轴承润滑油

  • 网络bearing oil
轴承润滑油轴承润滑油
  1. 滑动轴承润滑油膜厚度测量方法分析

    Analysis on Measurement Approach for Lubricant Film Thickness of Sliding Bearing

  2. 静载滑动轴承润滑油膜迁移的研究

    The study of oil-film transference in statically loaded journal bearing

  3. 基于超声波的液体滑动轴承润滑油厚度的测定

    The Measurement of Shaft Locus of Liquid Sliding Bearing

  4. 汽车变速器二轴齿轮内孔滚针轴承润滑油回路研讨

    Research on Lubrication Circuit of Second-shaft Gear 's Inner-bore Needle Bearing in Vehicle Transmissions

  5. 此外,针对滑动轴承润滑油膜厚度监测,开发了基于光纤位移传感器的三点测量系统。

    Then , a three-point measurement system with fiber-optical sensor of displacement is designed to measure the thickness of the lubricant film .

  6. 研究发现,随着一轴承润滑油粘度的降低,转子系统亚临界角速度区的混沌区域和拟周期区域扩大了。

    The results show that within the subcritical speed range the chaotic and quasi-period range widen with the decrease of the lubricant viscosity in one of the two support bearings .

  7. 着重介绍大型推力轴承润滑油外加泵外循环冷却系统的工作原理、设计要点、主要元件选择和真机运行情况。

    The working Principle , the design key Points , the main Parts selection and the actual operating conditons of external circulation cooling system with a motor-pump located outside the lubrication oil reservoir are introduced emphatically in this paper .

  8. 用数值方法研究了在非线性油膜力作用下具有碰摩故障的转子系统的动力学特性,并研究了当改变其中一个支承轴承润滑油的粘度时,转子系统的动力学特性。

    Based on it , the dynamic characteristics of rotor-bearing systems with rub-impact faults are investigated emphatically considering the effects of nonlinear oil-film force by numerical method . And the dynamic characteristics of rotor-bearing systems are studied when the lubricant viscosity of only one support bearing is changed .

  9. 陀螺转子轴承用润滑油的成膜性能试验

    Film Forming Performance Test of Lubricating Oil for Gyrorotor Bearings

  10. 轴承与润滑油的接触面油气井井漏井壁与波纹管接触应力分析

    Bearing oil interface Analysis of contact stress between thief zone wellbore and bellow pipe

  11. 同时,初步确定了流体动压润滑硬盘轴承的润滑油和密封系统的解决方案。

    A solution to oil lubricating and seal of hydrodynamic fluid bearing for hard disk drive was given .

  12. 通过泵强力向发动机轴承注入润滑油润滑内燃机的方法。

    A method of lubricating internal combustion engines in which a pump forces oil into the engine bearings .

  13. 这很费事,为了减小摩擦,人们使用轴承和润滑油。

    You pay for that , and people try to reduce friction with bearings and with lubrication , oil .

  14. 还有一种方法,就是提高轴承中润滑油的高度,油的高度为100毫米。

    As an alternative , the oil100 mm high , to raise the level of the oil in the bearing .

  15. 我的意思是发电机轴承用润滑油应由船方供给,而不是由你们供给。

    What o mean is that the grease for the generator bearings should be from the ship 's store , not from yours .

  16. 此外,神经降压肽样免疫反应轴突终末可与血管和神经胶质胞体相邻或者直接接触。轴承与润滑油的接触面

    In addition , close approximations or direct contacts between NT-LI terminals and blood vessels or neuroglial cell bodies were observed . bearing oil interface

  17. 计算和试验结果表明,这种散热系统能够有效地降低轴承的润滑油温度。

    It has been found from an approximate calculation of the heat dissipation capacity and the test results that such a system is effective .

  18. 分析了压缩机转子、滑片等的受力和运动状态以及转子轴承和润滑油系统等动力学过程。

    And the dynamic processes of the compressor , such as the forced and motion state of the sliding vanes , rotor-bearing and lubricating oil system etc are also studied .

  19. 滑动轴承的紊流润滑油膜中的速度分布和压力分布

    The velocity and pressure distributions within the turbulent lubrication film of slide bearings

  20. 在轴承内的润滑油流动下面提供一些与弹性流体动力润滑有关的量。

    Oil flow in bearing Some of the quantities involved in elastohydrodynamic lubrication may be mentioned .

  21. 在轴承内的润滑油流动

    Oil flow in bearing

  22. 检测轴承,更换润滑油可以帮助我们决定添加润滑油的量以及什么时候停止添油。

    Detect bearings , replacement of lubricants can help us decide to add the amount of lubricant and when to stop Tim oil .

  23. 改进后使用结果表明:轴流压缩机运转正常,润滑油回油通畅,压缩机轴承座无润滑油泄漏。

    The final result by above measures shows the axial flow compressor is in working order , lubricating oil returns smoothly , and there is no lubricating oil leakage in bearing box of compressor .

  24. 低误差的陀螺仪旋转轴轴承所使用的润滑油往往用量不足,不能形成足够的EHD油膜。

    Low-error gyroscope spin axis bearings often contain insufficient lubricant quantity to form full EHD films .

  25. 圆锥滚子轴承结构参数与润滑油膜厚度的关系

    The Relation Between Thickness of Oil Film & Design Parameters of Tapered Roller Bearings

  26. 通过对轴承消耗功率和润滑油流量的分析,提出了计算轴承温升的计算流程并编写计算程序,分析表明轴承温升对曲轴轴承的正常运转影响很大。

    Through analyzing and calculating the bearing wasting power and oil flux , the calculation process of bearing temperature is put forward .

  27. 计算了油润滑导轴承上油压力和润滑油量,分析了可能发生的润滑故障;计算了清水润滑导轴承所需润滑水量和压力。

    Lubricating oil pressure and quantity of guide bearings were calculated , probable lubricating malfunctions were analyzed , lubricating water quantity and pressure of clean-water-lubricated guide bearings were calculated .

  28. 右面的图解显示了Timken公司为所有的轮轴轴承推荐的轮轴轴承润滑脂和润滑油的规格说明。

    The chart ( right ) shows wheel bearing grease and oil specifications recommended by The Timken Company for all wheel bearings .

  29. 介绍了轧辊轴承的润滑特点,分析了轴承润滑油膜参数与其寿命间的关系;

    The lubrication characteristics of bearing for roll is introduced . The relationship between oil film parameters of the bearing for roll and the lifetime of the bearing is analyzed .

  30. 轴承的摩擦使轴承和流通于轴承间的润滑油发热。

    The friction of the bearings causes them and the lubricating oil which is circulating through them to warm up .