研制

    Development of Tropism Equipment with Thulium Permanent Magnetic Steel for Molding Electromagnetism