偏角

piān jiǎo
  • deflection;drift angle;angle of avertence
偏角偏角
偏角 [piān jiǎo]
  • (1) [drift angle]∶船舶航行时纵轴线与航行轨迹切线间的夹角

  • (2) [deflection]∶指示器或指针相对刻度盘零读数的偏转角

偏角[piān jiǎo]
  1. 用“等比分割法”代替总偏角法测设线路平曲线

    Application of Equal Scale Cut Method Replacing General Drift Angle Method into Highway Layout

  2. 带缓和曲线的大偏角长大曲线实用测设方法研究

    A study of practical survey and design method of long curves at large drift angle with smooth sections

  3. 基于GPS的汽车横摆角速度和侧偏角工程测试方法

    Engineering Test Method for Motor Vehicle Yaw Rate and Sideslip Angle Based on GPS Technology

  4. 基于VB的提升钢丝绳内偏角计算与查询系统

    Calculation and search system of inner deflection angle for hoisting steel rope base on VISUAL BASIC

  5. 探讨了导向圆盘直径D、自重W、入土深度H和圆盘偏角θ对机耕船导向性能的影响;

    Effects of disk diameter D , weight W , rut depth H and disk deflection angle θ on steering performance are discussed .

  6. 在VB6.0上开发偏角法和弧距法计算桥梁工作线的应用程序

    Application Development of Calculating Bridge Work-line by Deflection-method and Arc-length-method under VB6.0

  7. 为了保证着陆引导的精度,建立了Kalman滤波器估计系统位置和航向偏角。

    What 's more , the state equation and measurement equation for Kalman filters are constructed to estimate system position and azimuth angle .

  8. 结果:L4椎体椎弓根的横径、内偏角有统计学差异(P0.05)。

    Results : L4 vertebral body pedicle diameter , there is significant difference in angle ( P0.05 ) .

  9. 通过探索有偏角衬底、Al(GaAs)As低温缓冲层和循环热退火等技术的最优条件,在Si衬底上外延生长出了高质量的GaAs材料。

    High-quality GaAs epilayer is obtained by employing the technologies of the tilted Si substrate , optimization the low temperature Al ( GaAs ) As buffer layer and thermal cycle annealing .

  10. 观察组治疗后在畸形症状、掌倾角、尺偏角改善及临床疗效方面较对照C及D组有显著性差异(P<0.05),有统计学意义。

    The observing group , compared with A or B control groups , has remarkable difference on improvement of anomaly , palmaris inclination , angle of ulnar drift and the effect in treatment of colles fracture ( P < 0.05 ) .

  11. L5椎体椎弓根CT测量指标指标中,左侧横径、左侧内偏角、内偏角均值的值有统计学差异(P0.05)。

    L5 vertebral body pedicle CT measure indicators , the diameter of the left , the left inner angle , internal angle difference between the mean values are significant ( P0.05 ) .

  12. 用低速风洞测力试验和襟翼处绕流的PIV测量试验研究锯齿形格尼襟翼在不同偏角下的增升效益。

    Force and PIV local flow measurements were conducted in a low speed wind tunnel to study the effectiveness of serrated Gurney flap at different deflections .

  13. 重点完成了弹头偏角控制原理的分析和基于FLUENT的气动力学特性仿真,在充分考虑各模块合理布局的基础上设计加工了灵巧弹药样机。

    Key completed the principle of deflectable nose control analysis and aero dynamics simulation in fluent , designed the prototype of smart munition on the basis of considering layout of each module .

  14. 适应式PID算法是根据船舶航行时的天气、海况、负载及航偏角大小改变PID比例、积分、微分系数以适应船舶航行需求;

    The algorithm of adaptive PID can change the coefficients of proportional , integral and differential gains according to the condition of weather , sea states , loading and the heading error so as to suit the demands of ship 's navigation .

  15. 分别在标本组、对照组和实验组的CT片上测量术前及术后椎弓根螺钉钉道的水平偏角,与解剖学的椎弓根e角数据比较,并进行统计学处理。

    The preoperative and postoperative level angle of screw track of the pedicle in CT films in the specimen group , the control group and the test group , were compared with e angle of the pedicle in the anatomy and analyse them in statistics .

  16. 地堑的走向一般为N60°E左右,相对于冲绳海槽的走向更偏向于东西方向,偏角在15°左右。各段中央地堑是被NW向断裂错开的。

    The striking direction of central graben is N60 ° E roughly , that is 15 ° more to the east comparing to the striking of the Okinawa Trough .

  17. 利用检偏角的变化,对布儒斯特显微镜(BAM)图像像素点所代表分子簇的极化倾角和取向方位角进行了参数估计。

    This ( paper ) presented a parameter estimation technique of polar tilt angle and azimuthal orientation angle of BAM images according to the variations of analyzer angles .

