差热分析仪

利用热重差热分析仪对几种常用木质家具材料在不同氧气浓度下的热分解和燃烧行为进行了研究。

In this paper , TGA and DTA techniques are used to study the pyrolysis and combustion of some furniture wood under different oxygen concentrations .

采用差热分析仪测定不同锑含量的Fe－C－Si－Mn合金的共晶转变温度。

DTA was used to determine the eutectic transformation temperature of the alloy with varying antimony content .

利用元素分析仪和差热分析仪分别对莲纤维中N元素的含量及纤维的热学性能进行了研究。

The content of nitrogen was measured by Elemental Analyzer and the heat property was studied by Differential Scanning Calorimetry .

借助扫描电子显微镜（SEM）、差热分析仪（DSC）分析了共混物的微观结构形态与热行为，并对共混物的力学性能进行了系统研究。

The thermal behavior and microscopic morphological structure of the blends were studied by means of DSC and SEM , and the mechanical properties of the blends were also tested .

采用热重分析仪、差热分析仪、红外光谱、X射线衍射和等温N2吸附考察了样品的稳定性、组成、晶相和孔径及其分布。

The thermal stability , composition , crystalline phase and pore size distribution of powder samples were studied by thermal gravimetric analysis , differential thermal analysis , FT-IR spectrograph , X-ray diffraction and isothermal nitrogen adsorption , respectively .

同时利用差热分析仪研究了Ni-P合金镀层和复合镀层的晶化动力学，运用Ozawa、Freeman-Carroll、Achar和Coats-Redfern方法对非等温动力学数据进行了分析和比较。

The data of non-isothermal kinetics were analyzed and compared by methods of Ozawa , Freeman-Carroll , Achar and Coats-Redfern .

本文利用红外光谱、GPC、示差热分析仪、旋转式粘度计及常规化学手段研究了H&SPAN型高吸水性树脂结构与性能间的关系。

The relation of the structure and properties of water-highly absorptive re - sin of H-SPAN type is studied by using IR spectroscopy , GPC , Differential thermal analysis , rotary viscosimeter and general chemical method etc.

采用C2H2为碳源制备了碳包铁纳米粒子，通过X射线衍射（XRD），透射电镜（TEM），热重差热分析仪（TGDSC）等分析手段对粒子的成分、形貌等进行了表征；

Carbon-coated iron nanoparticles was produced under C 2H 2 atmosphere . The nanoparticles , collected from the reactor wall , were characterized by transmission electron microscopy ( TEM ), X-ray diffraction ( XRD ) and thermal analysis ( TG-DSC ) experiments .

借助X射线衍射仪（XRD）、扫描电镜（SEM）、光电子能谱仪（XPS）和差热分析仪（DSC）等对熔浆法制备的该涂层体系组织结构和抗氧化性能进行了研究。

The microstructure and anti-oxidation property of the anti-oxidation coating system , which was fabricated by fused slurry method were investigated by means of X-ray diffraction ( XRD ), scanning electron microscopy ( SEM ), X-ray photoelectron spectroscopy ( XPS ) and differential scanning calorimetry ( DSC ) .

利用EPMA和高温差热分析仪（TGA），针对低碳钢在不同氧含量的氧化性气氛的高温氧化行为进行了系统研究，获得了实验钢的氧化激活能和氧化铁皮生长形貌。

EPMA and TGA were used to explore the high temperature oxidation behaviour of the low carbon steel under oxidant gas condition with different oxygen content . The oxidation activation energy and growth morphology of the scale were obtained .

利用差热分析仪和拉伸试验机，研究了易熔合金Bi-Pb-Sn-Cd的成分对合金熔点和剪切强度的影响。

The melting point and the shear strength of Bi-Pb-Sn-Cd fusible alloys were determined by DSC and tension tester .

在实验室条件下，利用压力差热分析仪（DTA）分别对新疆和吉林两种生油岩做了压力热解实验。

For a better simulation of the natural degradation of source rock Kero - gen under experimental conditions , pyrolysis experiments on two kinds of source rock samples from Xinjiang and Jilin were carried out by means of high pressure differential thermal analyser ( DTA ) .

采用由日本岛津（SHIMADZU）公司生产的DTG-60H型热重-差热分析仪，对水煤浆在不同升温速率下的特性进行研究，升温速率分别为20℃/min，30℃/min和50℃/min。

The characteristic of coal water slurry at various heating rates is studied with the thermogravimetry-differential analyzer produced by Japanese Shimadzu Company . The heating rates are 20 ℃ / min , 30 ℃ / min and 50 ℃ / min respectively .

智能化小型化差热分析仪的研制

Development on Miniature Intelligent Differential Thermal Analysis Instrument

介绍了标准型和高温型差热分析仪程序温度控制器和热天平部分常见温度检测误差故障的检查、排除方法。

This article introduces the common troubles and trouble_shooting methods for temperature controller and TG basic unit in Rigaku TG_DTA_DSC thermogravimetric_analyzer .

