干态

gān tài
  • dry state
干态干态
干态[gān tài]
  1. 该传感器响应迅速,灵敏度高,稳定性及选择性好,于4℃干态保存4周,其响应信号基本不变。

    The immunosensor has a fast response time , high sensitivity , good selectivity and stability of about four weeks when storing a dry state at4 ℃ .

  2. 用热重分析这种改性膜在干态时的热稳定性表明,在330℃以下完全稳定。

    The work further extended to study the thermal stability of these modified membranes in a dry state . These modified membranes up to 330 ℃ are stable .

  3. 相量的q形变相干态及其压缩性质

    Q phase coherent states and their squeezing properties

  4. 干态MC经复水后能恢复至冻干前的形态。

    Dried MCs could comeback their original shapes by rehydration .

  5. 在引入q形变技术的基础上,我们研究了q形变相干态的一些压缩性质。

    Using the q-deformation technique , we study the squeezing properties of q-deformed coherent states | α, p 〉 .

  6. 观察SEM照片可见:干态CS/GA鱼油MC基本呈球形,表面为多孔结构,部分MC出现破壁。

    The SEM photographs showed that dried MCs were generally porous spheres , and part of them had break walls .

  7. 通过红外光谱、热失重分析等对样品进行了结构性能表征。测定了样品的吸水率及对干态、湿态CO2的吸附性能。

    The chemical structures and the thermal stability of the fibrous adsorbent and their adsorption characteristics of water , dry CO2 and humid CO2 , was studied .

  8. 研究结果表明:将PA6、PP和PP-g-MAH共混解决了PA6干态下的冲击强度低,吸水率大的问题,但拉伸强度、弯曲强度等力学性能较PA6有所下降。

    The results showed that although addition of PP and PP-g-MAH improve impact behavior and lowers absorption , but the mechanical properties decrease .

  9. 采用干态固定床实验装置系统,研究去除垃圾焚烧炉烟气中HCl气体的主要影响因素及其规律。

    The main influence factors and pattern of removal of gas HCl in flue gas are studied by using the test equipment system of dry fixed bed .

  10. 而壳聚糖含量为60%时,共混膜的干态抗张强度(σd)和湿态断裂伸长率(εw)均达到最大值。

    The starch content in the blend films can improve the mechanical properties of them , the tensile strength values increased by 31.9 % in dry state and 26.4 % in wet state when the chitosan content was 60 % .

  11. 综合力学性能测试表明,材料的拉伸断裂和屈服强度符合工程塑料的要求,干态和湿态下的Izod、Charpy冲击强度得到显著提高,接近国外超韧聚酰胺66工程塑料水平。

    The comprehensive tests of the mechanical properties showed that both the tensile strength at break and yield strength met the requirements of engineering plastics , and the Izod and Charpy impact strength in dry and wet state was obviously improved .

  12. 用做木材黏合剂,在25℃时干态剪切强度为7-53MPa,室温和100℃时用水浸泡不开胶时间达到91-5d和90-6min。

    Used as wood adhesive , its dry shearing strength was 7 53 MPa at 25 ℃ . Immersed in water at room temperature and at 100 ℃, it kept adhesion for 91 5 d and 90 6 min respectively .

  13. 力学性能实验测得当羧丁酰壳聚糖的含量为30wt%时,共混纤维的干态抗张强度达到最大值,为14.32cN/tex,纤维的湿态抗张强度随着羧丁酰壳聚糖含量的增加而降低。

    Tensile test showed that the dry fiber tensile strength of blend fibers achieve maximum value for 14.32cN/tex when the the content of D-carboxymethyl chitosan was 30wt % . The wet tensile strength of blend fibers decreased with the increasing of the content of D-carboxymethyl chitosan .

  14. 秸秆覆盖对干态和湿态土壤产流过程的影响

    Effect of Straw Mulch on Runoff Yield Process of Driest and Wettest Soil

  15. 随着温度的增加,干态及耐水强度呈现减小的趋势。

    As the temperature increases , intensity of dry and water show a decreasing trend .

  16. 水润滑时材料磨损量增加,油润滑时磨损量较小,干态时磨损量最小。

    Under oil lubrication the composite 's wear was less , but more than under dry lubrication .

  17. 油润滑时试样的摩擦系数和体积磨损均介于干态和水润滑之间;

    Both friction coefficient and bulk worn loss of the samples under oil-lubrication test situation are the midst .

  18. 人们致力于开发干态聚合物电解质和含液聚合物电解质两大体系。

    Researchers are doing some R & D work on solvent-free polymer electrolytes and polymer electrolytes containing solvent .

  19. 干态微粒散落检测仪是用于评估无纺布在干燥状态下微粒散落倾向的检测仪器。

    The test instrument of dry linting is for evaluating the linting tendency of nonwoven in the dry state .

  20. 差别化柞桑弹力真丝在干态下的弹性伸长变形明显提高,在湿态下趋向稳定。

    Its elastic extension deformation is obviously improved in dry condition , but tends to be stable in wet condition .

  21. 干态与湿态下头发断裂强度、断裂伸长率之间的差异具有统计学意义。

    There was a significant difference of breaking strength and strain of break of hair fibers between dry and wet state .

  22. 干态断裂强力为普通粘胶的1.5倍,湿态断裂强力则为普通粘胶的2倍;

    The break force of polynosic fiber is 1.5 times of rayon in dry state , and 2 times in wet state .

  23. 在干态时,高强力意味着面料保形性好,可提高纺纱及织造的生产效率;

    In dry condition , high strength means the fabric has good shape relenlion , it can improve spinning and weaving production efficiency .

  24. 因此,纤维素在干态条件下进行交联时,在正常使用条件下,织物会具有折皱回复性和褶皱保持性。

    Therefore , cellulose is crosslinked when it is dry so that it will have crease recovery or crease retention properties under normal use .

  25. 研究表明:干态高速滚齿的顺利进行,需要在切削理论上的全面突破,以及刀具、机床和工艺技术的综合改进。

    Research shows that the realization of dry gear hobbing needs developing the cutting theory , and improves the machine tools , tools and technics .

  26. 综述了近年来干态聚合物电解质的研究进展,包括:(1)以改性聚氧化乙烯-锂盐复合体系为代表的耦合体系;

    There are three kinds of solvent-free polymer electrolytes : ( 1 ) coupled systems represented by the complex of modified polyethylene oxide and lithium salt ;

  27. 当刹车比压和能载增加时,经过不同温度处理的四种试样干态及湿态平均动摩擦系数均相应下降。

    The average dynamic FC of four kinds of samples treated under different temperatures was reduced in dry and damp condition as brake pressure and energy were raised .

  28. 试验结果证明T300/QY9512复合材料在150℃、干态和湿态下,力学性能保持率较高,耐湿热性能好。

    The test results show the mechanical property of T300 / QY9512 composites have high retention rate and good hygrothermal property at 150 C , dry and wet state .

  29. 通过扫描电镜、孔隙率和湿膜电导率,主要考察了成膜工艺中干态处理的环境因素,温度和湿度对所制微孔膜的形态和性能的影响。

    The effects of air-drying conditions ( temperature , humidity and drying time ) on morphology and properties of the microporous membranes have bean investigated by SEM , porosity and conductivity .

  30. 白炭黑吸附于粒子表面,可降低粒子间的液桥力,粒子间距增大,减少粒子的相互粘结,提高铁红颜料粉体在自然干态下的分散性能。

    Precipitated amorphous silica adsorbed on the surface of particles degrades the liquid bridge force between particles and adds the space between particles and reduces agglomeration of particles to improve the dispersion properties of dry powders .