  18. 方法随机选取30例成人尸头进行CT扫描,对前鼻棘至眶尖部各结构的距离、侧偏角、视神经管及眶上裂各径线长度、毗邻关系等进行断层影像解剖观测。

    Methods A CT scanning was done for 30 adult cadaveric heads . The distance and angle of the lateral deviation from anterior nasal spine to the varial structures of the orbital apex , structures and the adjacent relationship of optic canal walls and the superior orbital fissure were measured .

  19. 本论文采用CCD摄像机成像技术作为采集手段,利用计算机数字图像处理技术,达到测量汽车前照灯的发光强度,远光中心坐标,近光拐点坐标以及光轴偏角等特征参数的目的。

    The measuring system using planar array CCD as detector is introduced in the paper , it utilizes the computer digital image processing technology , and it can measure the characteristic parameters such as luminous intensity , center of far light , corner of the close light .

  20. 以电子罗盘输出陀螺经纬仪照准部与真北方向的偏角作为反馈信号,DSP处理器进行解算,并利用模糊控制算法控制步进电机的运动,逐步逼近,实现粗寻北自动化。

    The angle between the collimating position of the gyroscope is exported from the electronic compass and true north as the feedback signal to be processed by DSP , and the fuzzy control arithmetic is adopted for control the movement of the step motor to achieve the coarse north-finding automatically .

  21. 本文在利用Voronoi图的分层航迹规划,规划出预定航迹,并利用模糊变增益比例制导律控制导弹的偏角ψV和弹道的倾角θ,实现航迹跟踪。

    This thesis uses fuzzy changing the gain proportion guidance to control the yaw angle ψ v and the pitching angle θ, and to realize following track , with the predetermined track , which had been designed by hierarchical track planning with Voronoi diagram .

  22. 利用SOP(小尺寸封装)芯片的外形轮廓信息,在灰度惯性矩基础上实现了芯片偏角检测。

    Then implement rapid component partition basing it . By means of the grayscale inertia moment theory , this system calculate chip rotation angle through the contour information of SOP ( Small Outline Package ) chips .

  23. 利用流体分析软件FLUENT对切割粉碎流场建模,并在进行数值分析后,得到了最有利于切割粉碎的叶轮形式、刀片偏角,提出了高速切割粉碎设备粉碎物料存在一个经济转速。

    The flow field of cutting comminution is simulated and analysed by computational fluid dynamics software FLUENT . From which we received the impeller form and deflexion angle of blade most in favor of cutting comminution , and proved that the high-speed cutting comminution have a economic rotational speed .

  24. 汉族L4椎弓根的左、右横径及横径平均值均较维吾尔族的横径小;汉族L4椎弓根的左、右内偏角及内偏角平均值均较维吾尔族内偏角大。

    Han left L4 pedicle , the average diameter of the right diameter and smaller diameter than the Uighur ; Han L4 pedicle of the left and right within the inner angle and declination angle averages than those in Uygur large .

  25. 台风波浪数值预报的CHGS法&Ⅱ.台风风场中梯度风摩擦修正系数和风向内偏角的计算

    CHGS METHOD FOR NUMERICAL FORECASTING OF TYPHOON WAVES & ⅱ . Computations of frictional correction coefficient and inner deflection angle of wind direction for the gradient wind in the wind field of typhoon

  26. 本文用模拟方法研究了车辆动力学控制系统(VDC或IVD)。采用闭环的横摆角速度及车辆侧偏角控制,用它们之间的相平面分析确定控制策略。

    In this paper , an Interactive Vehicle Dynamic ( VDC or IVD ) system is studied by simulations , and an effective control algorithm is proposed , which includes closed loop control of yaw rate & slip angle and phase plane analysis .

  27. 在城市桥梁缓和曲线段构造边线测设中,不能设站于ZH点,或设计只有缓和曲线YH-HY段的情况都不能于ZH点用偏角法等方法放样。

    In the course of surveying urban bridge spiral curve structure sideline location , when a station can not be set up in ZH spot , nor is only CS SC in spiral curve designed , method of defection angle can not be used in ZH spot .

  28. 结果表明,水口上下倾角为0、左右偏角60°、侧孔面积为18mm×11mm时,水口的综合性能最佳,能满足熔池布流的要求。

    The results showed that as nozzle up and down inclination is 0 , both sides deviation angle 60 ° and side hole dimension 18 mm × 11 mm , the comprehensive properties of nozzle were optimum and can meet the requirement of feeding liquid steel into bath .

  29. 激光偏角测量技术研究

    A Research on the Measurement of Mirror Deflection Angle with Laser

  30. 飞机平尾偏角故障的自动检测

    Automatic Test of Aircraft Failure in Deflected Angle of Horizontal Tail