利用热重差热分析仪研究重金属的高温挥发过程，考察了钙硅比、气氛、升温速率等因素对失重率、挥发特性的影响。

The Ca / Si , atmosphere , heating rate , that influence the volatilization rate and reaction characteristics , had been studied .

采用高温金相显微镜研究了含铌冷硬铸铁高温的金相组织，差热分析仪测定了铌对冷硬铸铁固态相变温度的影响。

The effect of Nb on structure at elevated temperature and phase transformation temperature of chilled cast iron was studied in this paper .

在惰性气氛中，利用差热分析仪研究了不同添加剂改质煤沥青筑路油中沥青质的热失重情况。

The thermal weight loss of asphaltene in the pitch road building oil modified with different additives is studied with derivative thermo-gravimetric analyzer in inert atmosphere .

用激光粒度分析仪、红外光谱仪和差热分析仪对聚合物的形态及结构进行了表征。

The polymer morphology and structure were characterized by laser particle size analyzer , IR spectrometer ( IR ) and differential thermal analysis ( DTA ) .

利用扫描电子显微镜和差热分析仪，研究了Sn-0.7Cu粉末的机械合金化过程；

Sn-0.7 Cu powder prepared by mechanical alloying ( MA ) was analyzed using a differential thermal analyzer ( DTA ) and a scanning electron microscope ( SEM ) .

通过傅里叶红外光谱仪、差热分析仪、拉曼光谱等对玻璃固化体结构进行表征，以电感耦合等离子体质谱测试玻璃固化体的抗浸出性能。

Fourier transform infrared spectroscopy ( FTIR ), differential thermal analysis ( DTA ), Raman spectroscopy were used to characterize the glass structure . The leaching resistance property of glass was tested by inductively coupled plasma mass spectrometry ( ICP-MS ) .

系统地研究了7050铝合金经固溶处理后，在人工时效过程中的动力学特征，结合透射电子显微镜，差热分析仪对时效规律及时效过程中的相变机制进行了初步探讨。

The kinetics in the artificial ageing process of 7050 aluminium alloy after the alloy being solution treated was studied systematically . The phase transformation mechanism during the process of ageing was investigated preliminary by transmission electron microscope ( TEM ) and differential thermal analysis ( DTA ) .

用示差扫描热分析仪（DSC）和恒应力拉伸试验研究了时效和冷加工率对Ti-50.5mol%Ni形状记忆合金相变特性和回复应变的影响。

The effect of aging and cold working rate on the trans formation properties and the recovery strain in Ti-50 . 5mol % Ni shape memory alloy have been investigated with DSC ( Differential Scanning Calorimetry ) and mechanical test under a constant stress .

利用示差量热分析仪、Model283potentiostat／galvanostat以及磁天平等仪器，对其中某些纳米材料的电学性能、磁学性能和热学性能进行了初步探讨。

And their electricity , magnetism , and calorifics performance are respectively discussed by using DSC , Gouy balance , and Model 283 potentiostat / galvanostat .

采用TGA-92型热重&差热综合分析仪，对秸秆、桉树木废料、花生壳、稻草、大豆杆及棉杆进行燃烧特性分析。

The burnable characteristics of straw haulm , eucalypt waste , peanut shell , straw , soybean pole and cotton pole were analyzed with TGA-92 heat heavy-difference heat integrated analyser in this paper .

燃烧系统的设计和运行都必须以燃料的自身特性为基础，用热重差热同步分析仪研究了神华煤液化残渣和液化残渣水煤浆的热解以及燃烧特性。

When design or run any combustion system the fuel characteristics must be taken as the foundation .

自动记录差示热分析仪

Auto-recording differential thermal analyzer

热重分析表明，该树脂在改性前后的耐热稳定性差别不大。快速加热差示热分析仪/热天平

TG / DTA analysis shows that the thermo stability of the modified resin is the same with the unmodified resin . rapid TG-DTA unit

超微人参粉粒度及分布测定并采用红外光谱、紫外-可见光谱、激光粒度仪、扫描电镜、差示热分析仪等分别对三种复合粒子进行结构和性能表征。

The determination of the particle and distribution of particle of superfine power Of Panax Ginseng by the laser equipment of particle size analysis , TEM and SEM IR , VIS-UV , Particle size analysis , SEM and DTA were used to analyse their structures and characters .

采用差示扫描热分析仪（DSC）、X射线衍射（XRD）等研究了6061铝合金基体化学镀Ni-P、Ni-W-P合金的组织结构及相转变行为。

The structure and phase transformation behavior of Ni-P , Ni-W-P electroless plating layer on aluminium alloy was studied using differential scanning calorimetry ( DSC ), X-ray diffraction ( XRD ) .