重整反应器

  • 网络reforming reactor
重整反应器重整反应器
  1. 对超期服役重整反应器采用正火加喷淋工艺进行恢复

    The Restoration of Over-Service-Time Reforming Reactor by Normalizing under Spray Type Cooling

  2. 楔形条缝焊接筛网在重整反应器中的应用

    Application of weld ing screen cloth with wedged strip weld on reforming reactor

  3. 在利用ANSYS分析软件对重整反应器扇形管进行结构力学分析时,用正交各向异性板理论简化扇形管模型非常必要。

    It is very necessary to simplify the platforming reactor scallop model using the orthogonal-stiffened plate theory when analyzing the mechanics performance of scallop by utilizing ANSYS analysis software .

  4. 针对连续重整反应器,分别采用改进算法的BP神经网络、PLS-BP神经网络和小波神经网络建立重整产品液收率软测量模型。

    Three soft sensing models based on improved BP artificial neural networks ( ANN ), PLS BP ANN and wavelet ANN respectively , have been established for liquid yield of reforming products .

  5. 研究结果表明,在蒸汽与甲烷中的碳比例一定时,蒸汽重整反应器内的反应速率和它出口处CO的浓度,随甲烷的流量的增加而提高。

    The paper describes the fact that the ratio of steam to carbon in methane is constant , the reactivity in the steam reforming reactor and the CO concentration at the outlet of the steam reforming reactor will rise with the increase of the flow rate of methane .

  6. 重整反应器扇形管变形损坏机理及对策研究

    Research on the deformation mechanism of catalytic reforming reactor scallop and countermeasures

  7. 重整反应器扇形管有限元简化模型的建立与分析

    Establishment and Analysis on Finite Element Simplified Model for the Platforming Reactor Scallop

  8. 重整反应器内焦炭的形成及其机理探索

    Coke Formation and Its Mechanism in Naphtha Reforming Process

  9. 600kt/a连续重整反应器试制简介

    An Brief Introduction to the Fabrication of 600kt / a Continual Reform Reactors

  10. 十七集总催化重整反应器的稳态模拟

    Steady state simulation of a catalytic reforming reactor using a 17 - lumped kinetics

  11. 连续铂重整反应器中心管国产化

    Domestication of center tube of continuous reforming reactor

  12. 连续催化重整反应器结焦含量软测量

    Coking Models of Reactor in Continuous Catalytic Reforming

  13. 连续重整反应器结焦问题探讨

    Probing into Coking Troubles in Continuous Reforming Reactors

  14. 催化重整反应器的模拟研究

    Study on kinetic simulation of catalytic reforming reactor

  15. 基于有限元理论的重整反应器扇形管力学性能分析

    Analysis on mechanical properties of scallop tube of reforming reactor based on finite element theory

  16. 同时,成功开发了包括开工、工和正常操作的重整反应器动态仿真培训模型。

    The dynamic simulation model of reforming reactor include start , shut-down and normal operation are developed .

  17. 旧重整反应器的修复

    Renovation of old reforming reactor

  18. 介绍了金陵分公司炼油厂重整反应器约翰逊外网的损坏情况及造成的危害。

    The failure situation and caused damage of Johnson outer meshes reforming reactor for Jinling company refinery were recommended .

  19. 对连续催化重整反应器结焦含量软测量问题进行了研究。

    In this paper soft sensing on coking models of reactor in the process of continuous catalytic reforming is studied .

  20. 重整反应器扇形管正交各向异性板模型的建立及有限元分析

    Foundation of the Model of the Orthogonal Anisotropic Plates of the Scallop Tubes of Reforming Reactors and Their Finite Element Analysis

  21. 它既有催化重整反应器的优势,又有蓄热体的优势,可以利用蓄热体的快速换热性质,快速地产生氢气,是一种新型氢发生器。

    And it can fleetly generate hydrogen by using regenerative heat exchanger of high temperature . It is a new hydrogen generator .

  22. 结果表明:各项性能指标均满足常见的加氢类设备技术要求,可用于制造板焊式加氢重整反应器等临氢设备;

    The results showes that the performance index can meet the demand of common hydro-device , and the steel plate can be used to manufacture panels-welded hydro-device equipment .

  23. 由于稳态模拟对于动态模拟的开发具有重要意义,因此本文又进一步建立了十七集总的重整反应器稳态模型,该模型比十六集总稳态模型更精确,更有利于准确预测汽油辛烷值。

    Because steady state model is very important to impolder the dynamic simulation , the steady state simulation of catalytic reforming reactor with seventeen lumped components was established in this paper .

  24. 反应催化剂中的氯化物会随原料、补充的氢气(尤其是当重整反应器中的气体不够纯净的时候)以及水洗水进入系统。

    Chlorides enter the system with the feed , from the reactor catalyst , with make-up hydrogen , especially if un scrubbed reformer gas is used , and with the wash water .

  25. 介绍了国内首台自行设计和制造的立式重叠重整反应器的主要技术参数、设备结构、材料选用及制造技术等。

    The main technical parameters , structure , material selection and fabrication process for 4 reactor stack in reforming process unit are described , which is the first set designed and fabricated in China .

  26. 数值研究车载甲醇重整制氢反应器

    Numerical Simulation of Reactor for Methanol Steam Reforming in Automobile

  27. 重整制氢反应器的种类和研制进展

    The species and research progress of reactors for reforming hydrogen

  28. 重整径向反应器布气系统的流体力学行为及其优化设计

    Hydrodynamic behavior of the gas distribution system in radial flow moving-bed reactor

  29. 连续重整装置反应器约翰逊网失稳分析及制造与安装

    Analysis of Out-of-stable of Johnson Net of Continuous Reforming Unit Reactor and Installation Technique

  30. 甲醇水蒸气重整微型反应器催化剂涂层的研究

    Steam Reforming of Methanol over a Coated Catalyst