黏结剂

  • Adhesive;【机】binder
黏结剂黏结剂
  1. 氟橡胶F(2314)黏结剂的热分解动力学

    Thermal Decomposition Kinetics of F_ ( 2314 ) Bonder

  2. 目的:评价自酸蚀黏结剂Ⅰbond在不同涂擦方式下对离体牙牙本质通透性的影响。

    Objective : To evaluate the influence of self-etching adhesive I bond on the permeability of dentin with different brushing ways in vitro .

  3. 无机黏结剂C颗粒经24h的水浸泡后,其崩解率为6.1%;

    After 24 hours ' wet steep , the granular disintegration rate of mineral binder ( C ) was 6.1 % ;

  4. 通过对相关函数g(r)分析,揭示了各黏结剂与ε-CL-20之间相互作用的方式。

    By the pair correlation function g ( r ) analysis , the manners of interactions between the binders and ε - CL-20 are revealed .

  5. 无黏结剂5A分子筛吸附分离正构烃的结焦失活

    Coking deactivation of binderless 5A molecular sieves used in adsorption for normal hydrocarbons

  6. Nafion是催化剂层中良好的黏结剂和质子传导载体。

    Nafion was used both as a good binder and proton conductor in the catalyst layer .

  7. Alloyprimer可以显著提高纯钛和贵金属与黏结剂的黏结强度,而对钴铬合金和镍铬合金则不明显。

    Alloy primer can significantly increase the shear bond strengths of pure titanium and precious alloy , while it cannot increase the shear bond strengths of Co-Cr and Ni-Cr alloy .

  8. 结果表明,在不同升温速率的TG曲线上,F2314黏结剂热失重的起始温度大致相同,而结束温度随升温速率的增大而升高。

    The results show that the initial temperature of F_ ( 2314 ) bonder on TG curves are approximately same , the final temperature increases with increasing the heating rate .

  9. PVA(聚乙烯醇)改性淀粉黏结剂B作为有机复混肥造粒黏结剂,能明显延缓颗粒肥中NH4+-N、全氮、全磷和全钾释放速率。

    Especially the starch adhesive B modified with PVA ( Polyvinyl Alcohol ) was able to distinctly delay the release speed of NH ~ + _4-N , total nitrogen , total phosphorus and total kalium in granule fertilizer .

  10. 目前,市场上销售的绝大部分中密度纤维板(MDF)在生产过程中都使用脲醛树脂胶(UF)或酚醛树脂胶(PF)作为黏结剂。

    Currently , the vast majority of medium density fiberboard sold in the market using urea-formaldehyde resin ( UF ) or phenolic resin ( PF ) as the binder .

  11. 试验结果表明,采用有机黏结剂CC的含碳球团在800℃下保温1h,球团仍能保持较高的高温强度(30~40N/球)。

    The results show that the pellets using organic binder " CC " will continue to have higher strength of 30 ~ 40 N / pellet at 800 ℃ for 1 hour .

  12. A组:FL-Bond自酸蚀黏结剂脱敏;

    Group A : FL-Bond self-etching adhesive system .

  13. 最后加入50g无机试剂M,充分搅拌0.5h,得到性能优良的纸浆黑液气化型煤黏结剂。

    Finally the modified product was mixed with 50g inorganic reagent M and stirred for 0.5 hour . The good quality binder was thus obtained .

  14. 结论:新型牙本质黏结剂具有轻微的细胞毒性,UB对牙髓组织的影响还有待进一步研究。

    CONCLUSION : The new adhesive had slight cytotoxicity . Further study on the influence of the new dentin bonding agents towards pulp tissue must be taken .

  15. 用晶化的硅酸铝短纤维作增强体,用磷酸铝作黏结剂制得预制体,用AZ91D作基体金属,通过挤压浸渗工艺制备镁基复合材料。

    A magnesium alloy matrix composite was fabricated by squeeze cast with the preform made of crystallized aluminum silicate short fibers as reinforcement and aluminum phosphate as binder .

  16. FOX-12改性双基推进剂只有一个分解峰,表明FOX-12和双基黏结剂(NC、NG等组分)一起分解。

    There is only one exothermic peak of FOX-12-CMDB propellant , showing that FOX-12 and double base binder ( NC and NG , i.e. ) are decomposed at the same time .

  17. 通过选择合适的催化剂二月桂酸二丁基锡(T-12)缩短HTPB-TDI黏结剂体系的固化周期;

    A suitable catalyst , dibutyltin dilaurate ( T-12 ) of shortening the curing time of the HTPB-TDI binder system was choosed .

  18. 在峰值速度小于3cm/s时,用黏结剂(粘结厚度小于2mm)或螺栓固定传感器的方法是比较合适的。

    At the peak vibration velocity of less than 3 cm / s , the binders ( with binding thickness of less than 2mm ) or bolts is relatively suitable for fixation of sensors .

  19. 基于水量、糊化温度、糊化剂及交联剂4个因素设计了正交试验L9(34)方案,制备糊化玉米淀粉黏结剂,以木材黏结压缩剪切强度评价黏结剂的黏结性能。

    An orthogonal test scheme L9 ( 34 ) was designed considering four main factors , water content , gelatinization temperature , gelatinization agent and cross-linking agent with three levels . The bonding properties of maize starch adhesives were characterized using shearing strength under compression loading .

  20. 通过测定HTPB-TDI黏结剂体系的黏度,评价了加入催化剂和抑制剂方式对浇注PBX黏结剂体系的适用期的影响,找出合适的T-12与HAA摩尔比为4∶1。

    The influence of added way of catalyst and inhibitor on the pot life of casting PBX was evaluated by testing the viscosity of the HTPB TDI binder system . A proper proportion between T-12 and HAA was found to be 4 ∶ 1 .

  21. 纸浆黑液制气化型煤黏结剂研究

    Preparation of Binder for Gasifying Briquettes with Black Liquor from Pulping

  22. 不同釉质黏结剂去除方法对牙面着色影响分析

    Effects of different orthodontic adhesive removing methods on extrinsic dental stain

  23. 新型牙本质黏结剂体外细胞毒性研究

    In vitro cytotoxic study of a new dentin bonding agents

  24. 新型树脂黏结剂对全瓷黏结强度的影响

    Influence of new resin cements on bond strength to ceramic

  25. 改性淀粉黏结剂在复混肥料造粒中的应用研究

    Application of modified starch adhesive in granulation of compound fertilizer

  26. 氢氧化钠水解玉米秸作型煤黏结剂的研究

    Research on sodium hydroxide hydrolysis corn straw as briquette binder

  27. 冶金炉窑用高强型煤黏结剂优配的实验研究

    Experimental research on binder optimization of high-strength briquette used for metallurgy furnace

  28. 陶瓷&树脂黏结剂黏结的研究进展

    Progress on adhesion behavior between composite resin cement and ceramics

  29. 黏结剂组分对型煤热稳定性影响的研究

    Study on components of binder affected to the thermal stability of coal briquette

  30. 钼改性酚醛树脂黏结剂的研究

    Study on Mo - PF Used as Bonding Agent