铁水预处理
- 网络Hot Metal Pretreatment;pretreatment of hot metal;hot metal pre-treatment
-
济钢KR铁水预处理工艺设计
Process Design of KR Hot Metal Pretreatment in Jigang
-
通过对喷吹法和机械搅拌法铁水预处理工艺进行分析,确定选用KR法铁水预处理工艺。
The hot metal pretreatment of injecting and mechanical stirring are analyzed , then the " KR " hot metal pretreatment is confirmed to use .
-
基于改进BP神经网络的铁水预处理终点硫含量预报模型
Final Sulfur Content Prediction Model Based on Improved BP Artificial Neural Network for Hot Metal Pretreatment
-
铁水预处理用Al2O3-SiC-C砖的使用及其损毁机理
Application of Al_2O_3-SiC-C brick for hot metal pretreatment and its wear mechanism
-
开发铁水预处理KR复合脱硫剂,并验证其应用效果。
Introduced the development and application of KR complex desulfurater .
-
CaO-Fe2O3-CaF2铁水预处理脱磷熔剂的研究
Study on Dephosphorizing Flux Containing CaO-Fe_2O_3-CaF_2 for Hot Metal Pretreatment
-
在铁水预处理中CaO-Fe2O3-CaF2基粉剂脱磷工艺和影响因素的探讨
Study on technology and influencing factors on hot metal dephosphorization by cao-fe_2o_3-caf_2 flux
-
MgO和MgO-11%Al2O3等碱性物质可作铁水预处理的耐火材料,空气和氧气都可作为喷吹渣剂的载气。
Both MgO and MgO-11 % A12O3 can be used as the refractory for the pretreatment of hot metal . Compressed-air and oxygen can be the fluxes-blowing carrer gases .
-
通过喷CaO粉和加Mg粉高效脱硫的铁水预处理能将铁水中平均硫含量从350×10-6脱至50×10-6。
The average sulphur content in hot metal could be reduced to 50 × 10 - 6 from 350 × 10 - 6 by hot metal pretreatment - injecting CaO powder and Mg powder high efficiency desulphurization .
-
包钢中磷铁水预处理100kg级热模拟试验研究
100 kg Scale Hot Simulation Test and Study on Pretreatment of Medium-Phosphorus Hot Metal in Baotou Iron & Steel Rare Earth Company
-
重钢在铁水预处理、LF炉外精炼配套技术完善以后,为保证优质、低耗的连铸钢水,进一步缩短冶炼周期和提高生产节奏,开发了长寿复吹转炉冶炼技术。
After hot metal preprocessing and secondary refining technology achieved , long life combined blown converter had been developed in order to ensure high quality and low cost molten steel . It can reduce refining periodic time and improve rhythmic production .
-
使用证明,KR法铁水预处理工艺选型合理,脱硫率稳定在90%左右,能够满足钢种、转炉和连铸机的生产要求。
The application has shown that the " KR " process is reasonable , the degree of desulphurization is 90 % . The process has met the requirement of steel grade , BOF and continuous casting machine .
-
认为对于中等容量的转炉车间,应采用铁水预处理(KR)转炉(BOF)钢包精炼炉(LF)真空处理(RH)连铸(CC)的现代炼钢生产工艺流程。
The authors suggest that the modern steel-making processes of hot metal pretreatment ( KR ) converter ( BOF ) ladle refining ( LF ) vacuum treatment ( RH ) continuous casting ( CC ) should be applied for the medium capacity converter shop .
-
低碱度渣铁水预处理脱磷研究
Experimental Study on Dephosphorization of Hot Metal With Low Basicity Slag
-
国外铁水预处理和钢水二次精炼用耐火材料
Refractories for hot metal pretreatment and molten steel secondary refining abroad
-
镁基脱硫剂在铁水预处理中的应用
Application of hot metal desulphurization using magnesium based reagents at BISCO
-
铁水预处理喷吹法和搅拌法脱硫分析
Analysis of Desulphurization of Injection and Stirring for Hot Metal Pretreatment
-
氧化钙基熔剂的中磷铁水预处理过程的热平衡
Heat Balance of Medium Phosphorus Hot Metal Pretreatment with CaO-based Fluxes
-
鱼雷罐喷粉铁水预处理脱磷动力学模型
Kinetic model for hot metal dephosphorization with flux injection in torpedo-car
-
铁水预处理粉剂组成对脱硫的影响
Influence of Flux Composition on Desulphurization in Hot Metal Pretreatment Process
-
转炉渣用于铁水预处理脱磷剂的热力学分析
The thermodynamic study of hot metal dephosphorization fluxes containing BOF slag
-
喷吹石灰基复合脱硫剂的研究&铁水预处理之一
Study on Hot Metal Pretreatment by Injecting Lime Base Complex Desulphurizer
-
较高硅含量铁水预处理脱磷研究
Study on pretreatment dephosphorization from molten iron with slightly high silicon content
-
铁水预处理中锰和磷的氧化
The Oxidation of Manganese and Phosphorus in Hot Metal Pretreatment
-
铁水预处理同时脱硫和脱磷反应模型及其应用
A Model of Desulfurization and Dephosphorization in Molten Iron Pretreatment
-
铁水预处理过程氮含量控制的试验研究
Experimental study of nitrogen content control in hot metal pretreatment
-
中磷铁水预处理中熔剂成分对脱磷的影响
The Effect of Flux Composition on Dephosphorization for Medium Phosphorus Hot Metal
-
移动电磁场对铁水预处理脱硫速度的影响
Effect of Traveling Electromagnetic Field on Desulphurization Rate of Hot Metal Pretreatment
-
鞍钢第一炼钢厂铁水预处理工艺及故障分析
Molten Iron Pretreatment Technology and Fault Analysis in Angang 's No.1 Steelmaking Plant
-
铁水预处理同时脱硫脱磷的研究
A Study on Simultaneous Removal of Phosphorus and Sulphur in Hot Metal Pretreatment