润湿剂

rùn shī jì
  • wetting agent
润湿剂润湿剂
  1. 通过对微电铸原理及析氢机理的分析,提出稳定pH值、增加搅拌和过滤循环、添加润湿剂以及采用脉冲电流等四种有效措施。

    In order to solve hydrogen evolution , the paper analyzed the mechanism of micro - electroforming and hydrogen evolution , then proposed four effective measures , leveling value of pH , adding whisk and filtration cycles , appending wetting agent and adopting impulse current .

  2. 润湿剂DMP-10提高含水疏松砂岩树脂固砂强度

    Improvement of Sand Consolidation Strength by Wetting Agent DMP-10 for High Water-Bearing Loose Sandstone

  3. 电流密度和润湿剂对Ni镀层组织与形貌的影响

    Effects of Current Density and Wetting Agent on the Nickel Coating by Electroplating

  4. 测定了复合浆料的Zeta电位。分别测定了润湿剂为油和水时玄武岩复合纤维材料试片的润湿角。

    Zeta potential of the composite pulp and the wetting angle of the material sample wetted by oil and water are measured .

  5. 以表面活性剂OP溶液为样品润湿剂,以琼脂溶液为悬浮剂,用悬浮液技术将聚合松香样品制成悬浮液;

    Surfactant OP was used as a wetting agent of sample and agar solution was used as a suspending agent , and the suspension of polymerized rosin was prepared by suspension technique .

  6. 详细叙述了由TX-10与氨基磺酸反应制取TX-10硫酸酯钠润湿剂的方法。

    The synthesis of TX-10 sulfate sodium wetter by means of TX-10 reacting with sulfamic acid was introduced in details .

  7. 表面活性剂包括分散剂、润湿剂、主乳化剂及HLB调节剂,为质量比0.35∶0.5∶0.6∶0.4的ABS、OP-10、Tween-20、Tween-80混合物;

    The Ss include dispersant , wetting agent , main emulsifier , and HLB regulator are ABS , OP-10 , Tween 20 , and Tween 80 in mixture in mass ratio 0.35 ∶ 0.5 ∶ 0.6 ∶ 0.4 ;

  8. 结果显示甘露糖酯是一种表面活性较好的物质,甘露糖二酯HLB值均为8~9左右,可作为润湿剂和铺展剂,单酯的HLB为11.22,可以作为O/W型乳化剂。

    The result showed that lauroyl mannoses had good surface activity . The HLB of diesters were all about 8 ~ 9 , which could be used as wetting agent , while the HLB of monoester was 11.22 which could be used as O / W emulsifier .

  9. 根据铝翅片冲压加工工艺的技术特点,选用加氢精制窄馏分轻质油为基础油,添加特制的脂肪酸酯为油性剂以及自制的润湿剂和复合防锈剂等添加剂调合成HC-L200挥发性冲压油。

    A volatile pressing oil HC-L200 was formulated with hydrotreated narrow fraction light base oil , fatty acid ester lubricant and additives , such as homemade wetting agent and compounded antirust agent .

  10. 消痛贴膏中润湿剂的透皮促透作用研究

    Study on Transdermal Enhancing Effect of Wetting Agent in Xiaotong Strapping

  11. 烧结式富锌涂层涂料中润湿剂的选择

    Selection of Wetting Agent in the Paint for Sintered Zinc-Rich Coating

  12. 传统的润湿剂在陶瓷砂轮中存在不可避免的缺陷。

    Traditional wetting agent often leads to defects in vitrified abrasive wheel .

  13. 润湿剂在叶面肥料中的应用研究

    Study on the application of wetting agent in foliar fertilizer

  14. 润湿剂和分散剂之间存在交互作用。

    There was an interaction between wetting and dispersing agents .

  15. 润湿剂种类对热烧结锌铝涂层性能的影响

    Influence of different wetting agents on the properties of sintered Zn-Al coatings

  16. 油井固砂中润湿剂的研究与应用

    Development and Application of Wetting Agent in Sand Control

  17. 增稠剂黄原胶在模拟降雨的情况下对药液的增效作用优于润湿剂有机硅。

    Synergism of thickening agent xanthan gum was better than wetting agent organic silicon .

  18. 包含非离子润湿剂和稳定剂。

    Contains a nonionic wetting agent and stabilizer .

  19. 润湿剂:2.5%;

    The wetting agent : 2.5 % ;

  20. 农药润湿剂的选择与计量

    Selection and Measure of Pesticide Wetting Agent

  21. 报道了润湿剂DMP10在树脂固砂中的应用性能。

    The performance properties of wetting agent DMP-10 in sand consolidation by resin compositions are presented .

  22. 某种有机的润湿剂或消泡剂十分有助于形成可过滤的半水物。

    An organic wetting agent or foam suppressant is quite helpful in the formation of filterable hemihydrate .

  23. 由于润湿剂和分散剂均为表面活性剂,期间存在的相互结合可能是这种交互作用的来源。

    Since the wetting and dispersing agents are surface-active agents , interactions may present during the source .

  24. 因其特殊的结构而具有一些特殊的性质,可以在涂料润湿剂和乳化剂中应用。

    The product is characterized by use of IR , and can be used for wetting agent and emulsifier in coatings .

  25. 采用纳米银粉为抗菌材料,水性氟碳乳液为基料,添加润湿剂、分散剂和消泡剂等助剂,制备抗菌涂料。

    A waterborne conductive coatings was prepared , Which was based on conductive graphite powders as filler and fluorocarbon emulsion as binder .

  26. 指出润湿剂分子与高分子材料表面间的吸附是通过水化膜作为中间相来完成的。

    The adhesion between wetting agent molecule and polymer material surface is accomplished by the hydration film in the form of intermediate phase .

  27. 该过程也属于液态加工过程,但是,为了使化学助剂具有良好的渗透性能,通常需要加入润湿剂。

    This process is also aqueous , but often requires the addition of a wetting agent to obtain good penetration of the chemicals .

  28. 高分子量聚合物型分散剂是本身可成膜的高聚物,与传统的润湿剂相比具有高耐水性和耐皂化性。

    HMW-Polymeric Dispersing Agents are film-forming polymers with a high resistance to water and saponification , this in contrast to conventional Wetting Agents .

  29. 介绍了以复合表面润湿剂为基料,引入增效成分以及其他多种助剂而成的农用增效助剂的研制过程。

    This paper introduced the development of agricultural synergistic agent that include the composite surface active agent , synergist and some accessory ingredient .

  30. 树脂添加剂的作用(润湿剂可提升液态树脂的润湿性,交联剂为树脂膜增强)也得到了证明。

    The role of the resin additives ( wetting agent for improving the wettability of resin , and cross-linking agent ) has been proven .