裕量

  • 网络margin;allowance
裕量裕量
  1. GPS现代化信号体制与系统裕量分析

    GPS Modernization Signal System and System Margin Analysis

  2. 确定PID控制器参数使闭环系统具有给定的相位裕量。

    Evaluating the PID parameters to enable the closed loop syetem with the given phase margin .

  3. 四足步行机结构参数P、Q的关系与稳定裕量S的分析

    The relation between the position construction parameters p and Q of a quadruped walking robot and an analysis of the stability margins

  4. 采用特定相位裕量方法动态调整PID控制器的参数,使控制器能在线自适应网络系统中的变化。

    The controller parameters are dynamically tuned by applying especial reference phase method for adapting the change of the Internet system .

  5. 在时滞系统PID控制闭环稳定的基础上,进一步引入频域稳定裕量:幅值裕度、相角裕度。

    In condition of the time-delay systems closed-loop stability , introduce the frequency stability margin : gain margin and phase margin .

  6. 通过MATLAB对滚转回路的模型进行仿真,比较了不带角速度反馈和带有角速度反馈情况下,系统的幅值增益和相位裕量。

    The model of roll is simulated by MATLAB . The system gain and phase margin is compared with rate gyros and no rate gyros .

  7. 在DVD聚焦系统中引入超前滞后补偿器以增加系统的低频增益和稳定裕量;

    A lead-lag compensator is introduced into a DVD focus system to increase the low-frequency gain and stable margin of the system .

  8. 它在多个现场可编程阵列(FPGA)上实现各功能模块,以充分利用各FPGA的容裕量,达到系统资源分配的平衡。

    By implementing the functional modules on diverse FPGAs , it utilized the resource on each FPGA to the most extent , and equalized the resource distribution among all FPGAs .

  9. 一些图形组合难以通过修正而得到足够的制造裕量,这些图形通常被称为OPC不友好的(OPCUnfriendly)。

    Some pattern configurations are harder to be corrected to get enough process margin , which are usually called " OPC-unfriendly " for a particular lithographic process .

  10. 初步的研究结果表明:如果在自然循环长度和延伸燃耗运行期内发生落棒事故,对于基负荷运行和基负荷一次调频运行,均有PCI的应力裕量,不会造成燃料棒破损。

    The results show there are enough stress margins for the base load operation and primary frequency control operation if rod drop accident occurs in the natural cycle and stretch out operation , therefore no risk of PCI failure has been found .

  11. 针对电流型电荷泵PLL频率综合器芯片,提出一种称为极值相位裕量的无源环路滤波器方案和设计方法。

    A passive loop filter scheme and the design method of the filter for current charge pump PLL frequency synthesizer chip are given in the paper . The method is known as the method of extreme value phase margin .

  12. 发射功率裕量K设置约为SSNR时系统有最高吞吐率,而增强接收机的抗噪能力(降低SSNR值)将极大提高功率控制协议的性能。

    Simulation results also indicate that the increase of the receiver 's noise tolerance capability ( that is , a lower SSNR value ) will greatly improve the performance of power control protocols .

  13. 该氦气系统的特点体现在:双功能,即有宽的裕量满足SLL-TBM和DLL-TBM实验;

    The features of the system is that the equipment specification has wide margin for DLL-TBM and SLL-TBM test , i. e.

  14. 仿真结果显示,在SSS、TTT和FFF三种条件下,环路带宽变化仅为12%,相位裕量只变化0.1°。

    Simulation results demonstrate that , under SSS , TTT and FFF conditions , the variation of the unity-gain bandwidth of the PLL is only 12 % and the variation of phase margin is only 0.1 degree .

  15. 测试结果表明,无线信道功率裕量均在30dB以上,信道可靠性优于99.99%,各道信号实际连续率在99.67%以上,超过规范规定的要求。

    The test results show that the power abundances of radio channels are over 30 dB , the channel reliability is superior to 99.99 % , and the practical continuity of channel signal is 99.67 % or more .

  16. 其次在相同指标下采用相位裕量和幅值裕量法整定分数阶控制器参数,完成了分数阶比例积分(FOPI)控制器和分数阶[比例积分](FO[PI])控制器的设计。

    Secondly , the method of phase margin and gain margin is adopted for fractional order controller parameters tuning , and the fractional order proportional integral controller and the fractional order [ proportional integral ] controller are designed in the same index .

  17. 提出了基于X-Q自适应控制器的一类非线性控制器及大相角裕量计算机辅助设计多目标优化算法,以制浆蒸煮过程实际工艺为应用背景进行研究。

    The large phase angle allowance design method of multi-objective optimal control system and a first class new type nonlinear controller based on X-Q controller are presented ; pulp cooking process reality for the background applying is in progress .

  18. 级联电路的稳定裕量及其工程测量

    To Examine Stability Margin and Its Engineering Measurement of Cascade Circuits

  19. 针对这个问题,进行了准确的螺纹裕量计算。

    Aiming at this issue , accurate thread excess was calculated .

  20. 相位裕量是控制系统设计的一个极为重要的参数。

    Phase tolerance is an important parameter in designing control systems .

  21. 钢制压力容器与管道腐蚀裕量的可靠性设计

    Reliability Design of Corrosion Allowance for Steel Pressure Vessel and Piping

  22. 迫流冷却超导磁体稳定裕量的计算模型

    Calculation models of the stability margin for forced - flow cooled magnets

  23. 选用通风机流量裕量的概率分析法

    Probability Analysis Method to Select Flowrate Allowance for a Fan

  24. 基于裕量最大的多载波快速最优比特分配算法

    An Optimal Bit Loading Algorithm for Max Margin Problem in Multi-Carrier Modulation

  25. 一个计算腐蚀裕量确定检验周期的实例

    An Example of Determining Inspection Period by Calculating Corrosion Allowance

  26. 锁相跳频源的极值相位裕量设计法

    Design of PLL Frequency Synthesizer by the Method of Extreme Value Phase Margin

  27. 计算相位裕量的传统方法计算量大。

    On Quantity Conventional calculation methods necessitates tedious computations .

  28. 获得最佳的数据读取时序裕量和功率性能

    Designing for Optimum READ Timing Margins and Power Performance

  29. 压力容器强度计算中如何考虑腐蚀裕量

    Consideration of Corrosion Allowance in Pressure Vessel Strength Calculation

  30. 等功率裕量法在双机架可逆轧机中的应用

    Application of Equivalent Rate of Power on Double Stands Reversing Cold Rolling Mill