静置时间

详细研究了搅拌时间、转速及静置时间等因素对液液平衡的影响，优化最佳条件。

The effect of process parameters , such as the stirring time , stirring velocity and setting time were investigated and the optimum operation parameters were achieved .

样本处理后静置时间对HBV-DNA荧光定量PCR的影响

Effects of Standing Time for Disposed Samples on HBV-DNA Fluorescent Quantitative PCR

结果表明：进料液的静置时间为3h时，Zn2+在SDS胶团上的吸附达到平衡状态。

The Zn2 + adsorption to SDS micelle reached equilibrium after 3h .

最适宜的条件为加热温度60～80℃，静置时间不少于1h。

Optimum conditions include heating temperature 60 ' - 80'C and standstill time no less than 1 h.

应用Stokes公式模拟了夹杂物沉降距离与静置时间的关系，分析了影响夹杂物沉降速度的因素。

The relationship between deposition distance and time is simulated by Stokes equation . The influence factors of deposition velocity of inclusion are analyzed .

通过人工神经网络（ANN）方法预测了火灾后考虑不同受火温度、静置时间、冷却及冷却后的养护方式三种影响因素的混凝土抗压强度；

Concrete compression strength was predicted by Artificial Neural Network ( ANN ) considered three factors , such as temperature , standing time and cooling and curing process after cool .

亚丙脒在室温下的静置时间为9h。

Standing reaction time 9 hours at room temperature .

对EDTA容量法测定水中硫酸根时，对加入沉淀剂后样品静置时间对测定结果的影响进行了研究。

This paper discusses the effects of sample resting when precipitating agent is added on experiment results by using EDTA volumetric method for the determination of SO2-4 in water .

Plackett-Burman试验结果表明聚合物分子量对体积比有高度显著的负影响，而细胞浓度、电解质、静置时间及pH值无显著影响。

Results from Plackett-Burman design presented that the molecular weight of PEG and DEX had highly significant and negative effects on volume ratio while cell density , electrolytes , settling time and pH were insignificant .

结果表明：对半固态AZ91D镁合金组织结构的影响主次顺序为：搅拌速度、静置时间、浇注温度、搅拌时间；通过试验得到了最优的工艺试验参数：搅拌速度500r/min；

The results show that stirring speed is the main factor to influence the semisolid magnesium alloy microstructure , the optimum parameters are obtained by orthogonal experiment .

论文研究结果表明：在熔铸过程中，把合金熔体搅拌过程和熔体静置时间延长，用少量的CaF2参与做覆盖剂，可以生产出密度较低，强度和塑性都较高的镁锂合金；

The results indicate that it is favor of improving the strength and ductility with lower density at the condition of enhancing the stirring and prolonging the time before casting and using CaF2 as the flux cover .

试验中，当处理后出水的静置时间达到30min时，杀菌率可达到99.99%。

In the experiment , when the static duration of the effluent water after the treatment was 30 min , the sterilization rate could reach 99.99 % .

反萃最佳条件：相比1.0，反萃时间10min，静置时间30min。

The reverse extraction optimum condition : phase ratio is 1.0 , the time of reverse extraction is 10 minutes , the standing time is 30 minutes .

主要研究了温度、静置时间、浮充电压、浮充时间等对AGM系列电池的电导/内阻的影响；

The influence of temperature , storage time , float charge voltage , float charge time and so forth on the conductance / internal resistance of AGM VRLA batteries was mainly studied in this paper .

结果表明，随着电场强度的加大、处理温度的提高、离子强度的增大、处理时间和PEF处理后静置时间的延长，蛋白质和核酸的提取率增加。

The results showed that the liberation of protein and nucleic acid increased with the increasing of the electric fields intensity , treated temperature , ions concen - tration , prolonged treatment time and the time after pulsation .

化成前电池的静置时间应当大于8h；电池在3.0V之前采用小于0.01C的化成制度；

Before formation the battery should be placement 8 hours and the system of formation must be less than 0.01C before the voltage reach to 3.0V ;

菌液与含铜废水混合后的静置时间为5min时，去铜率即可达50%，最佳菌种添加量为2.85×109个/L含铜废水。磁场在高温下对菌株生长仍具有促进作用。

The copper removal rate achieved 50 % as the experiment run for 5 minutes and the magnetic field is still helpful for the growth of strains even at the higher temperature .

当超声波作用时间不少于20min，超声作用后溶液静置时间不少于60min时，100mL的强极性溶剂DMAc可以分离14.6g正极材料。

When ultrasonic treatment time was not less than 20 min and holding time was not less than 60 min , cathode materials of 14.6 g was able to be segregated by using 100 mL DMAc organic solvent .

结果：甲硝唑注射液的最佳制备条件是：注射用水温度80℃，静置时间为15min，活性碳用量为0.025%。

Result : The best preparing condition of metronidazole injection was : the water temperature of injection was 80 ℃; the standing time was 15 min ; the quantity of active carbon was 0 . 025 % .

试验发现，氩气的除气效果好于氮气的除气效果，浮游法除气后的最佳静置时间为30min左右，铝熔体的最佳浇注温度为680～685℃。

The experimental results indicate that the degassing effect of Ar is better than the one of N2 , the best holding time after the degassing gases using the blister flotation method is about 30 min , the best pouring temperature of aluminum melt is 680 ~ 685 ℃ .

不同静置时间对面包品质影响的研究

Study on the Affects of Different Quiescent Time on Bread Quality

血标本静置时间对常规生化检验结果的影响

Impact of Laying-aside Time of Blood Sample on Routine Biochemical Laboratory Results

静置时间、可见光对紫外线消毒器出水中细菌的影响

Effect of Static Duration and Visible Light on Bacteria in Effluent from Ultraviolet Sterilizer

沉降颗粒含量随着静置时间的延长而增加；

The content of the sedimentation particle increased with the extension of the settling time .

同时研究了碱溶液浓度，反应温度，静置时间对分离效果的影响。

The effects of the different bases , concentration , temperature , holding time were investigated .

静置时间为3小时，澄清效果基本不再变化。

With the lag of time , the effect becomes better , and after 3 hours is steady .

晶化时间、反应前静置时间和表面活性剂对晶体形貌影响极大。

Reaction time , the standing time and structure-directing agent had a great impact on the crystal morphology .

结果表明：机制砂与河砂泌水率随静置时间成对数关系变化；

The result shows that the bleeding rate of manufactured-sand and river-sand changes in logarithm relation with stewing time ;

分离次数是影响蛋壳收率的主要因素，静置时间及粉末细度次之，影响因素最小的是搅拌时间。

The times of separated is the main factor effected the yield of eggshell , and the minor one is milling time .

讨论了萃取温度、静置时间、溶剂配比和絮凝剂对分离效果的影响。

The influence of extraction temperature , static placing time , solvent burden ratio and flocculating agent on separation effect were discussed .