过渡层

小角X射线散射方法测定结晶聚合物的平均过渡层厚度

Determination of average thickness of transition layer of crystal polymer by small angle X-ray scattering

硅粉水泥石小角度X射线散射实验研究（Ⅱ）&微孔界面过渡层厚度

Experimental Study on the Silica Fume Cement Paste by Small Angle X-ray Scattering (ⅱ) & Micropore Boundary Transition Layer

Cu和Cu/Ti过渡层对金刚石薄膜附着力的影响

Effect of Copper and Cu / Ti Intermediate Layer on Adhesion of Diamond Film

Ni基带上的氧化物过渡层制备

Deposition of oxide buffer layer on rabits Ni tape

Zr过渡层对Al膜微结构与性能的影响

The Effects of Zr Underlayer on the Microstructure and Properties of Al Films

其零电阻温度为101K.薄膜与基片之间界面清晰，没有过渡层，薄膜具有良好的c取向外延条纹。

The zero conductivity temperature of the film is 101K and it is c-axis in orientation with clear boundary between the film and the substrate .

以Al2O3为过渡层脉冲激光法制备PZT铁电薄膜

Growth of high quality PZT thin film with Al_2O_3 buffer layer by pulsed laser deposition

研究了Al2O3过渡层对ZnO薄膜结构形貌和发光特性的影响。

Effects of Al2o3 buffer layer on the properties of ZnO films were investigated .

结果表明：在沉积过程中，随沉积时间增加时，基材表面C浓度增加，O浓度下降，但SiC过渡层的生长缓慢。

The results indicate that the C concentration on the surface increases with the deposition time while the O concentration decreases .

等离子喷涂NiCrAl/ZrO2过渡层对FeCrAl/γ-Al2O3结合性能的影响

Influence of plasma-sprayed NiCrAl / ZrO_2 intermediate on adhesion of FeCrAl / γ - Al_2O_3

沉积一定厚度的钛过渡层可以显著提高TiN膜层与基体的结合力。

Depositing a certain thickness of Ti transition layer can promote adhesion strength between bias and coating greatly .

带有中间过渡层的Si3N4/Q235钎焊接头残余应力数值模拟

The Numerical Simulation of Residual Stress in Si_3N_4 / Q235 Welding Joint with Interlayer

Mo2C过渡层对金刚石-碳膜场发射均匀性的影响

Effect of mo_2c intermediate layer on electron field emission uniformity of diamond-carbon films

实验结果及分析表明，TiN涂层过渡层由混合层及扩散层组成，扩散层包括Ti原子扩散层及N原子扩散层；

The results show that TiN interlayer is composed by mixed layer , Ti atom diffusion layer and N atom dispersion layer .

用SEM检测了试样的金相组织及渗层厚度，结果表明经多元共渗后表面改性层由疏松层、白亮层、过渡层组成。

Result shows that the modified layer is composed of the loose layer , the bright layer and the transition layer .

TiC中间过渡层对硬质合金表面沉积（类）金刚石的影响

Effect of TiC Intermediate Transition Layer on the Diamond Film Deposited on Surface of Hard-metal

ZnO壳与CdS核之间并没有形成明显的晶界，仅通过一层过渡层相连。

There is no obvious crystal boundary between core and shell , only connected by a transition layer .

AlNi过渡层由陶瓷涂层到钢基体，由压应力过渡到拉应力；

The stress changed from compression stress to tensile stress with the Al / Ni adhesive coating from ceramics coating to steel base ;

测试结果表明有PT过渡层的铁电薄膜具有良好的铁电和介电性能。

Experimental results showed that the PZT thin films with PT buffer layer had good ferroelectric and dielectric properties .

梯度过渡层对TiC薄膜中残余应力影响的研究

A Study of the Effect of Gradient Interlayer on the Residual Stress in TiC Thin Films

ZnS窗口上过渡层的研究

Studies on the buffer layers of ZnS windows

含金刚石的复相过渡层及Al2O3衬底上金刚石薄膜的附着力

Deposition of a new kind of composite interlayer containing diamond phase and its application in enhancing adhesion of diamond coatings on alumina substrates

结果表明，采用激光表面重熔预处理作过渡层制备的生物陶瓷涂层的界面结合良好，表层为HA和β－TCP组成的活性生物陶瓷复合涂层。

The results show that laser remelting pretreatment is favorable to improvement of the mechanical properties and biocompatibility of bioceramic coating .

Ni－Cr衬底上MOCVD法制备YSZ过渡层的研究

YSZ buffer layer on Ni-Cr alloy substrates grown by MOCVD

大尺寸反射镜高精度光学镜面Ni-P过渡层的制备方法

Preparation of Ni-P Alloy Transition Layer of High-Precision Optical Surface for Reflection Mirror with Large Size

实验发现低温生长GaN过渡层有利于晶体质量的提高；

The experimental results show that the GaN buffer is necessary for improving the quality of GaN epitaxial layer .

水泥石&集料界面过渡层中CH晶体取向机理的探讨

A Hypothesis about the Mechanism of Orientation of CH Crystal in Interface Layer between Cement Paste and Aggregate

缝纫机针杆表面沉积含过渡层DLC薄膜及性能的研究

Properties of DLC films with buffering layers deposited on needle surface of sewing machine

摩擦表面生成由富C层和过渡层组成、厚度250~450nm左右且分布不均匀的修复改性层，初步推测其中富C层为类金刚石结构；

A 250 ~ 450 nm repaired layer with a carbon-rich layer and a transition layer was unevenly distributed on the frictional surface . The carbon-rich layer was supposed as in DLC structure .

每种成分的Ti（C，N）基金属陶瓷基本上都能形成芯-环结构，而且大部分芯-环结构都具有过渡层rim相。

All the Ti ( C , N ) - based cermets can basically form a core-shell structure , and most of the core-shell structures have the rim-phase .