介电损耗角正切

jiè diàn sǔn hào jiǎo zhènɡ qiē
  • dielectric loss angle tangent
介电损耗角正切介电损耗角正切
  1. 当质子辐照剂量大于1015cm-2后,体积电阻率及交流击穿电压下降,介电常数及介电损耗角正切上升。

    After the irradiation dosage more than 10 ~ ( 15 ) cm ~ ( - 2 ), the alternating breakdown voltage and bulk resistivity decreased , but the dielectric constant and the dielectric loss angle tangent increased .

  2. 研究发现,当质子辐照剂量小于1015cm-2时,交流击穿电压上升,体积电阻率、介电常数及介电损耗角正切无明显变化。

    Experimental results showed that under the proton irradiation dosage less than 10 ~ ( 15 ) cm ~ ( - 2 ), the alternating breakdown voltage increased , but the bulk resistivity , the dielectric constant and the dielectric loss angle tangent changed a little .

  3. 与聚苯胺相比,镍铁氧体/聚苯胺复合材料的介电损耗角正切tanδε值与磁损耗角正切tanδm值都增大。

    Dielectric loss tangent and magnetic loss tangent of the nickel ferrite / polyaniline composites are higher than those of the polyaniline .

  4. 总体来看,介电损耗角正切值也有随着碳化温度升高而增大的变化趋势。

    In general , the dielectric loss also had rising trend as carbonizing temperature increased .

  5. 报导了近十年来微波技术在介电损耗角正切大,即(εs&ε∞)高的一类聚合物加工中的应用概况。

    The application of microwave to polymers . which have high dielectric loss tangent ( high ε s ~ε ∞) in the last ten years is reviewed in this paper .

  6. 以相对介电常数和损耗角正切为输入特征参数,应用BP神经网络技术识别桃的新鲜度等级,平均识别率为82%。

    Furthermore , BP neural network technology was used to identify freshness of peaches when relative dielectric constant and loss tangent were selected as input characteristic parameters . Results showed the average distinguishing rate was 82 % .

  7. 介绍了利用微带电路来确定一组高性能、高频印刷电路板材料的介电常数和损耗角正切的方法,且给出了一组印刷电路板材料的特性测量值。

    The paper introduces measurements about dielectric constant and tangential loss angle of a group of good function and high frequency printed electronic circuit plate with microstrip circuit .

  8. 在室温条件下,猕猴桃的相对介电常数和损耗角正切随温度的增大而增大,电阻率随温度的增大而减小。

    At the usual temperature , the relative dielectric peculiarity parameters and loss tangent increase with the temperature 's increase , while the resistance will decrease with the temperature 's increase .

  9. 不均匀介质相对介电常数和介质损耗角正切的计算

    Calculation for Relative Dielectric Constant and Dielectric Loss Tangent of Heterogeneous Dielectric

  10. GB/T1693-1981硫化橡胶工频介电常数和介质损耗角正切值的测定方法

    Vulcanized rubber & Determination for industrial frequency dielectric constant and dielectric loss angular tangent value

  11. 研究了SiC(N)纳米粉体的介电常数和介电损耗角正切与粉体组成的关系。

    The microwave permittivity of the mixture of the SiC ( N ) nano powder with paraffin wax was measured .

  12. 相应地,对表征其介电特性的参数如介电常数ε、损耗角正切tanδ等的测试技术研究也日益受到人们的重视。

    Accordingly , test technology on the characterization of their dielectric property parameters such as dielectric constant , dissipation factor has also been paid increasing attention .

  13. 介绍一种高损耗介电材料的介电参数(介电常数、介质损耗角正切、交流电导率)测量的新方法及其原理。

    This paper presents a new method to measure the dielectric parameters of high-loss dielectrics ( dielectric constant , dielectric dissipation factor , AC conductivity ) and its principle .

  14. 研究表明,二氧化锰属于一种介电损耗介质,具有较高的电阻率和较大的介电常数,而且其介电损耗角正切随频率的增加变化不大。

    Results show that MnO_2 is a kind of dielectric loss medium , and it has high electric resistivity and dielectric constants .