变形速率

研究表明，电磁辐射基本上随着加载及变形速率的增加而增强；

Studies show that EME usually becomes stronger with the increase of load and the rate of deformation .

在岩石压缩试验中，按等变形速率加值，势必造成变形和荷载响应的不同步，即一个匀速而另一个则出现加速或减速现象；

In compression test of rock loading in a constant rate of deformation way will undoubtedly lead to non synchronism between deformation and load response .

详细地讨论了温度和变形速率变化对3D-C／SiC力学性能产生影响的内在方式。

Affect mode of temperature and displacement velocity variance on 3D-C / SIC mechanical properties was discussed in detail .

之间存在指数函数关系；动态再结晶完成后，奥氏体晶粒平均直径与变形速率温度修正系数Z之间符合线性关系。

Af ter the dynamic recrystallization was finished , the relationship between the average diameter of austenitic grains and the modification factor Z of temperature for de formation velocity was linearly conformable .

采用Gleeble1500热模拟机对半固态CuNiSi合金的触变性能进行了研究，同时分析了不同微量元素、不同变形速率对该合金触变性能的影响。

The thixotropy property of Cu Ni Si alloy in semisolid using the Gleeble 1500 thermal simulator was studied , and the effects of different micro elements and deformation rate on thixotropy property also were analysed .

降低变形速率、提高变形温度有助于降低Ti-Al纳米杆的屈服强度，使塑性变形更容易进行。

The lower strain rate and higher deformation temperature decrease the yield strength and then benefit the plastic deformation .

利用装置所测得的管道变形速率并根据Monkman-Grant关系计算了直管段和弯管段的剩余寿命。

The residual lives are attained through Monkman-Grant relationship according to the strain rates measured by devices .

研究了两种不同工艺（11自然硬化法和22烧结法）生产的泡沫陶瓷分别在1mmmin和5mmmin的变形速率和不同方向受到单向压缩条件下的应力-应变曲线或力-位移曲线。

The stress strain curves of force displacement curves of ceramic foams made by different methods under compression with a deformation speed of 1mm / min or 5mm / min in different directions are studied .

应用变形速率连续可变式热裂纹试验方法（VDR法）研究了碳、钼和稀土元素对奥氏体不锈钢焊缝热裂敏感性的影响。

The effect of carbon , molybdenum and rare earths on hot cracking susceptibility of austenitic stainless steel welds was studied with continuously variable deformation rate cracking test ( VDR ) method .

分析了MB15镁合金在不同变形速率下组织和力学性能的变化规律。

In this paper , the low of MB15 magnesium alloy is analysis in different rate about structure and mechanics property .

研究了SWRH82B钢在高温多道次高变形速率下再结晶的规律。

The re-crystallization rule of SWRH82B steel at high-temperature , more rolling times and high deformation rate was studied .

首次应用变形速率连续可变式热裂纹试验方法（VDR法）研究合金元素对HQ高强度钢埋弧焊结晶裂纹敏感性的影响。

The sensitivity of crystallization cracking which is affected by alloy elements in HQ high strength steel submerged arc welded metal was studied with continuously variable'deformation rate cracking test ( V-DR ) method for the first time .

BS700MC的应力值随着变形速率的加大、温度的降低和变形程度的增大而升高。

The stress increased with increasing the deformation ratio , increasing the deformation degree and decreasing the temperature .

在恒定的变形速率下3D-C／SiC的拉伸断裂应力在低于制造温度下随温度上升而上升，在接近制造温度1100℃附近达到最大值，然后随温度升高而降低；

The main research findings are as follows : At the same displacement velocity 3D-C / SiC tensile fracture stress increases with testing temperature increasing , when temperature reach material producing temperature 1100 ℃ the fracture stress reach maximum , then it decreases with the temperature increasing .

弹性阶段煤体的变形速率降低；

Lower deformation rate of coal specimen in stage elastic ;

提出了非线性变形速率的动态趋势曲线，可对基抗每一开挖阶段的变形采用幂函数形式定量地表示。

Dynamic trend curve of nonlinear deformation is put forward .

超高压工艺和热变形速率对各向异性复合永磁材料制备的影响

Influence of Ultra-High Pressure Technology and Hot Deformation Rate on Anisotropic Composite Magnets

变形速率对2205双相不锈钢形变诱导相变的影响

Influence of Deformation Rate on Strain-Induced Phase Transition of 2205 Duplex Stainless Steel

而变形速率则对最终强度影响不明显。

The effect of deformation rate is not obvious .

在中高应变速率区，岩石的强度增加很大，而粘性与变形速率成反比。

In moderate and high deformation rate region , dynamic strength increases substantially ;

变形速率比值判据与猫山隧道工程验证

Deformation Rate Ratio Criterion ( DRRC ) and Its Verification in Maoshan Tunnel Excavation

低温和大变形速率变形能细化铁素体晶粒组织。

Smaller ferrite grains can be attained at a lower deformation temperature and a greater strain rate .

材料的初始弹性模量在不同温度下均随变形速率的增加而增加。

Fracture strain decreases and initial modulus increases with the increment of displacement velocity at different temperature .

变形速率对含磷高强无间隙原子钢高温变形行为的影响

Effect of Deformation Rate on Deformation Behavior of High Strength IF Steel Containing P at High Temperature

滇西北大理冰期及冰后期地壳变形速率

Dali glacial period in the Northwest Yunnan and rate of crustal deformation in post ~ glacial period

流变应力随着变形速率的增加而增加，随着变形温度的升高而降低。

The flow stress decreases with the increase of deforming temperature and increases with the increase of strain rate .

用恒变形速率拉伸试验方法研究了铁素体奥氏体双相不锈钢焊缝金属的断裂行为。

The fracture behaviour of weld metal of ferrite-austenite duplex stainless steel was investigated by constant deformation rate tensile test .

固定变形速率时，升高变形温度则强度降低，延性增加。

At the same extrusion strain rate , both yield strength and ultimate strength decrease with increasing of the extrusion temperature .

造山运动发展阶段性主要表现为主逆冲断裂带的转换和变形速率的变化。

The stage-by-stage development of orogeny is mainly marked by the transformation of the main thrust zone and change of the deformation rate .

液-固两相区压缩变形速率对SiCw/6061Al复合材料组织和性能的影响

Effects of Compression Deformation Strain Rates at Temperature in the Solid-Liquid Two-phase Region on the Microstructure and Properties of SiCw / 6061Al Composites