撕裂性能

  • 网络Tear resistance
撕裂性能撕裂性能
  1. EPDM具有良好的抗磨损和抗撕裂性能,以及优秀的抗酸碱化学腐蚀的性能。

    EPDM has good abrasion and tear resistance and offers excellent chemical resistance to a variety of acids and alkalines .

  2. 但是在高温下POE的拉伸性能下降较大,其撕裂性能略低于EPDM和SBR胶料;

    But the tensile strength of POE compound decreased dramatically at high temperature , and its tear resistance was somewhat lower than that of EPDM or SBR compound ;

  3. CF-60钢抗层状撕裂性能与显微组织的相关性研究

    Relation between resistance to lamellar tearing and microstructure for CF-60 steel

  4. 浸胶用间苯二酚-甲醛-胶乳(RFL)成膜性及其胶膜撕裂性能的研究

    The Study on the Formation and Tear Properties of Films Made of Resorcin-Formaldehyde-Latex ( RFL ) Used in Immerging Cords

  5. 结果发现,此交联剂可以显著改善水基PUR膜的拉伸强度、撕裂性能、耐水性和较宽温度范围内的动态力学模量。

    The results indicate that the crosslinking agent can significantly improve the tensile strength , tear strength , water resistance and the dynamic mechanical properties in a wide temperature range .

  6. 在辐照剂量R≥10kGy时,PVDC产生辐射交联,PVDC膜的拉伸性能、撕裂性能、热收缩性能、热稳定性能和色泽受R的影响较明显;

    Results showed that when radiation dose R ≥ 10 kGy , PVDC could be crosslinked and it had an evident effect on tensile , tearing , shrinkable properties and heat stability as well as colour of the film with the increasing of R ;

  7. 结果表明,用IR部分替代NR后胶料的拉伸性能略有降低,撕裂性能提高,轮胎半成品和成品性能满足相应国家标准的要求,工艺性能良好。

    The results showed that the tensile strength decreased slightly , the tear strength increased and the better processibility was obtained with IR partly replacing NR in the compounds ; the properties of semi product and the performance of finished product met the requirements in the relevant national standards ;

  8. 当SiO2添加量为3%(相对于多元醇的质量分数)时,PU/SiO2复合材料的综合性能最优。多交联聚氨酯材料具有比均一聚氨酯材料更好的耐撕裂性能和断裂伸长率,拉伸性能区别不大。

    PU / SiO2 composites have best over-all performance when the SiO2 content comes to 3 % ( based on the mass of polyols ) . Multi-crosslink PU materials had much better tear-resistance property and elongation at break , similar tensile strength , compared with homogeneous PU .

  9. 舞钢研制开发的调质钢WH80Q具有高强度、良好的低温冲击韧性、抗层状撕裂性能、较低的时效敏感性系数。

    The quenched and tempered steel WH80Q offers high strength , excellent low temperature impact toughness , lamellar tearing resistance and lower aging sensitivity factor .

  10. 煤矿用电缆氯化聚乙烯护套抗撕裂性能研究

    Study of the Tear-Resistance of Chlorinated Polyethylene Sheath in Mining Cables

  11. GB/T16578-1996塑料薄膜和薄片耐撕裂性能试验方法裤形撕裂法

    Plastics Film and sheeting Determination of tear resistance Trouser tear method

  12. 篷盖织物基布及涂层布撕裂性能研究

    The ground fabric for covering-use cloth and the tearing performance after coated

  13. 纤维特性与纸页撕裂性能关系的研究

    Study on the Relationship between Fiber Properties and Tearing Strength

  14. 不同结构相涤纶平纹织物的拉伸与撕裂性能分析

    Research of Polyester Fabric Tensile and Tear Properties of Different Structure Plain Weave

  15. 多向载荷下PVC/双轴向经编织物的开缝撕裂性能

    Precracked tearing properties of PVC / biaxial warp knitted fabric under multiaxial loads

  16. 压延类柔性复合材料的抗撕裂性能研究

    Tearing Property Study on the Calendered Flexible Composites

  17. 牛仔布撕裂性能研究

    The Study of Tear Property of the Denim

  18. 输送带抗冲击、抗撕裂性能试验研究

    Experimental Research on Anti - impact , Anti - tear Performance of Conveyer Belt

  19. 经编双轴向织物撕裂性能研究

    The Study of Warp-Knitted Biaxial Fabric Tearing Property

  20. 灯芯绒织物撕裂性能研究

    The Study of Tear Property of Corduroy

  21. 双向拉伸载荷下双轴向经编织物增强柔性复合材料开缝撕裂性能研究

    Precracked tearing properties of flexible composites reinforced with biaxial warp knitted fabric under biaxial loads

  22. 纤维特性对纸页撕裂性能的影响

    The Effects of Fiber on Paper Properties

  23. 以双轴向经编针织物为骨架的增强塑料布撕裂性能的研究

    Research on Tearing Property of Reinforced Plastic Film with Bi - axial Warp Knitted Fabric Skeleton

  24. 另外衬经纱的衬入方式对撕裂性能也有一定的影响,文中还引入撕裂时纱线的强力利用率来针对基材不同密度,经纬向差异等进行深入分析。

    We introduce the yarn strength utilizing ratio to analyze the difference because of the density and warp / weft direction .

  25. 细小的M/A岛有利于改善低温韧性;试制钢板具有良好的强韧性和抗层状撕裂性能。

    Fine M / A was favorable for low temperature toughness . Offshore platform plate had excellent toughness and anti-lamellar tearing property .

  26. 并通过大量的实验,来确定各参数对输送带的抗冲击性能、抗撕裂性能的贡献。

    And it confirms every parameter of belt how to influence the anti-tear and anti-impact performance of belt through a large number of experiments .

  27. 通过使用适当的活性助剂,动态屈挠性能、耐撕裂性能和拉伸强度等最终物理性能相当于或优于硫黄硫化体系,但是耐热老化性能要好得多。

    By using the appropriate coagent , final properties such as dynamic flexibility , tear resistance , and tensile strength are comparable or superior to sulfur-cured systems with much better heat-aged performance .

  28. 详细研究了尼龙和聚酯短纤维用量对尼龙-天然橡胶和聚酯-氯丁橡胶复合材料的20%定伸应力、拉伸强度及撕裂性能的影响。

    The influence of the loading level of nylon and PET short fibres was studied on the physical properties of Nylon-NR and PET-CR Composites , such as 20 % modulus , tensile strength and tear resistance .

  29. 研究了不同标准下膜材的撕裂性能和机理,重点研究了中缝撕裂法中初始裂缝长度和方向对其撕裂性能的影响。

    The tear properties and mechanisms of membrane materials under different standards were studied , especially the influence of the crack length and direction on its tearing strength and strain under mono-axial centre slit tear test .

  30. 本实验从纤维特性&纤维长度、粗度和纤维本身强度方面研究了对纸页撕裂性能的影响,也研究了打浆、压榨对纸页撕裂强度的影响。

    The effects of three principal fiber properties-length , coarseness and strength-on the tearing strength of paper have been studied . The effects of beating and pressing on the tearing strength of paper also have been investigated .