砂纸

shā zhǐ
  • sandpaper;abrasive paper;sand paper;coated abrasive;glass paper
砂纸砂纸
砂纸 [shā zhǐ]
  • (1) [sandpaper]∶在一面用胶粘上砂子或其他磨料的纸,用于磨光和抛光

  • (2) [glass paper]∶粘有玻璃粉的纸,用来打磨竹木

砂纸[shā zhǐ]
  1. 如果需要,使用细砂纸打磨或用适当的砂粒轻度喷吹所有的拟敷胶表面。

    If required , rub with fine abrasive paper or lightly blast with suitable grit all the surface to which adhesive will be applied .

  2. 新型透明耐水砂纸浸渍处理剂的研究

    Research on Treating Agent of Lucency Water-proof Abrasive Paper

  3. 你可能得用玻璃砂纸打磨一下地板。

    You may need to give the floor a rub-down with glasspaper .

  4. 用细砂纸最后磨光。

    Use a finer piece of sandpaper to finish .

  5. 用砂纸打磨表面,然后再上油漆。

    Rub the surface with sandpaper before painting .

  6. 他们开始工作,用砂纸把木制品打磨平滑。

    They were settling to their work , rubbing down the woodwork with sandpaper .

  7. 用砂纸仔细而轻柔地打磨表面。

    Sand the surface softly and carefully .

  8. 这木料上到处是凹坑,需用砂纸打磨一下。

    The wood is full of pits and needs sanding .

  9. 将这件木器原来的漆烧掉,填补好上面的裂缝,再用砂纸磨光。

    Burn off the old paint , fill any cracks in the woodwork , and rub down well with sandpaper .

  10. 我用砂纸磨边边角角的地方,去除接头处的不均。

    I sanded the corners to take away any unevenness in the joints .

  11. JS-53A型砂布砂纸磨削性能试验仪的研制3M研磨产品在航空维护中的应用

    Development of Js-53A Grinding Properties Tester for Coated Abrasive Products

  12. 基于iFix软件的砂纸生产流水线SCADA系统的实现

    Implementation of SCADA System of Sand Paper Product Line

  13. C组的折裂面用800目碳化硅耐水砂纸湿磨光1min后,再黏接,制成棒状试件。

    The fractured surfaces of Group C were polished with 800-grit SiC sand paper for 1 minute and bonded and then sectioned into bar-shaped specimens .

  14. 因此,制作高回波损耗的光纤连接器应优先选用氧化硅砂纸湿式抛光工艺,抛光时间应控制在20~30s。

    So the wet SiO_2 abrasive polishing process be selected by preference when optical fiber connectors with high return loss are manufactured , and polishing time be controlled in the range of 20 ~ 30s .

  15. 双盘单速金相试样预磨机M-2是一种湿式磨光机,它利用不同粒度的金相砂纸,对各种金属及合金的试样进行磨光。

    Double disc single speed metallographic sample pre mill M-2 is a wet grinder , it uses the different size of the metallographic sandpaper , on a variety of metal and alloy samples .

  16. 结果表明:KH-560处理法能显著提高PE涂层的结合强度,比砂纸打磨、喷砂处理分别提高了40.3%,13.2%,而KH-550,KBM-7103不能显著提高PE涂层的结合强度;

    The results indicated that the adhesive strength of coatings after substrates pretreated with KH-560 was higher than those with sandpaper grinding and blasting by 40.3 % , 13.2 % , respectively , and that KH-550 and KBM-7103 had less effect on the adhesive strength .

  17. 用透射电镜观察了Fe-C-Cr-Mn亚稳奥氏体基铸铁在800SiC砂纸上经往复摩擦磨损试验后磨损表层的微观结构。

    The microstructure of austenite in the worn surface layer of Fe C Cr Mn cast iron sliding against 800 # SiC sand paper was observed with a transmission electron microscope ( TEM ) .

  18. 研究表明:如果硬铝板表面采用砂纸打磨处理时,采用黏度较低的TC-1环氧树脂胶或者在黏度较高的J-22环氧树脂胶中添加2%的硅烷偶联剂KH-560可以获得优异的粘接效果;

    The results show that if the duralumin plate surface is treated with sand papers , the epoxy adhesive TC-1 with lower viscosity or the epoxy adhesive J-22 with higher viscosity where 2 % wt silane coupler KH-560 is added provides good adhesive ability ;

  19. 她用砂纸把桌角打磨光了。

    She rounded off the corners of the table with sandpaper .

  20. 那条粗糙的干舌头正象砂纸一样地磨擦着他的两腮。

    The harsh dry tongue grated like sandpaper against his cheek .

  21. 在这里您可以看到刚才的铰链销用砂纸冲水。

    Here you can just see the hinge pin sanded flush .

  22. 你在上油漆之前要用砂纸把门打磨一下。

    You 'll have to sandpaper that door before painting it .

  23. 这张砂纸特别粗糙,所以你可以干得快些。

    This sandpaper is extra rough , so you can work faster .

  24. 然后将朱砂和油的混合物涂在前额。用砂纸把椅子打磨光再涂上清漆

    Apply that mixture on their foreheads . sand and varnish a chair

  25. 请用细砂纸或锉刀研磨,或者用抛光器磨光。

    Grind it using a fine emery paper or buff it up .

  26. 木匠用砂纸把一块木头打光滑。

    A carpenter smooths a piece of wood with sandpaper .

  27. 粗粒度可重构并行计算的面向对象仿真研究[砂纸]粒度号数,粗细

    Object-oriented simulation study on coarse-grained reconfigurable parallel computation grit size , grit number

  28. 这个没有皮的木料得用砂纸磨光。用砂纸把椅子打磨光再涂上清漆

    The bare wood must be sanded down . sand and varnish a chair

  29. 在漆木板之前先用砂纸将木板打磨光滑。

    Sandpaper the boards smooth before you paint them .

  30. 请用细砂纸或锉刀研磨旋梭尖的伤痕。

    Remove the scratches on the hook point using a fine emery paper .