单槽

  • 网络single-slot;Single Slot
单槽单槽
  1. 顾名思义,MailBox从本质上说就是Drop,用于在检测之前保存数据块的单槽缓冲区。

    As its name implies , MailBox is essentially the Drop by itself , a single-slot buffer that holds a piece of data until it has been retrieved .

  2. 铝电解生产过程中会形成大量的生产数据,有单槽单参数数据,也有单槽多点多参数数据,同时随着生产的运行,会不定期地增加一些工艺参数的检测与分析。

    Aluminum electrolysis process will produce large amounts of data , single-slot single parameter data , also have single-slot multicast data , at the same time as production operation , will not regularly add some process parameters of testing and analysis .

  3. 单槽电压由3.177V降至3.116V,吨碱电耗下降42.5kW·h。

    The voltage of unit cell decreased from 3.177 V to 3.116 V , the electricity consumption decreased by 42.5 kW · h / ( t · NaOH ) .

  4. Φ100mm单槽自动轧管机组的技术改造与实践

    Technical Innovation of Φ 100 mm Mono-groove Plug Pipe Mill

  5. Φ100mm单槽自动轧管机球形顶头自动更换装置设计

    Design of Automatic Spherical Plug - change System of mm Mono-groove Plug Pipe Mill

  6. 通过单槽试验确定较合适的添加剂配比为:明胶:40~45g/t;

    By single - electrobath experimentation the appropriate stoichiometry of additive was glue : 40 ~ 45g / t ;

  7. 介绍了应用先进的工艺和设备对Φ100mm单槽自动轧管机组生产线以及局部生产设备进行的技术改造。

    The Φ 100 mm mono-groove plug pipe mill line as well as part of the manufacturing equipment units are innovated with relevant the-state-of-art technology and equipment .

  8. 将其用于棒材连轧机精轧机架,可使轧辊裂纹和剥落缺陷明显减少,一次修磨单槽轧制量大于450t,且轧辊非正常报废比率由15%降至1%左右。

    After using in the bar finishing mill , the defects of roll obviously lessened and the waste rate decreased from 15 % to 1 % .

  9. 实验室XFD-63单槽浮选机更新换代、技术创新对实验室选矿试验工作发挥着重要作用。

    The upgrading and technological innovation of the lab-used single flotation cell of XFD-63 has important meanings for the laboratory test work of mineral processing .

  10. 采用改性隔膜扩张阳极技术的电解槽比普通隔膜电解槽单槽电压可降低0.15V左右,生产1t烧碱可节电105kW.h。

    The single groove voltage of the electrolyzer by modified diaphragm and expanded anode technique can be reduced by about 0.15 V than that of common diaphragm electrolyzer . And 105 kW · h electric quantity can be saved by producing caustic soda per ton .

  11. 单槽泳动床反应器脱氮及去除有机物研究

    Removal of Nitrogen and Organic Substance by One-trough Swimming Bed Reactor

  12. 单槽单桨磷酸萃取槽

    Phosphoric acid reactor with single tank and single central agitator

  13. 该反应器兼有单槽和多槽串联的特征;

    The mixer is characteristics of Single and multiple tank ;

  14. 单槽碳分生产非冶金用氢氧化铝的研究

    Using the Carbonation in the Single Tank for Alumina Hydrate for Non-metallurgical

  15. 单槽空气跳汰机及其检测系统的设计

    Design of single trough air jig and measuring system

  16. 单槽缝热管的实验研究

    Experimental Study on Single - Groove Heat Pipe

  17. 单槽冲模中凸模固定结构的改进

    Improvement in the Fixed Structure of the Punch of the Stamping Die with a Single Slot

  18. 分别采用单槽法和双槽法电沉积制备Cu/Ni多层膜。

    In this paper Cu / Ni multilayers were prepared by using single-bath and double-bath methods respectively .

  19. 第一个多尔-奥利佛单槽反应器是以1959年完成的小型试验为基础的。

    The first Dorr-Oliver single-tank reactor installation was based on a small-scale pilot-plant study done in 1959 .

  20. 在分析国内外现有网架(壳)节点的基础上,提出了一种新型单槽齿承插式节点。

    A new kind of grid shell node named single trough node is discussed in this paper .

  21. 有时把多槽和单槽反应装置装设在室外。

    For some time it has been the practice to install both multitank and single-vessel reaction units outdoors .

  22. 介绍了电机转子端板单槽冲模的几种结构形式,对这几种结构进行了比较,并给出结论。

    This paper introduced several structures of single punching dies of rotor shield plank of motor , then compared them and drew a conclusion .

  23. 本文介绍了打壳和定容气动装置的选择,系统气控原理,单槽压缩空气用量和管径的选择。

    The paper expatiates on principle of pneumatic control , option for crust breaker and feeder and calculating consumption of compressed air per pot and pipe diameters .

  24. 本文针对金川公司铜电解生产过程中存在阴极铜板太薄,表面结粒多、易氧化发黑等问题进行原因分析。通过实验室试验研究、现场单槽生产试验,取得成功。

    It exists some questions that copper plate is too thin , the surface agglomerate grains are so many and the surface is oxided easily in the productive process of Jinchuan Co.

  25. 根据分解工艺对多品种氢氧化铝性能的影响,对单槽碳分氢氧化铝存在的缺陷及原因进行了分析,结果表明连续碳分和种分分解工艺适合生产多品种氢氧化铝;

    Based on effect of Precipitation process of sodium aluminate on performance of special aluminium hydroxide , the defects of single column carbonation precipitation process and its causes are analyzed in this paper .

  26. 通过轧制7角钢的实践,得出采用开口切分孔轧制角钢不仅使轧件平直,而且可提高单槽轧出量5%,且减轻了主电机负荷。

    The practical results of rolling 7 angle steel sLow that using open slitting pass rolling angle steel make stick flat , increase the production 5 % on one pass and decrease the motor load .

  27. 该浮选机属压气式机械搅拌浮选机,采用圆柱体形状,槽深达3~4m,单槽容积大,处理量大,自动化程度高,浮选效率高,有利于极细颗粒煤泥的浮选;

    This flotation machine is of mechanical agitation with pressurized aeration , has a cylindrical cell with a depth of 3-4m , large volume and high throughput per single cell , high level of automation and flotation efficiency , and is suitable for fine slime flotation ;

  28. 单断断槽式、单断断阶式的凹陷以中央构造带作为油气勘探的突破口;

    Breakthrough gap is central structural belt in single-faulted trough terrace sags ;

  29. 阀控式铅酸蓄电池的电极和隔膜被紧装配在单体槽中。

    The electrodes and the separators in VRLA battery closely assembled against the cell wall .

  30. 模糊事故树在分析氯乙烯单体槽爆炸风险中的应用

    Application of Fuzzy Fault Tree Method in Risk Analysis of Vinyl Chloride Monomer Tank Explosion