适配卡

shì pèi kǎ
  • adapter
适配卡适配卡
  1. CAN总线PC智能适配卡的研制

    The Development of CAN Bus-PC Intelligent Adapter

  2. 适配卡采用并行通信方式,提高了数据传输速率。

    The adapter used parallel communication mode and had high data transmission rate .

  3. 基于PCIExpress的数据传输适配卡设计

    Design of Data Transmission Adapter Card Based on PCI Express

  4. 完成了PCI适配卡和DSP伺服控制器的设计。

    At the same time , PCI adapter and DSP servo controller are designed .

  5. 双端口RAM及其在CAN总线适配卡中的实现

    One Pair of Port RAM and its Realization in CAN Bus

  6. 一种ATM适配卡及其驱动软件的研究与设计

    Research and Design of ATM NIC and Its Driver

  7. 在流接口CAN适配卡的驱动设计方面,分析了WINDOWSCE。

    Secondly , in the design of stream interface CAN adapter driver , process of interrupt disposal in Windows CE .

  8. 适配卡采用PCIExpress接口,以光纤通道协议处理控制器作为其核心模块。

    The Fibre Channel protocol controller is the core module of the adapter with PCI Express interface .

  9. NET的主机系统设计,该部分实现分为嵌入式系统内核的定制、流接口的CAN适配卡驱动程序的设计、应用系统的设计。

    NET . The system is composed of customization of the kernel of embedded operating system , design of CAN adapter driver and application system .

  10. 一种MPEG-2实时编解码PCI适配卡的设计与实现

    Design and Implementation of a Real-time MPEG-2 CODEC Adapter Based on PCI Bus

  11. 然后研究了CAN总线实用接口技术,给出了一款PC/CAN智能通信适配卡的软硬件设计方法。

    Afterwards CAN interface technologies such as detailed design of hardware and software of intelligent PC / CAN interface cards are investigated .

  12. 针对车载工控机系列移动工程机械,设计了一种板载GPS模块的CAN通信接口适配卡。

    Aiming at construction vehicles with industrial PCs , this paper presents a kind of CAN communication interface adapter with onboard GPS module .

  13. 基于ISA总线CAN智能适配卡原理与设计

    Principle and Design of CAN Intelligent Interface Card based on ISA Bus

  14. PCI总线CAN通信适配卡设计及其与组态软件数据交换的方法研究

    Design of CAN Communication Adapter Card Based PCI and Research of Its Data Exchange Method with Configuration Software

  15. 接入ATM交换网的HDSL适配卡技术

    Technique of HDSL Adaptation Card of Accessing to ATM Exchange Network

  16. 基于PCI总线的LON适配卡驱动程序开发

    LON Adapter Driver Development Based on PCI Bus

  17. 基于PIC单片机的RS-232转CAN通信适配卡设计

    Design of RS-232-CAN Adapter Card Based on PIC MCU

  18. 基于并行口EPP模式的GPIB适配卡设计及应用

    Design and application of GPIB interface card based on EPP mode of LPT

  19. 在上位机适配卡的设计中,针对ISA总线和卡上单片机同时对双口RAM读写数据时的仲裁问题,提出了一种硬件判优方法。

    The hardware optimization method is suggested to arbitration problem on RAM data against ISA bus in regard of adapter design .

  20. 介绍了通过DDE通讯在组态软件环境下对CAN适配卡的驱动编程。

    Programming of driver for CAN adaptor in configuration soft by DDE communication was introduced .

  21. 用PCI9052设计PCI通讯适配卡的难点剖析

    The Analyze of designing PCI communication card with PCI 9052

  22. 可以克服网络并行计算系统NPC中网络适配卡总线传递速率的瓶颈;

    It could overcome the bottleneck of bus data transfer rate of network adapters in Networked Parallel Computing NPC ( or called NOW );

  23. 针对这一特点,本文利用EDA技术,设计了一种用于ATM终端设备的基于PCI总线的ATM网络适配卡。

    Aim at this peculiarity , this paper utilize EDA technology to design a ATM network adapter for ATM terminal device which is based on PCI bus .

  24. 根据子系统的需要,独立设计出数字化语音系统专用的ISA适配卡,成功利用ISA总线的16位端口方式进行数据传输,波特率可以达到16Mbps。

    A special ISA adapter has been designed to transmit data with the baud rate of 16 Mbps by means of 16-bit port .

  25. 在研制出ISA卡的基础上,设计了PCI总线到ISA总线的转接电路,由此做出了专用于该系统的PCI适配卡。

    Subsequently the author has developed the built-up connection circuit from PCI bus to ISA bus , and then designed the PCI adapter for this system .

  26. 在小型内燃机性能测试台中,设计了智能ISA适配卡,实现了对发动机扭矩和转速的控制。

    Intelligent ISA Card is designed for a multi-type internal-combustion engine testing platform . The control of the engine torque and speed is implemented .

  27. 本文主要介绍双端口RAM的特点、功能及硬件判优工作方式在CAN总线适配卡中的应用。

    This text introduce pairs of characteristic , function , hardware , port of RAM arbitrate working way in bus right to buy application of the card CAN mainly .

  28. 通过深入研究光纤通道五层协议,提出一种基于FPGA、支持定制上层协议的光纤通道适配卡设计。

    In this paper , with in-depth study of five-level Fibre Channel protocol , the design of Fibre Channel adapter which is based on FPGA and can support customed upper layer protocols is proposed .

  29. 完成了适配卡设备驱动程序VxD及上位PC机功能模块的设计。

    The drive VxD of the adapter and functional module of the PC / 104 system were programmed .

  30. 在对HFC上的IP电话系统进行讨论的基础上,提出了能同时处理两路语音信号的基于CABLEModem的IP电话适配卡设计方案。

    In this paper based on the discussion on VoIP system on HFC , a new scheme of design for cable modem-based VoIP adaptor that can process 2-channel speech signal at the same time is proposed .