振荡电路

  • 网络VCO;OSC;oscillation circuit;Oscillator
振荡电路振荡电路
  1. 将1kHz振荡电路中的分立元器件用集成芯片代替,使球形聚焦测井信号更稳定;

    Using an integrated CMOS chip to replace the isolated components in the 1 kHz OSC circuit improves the signal stability of the spherically focused logging tool .

  2. RC桥式正弦波振荡电路中反馈深度研究

    Feedback Depth Analysis of RC Sinusoidal Oscillation Circuit

  3. 单运放RC正弦振荡电路系列

    A series of single op amp r C sinusoidal oscillatory circuits

  4. 基于RC振荡电路的冰层厚度测量装置

    Ice layer thickness measurement device based on an RC resonator

  5. 一类非线性振荡电路中的Lyapunov指数分析

    Analysis of Lyapunov exponents in class of nonlinear electrical oscillator

  6. RC桥式振荡电路最大振荡频率的研究

    Study on the Maximum Frequency of RC-bridge Oscillator

  7. 基于MATLAB的RLC阻尼振荡电路仿真分析

    The Simulation Analysis of RLC Damping-Oscillatory Circuits Based on MATLAB

  8. 改进型高稳定度LC振荡电路的研究

    Study on improved LC oscillator circuits with high stability

  9. LC正弦振荡电路在无损检测中的应用

    Application of LC oscillating circuit to nondestructive thickness measurement

  10. 新型无LC元件脉冲振荡电路的设计

    Design of a New Type Non-LC Pulsing Oscillation Circuit

  11. 电容三点式振荡电路的研究与SPICE仿真

    Study on oscillator circuit of three-point capacitance with SPICE simulating

  12. HOPF分叉定理在非线性振荡电路中的应用

    Application Research of HOPF Bifurcation Theorem in Nonlinear Oscillation Circuits

  13. 传统的涡流检测中,通常由LC或RC振荡电路作为信号源。

    The traditional eddy current testing system usually takes LC or RC oscillation circuit as excitation signal source .

  14. 设计了一种电压控制LC振荡器,利用LC振荡电路作为振荡源,通过变容二极管来调节振荡器的频率,采用锁相环来提高输出频率的稳定度,以FPGA+单片机作为整个系统的测控部分。

    This paper presents a voltage-controlled LC oscillator with a phase-locked loop based on FPGA and MCU .

  15. 引用晶体管静态工作点与h参数的关系曲线,分析了静态参量IC、VCE对振荡电路频率稳定、起振、振荡频率的影响。

    The relation curve of static working point and parameter h is introduced in this paper .

  16. 本篇论文的主题是在标准数字CMOS工艺条件下,研究单片集成无线通信系统中本机振荡电路的设计。

    This thesis is about the design of local oscillator circuit for wireless communication system in standard digital CMOS technology .

  17. 一种用于DC-DC转换器的双频振荡电路的设计

    Design of a Dual-frequency Oscillator for DC-DC Converters

  18. 用一个RC振荡电路测量了传感器的振荡频率与相对湿度的关系。

    The relationship between oscillation frequencies and relative humidities was measured with a RC oscillatory circuit for the polymeric humidity sensor .

  19. 场域中的Hopf分岔定理及其在非线性振荡电路中的应用

    Hopf Bifurcation Theorem in the Flow Field and | ts Application to Nonlinear Oscillating Circuits

  20. 一种用Volterra级数分析含多个非线性元件振荡电路的新方法

    A New Algorithm for Analysis of Nonlinear Oscillator with Many Nonlinear Elements Using Volterra Series

  21. EWB在非正弦波振荡电路中的应用

    EWP Application in the Oscillating Circuit of Non - sine Wave

  22. 振荡电路的计算机辅助分析RLC电路的自动测量

    The Computer-Aided Analysis ( CAA ) of Autodyne Automatic Measurement of RLC Circuit

  23. 简述并联振荡电路特点以及感应加热淬火用SCR晶闸管中频电源调谐方法等。

    This thesis sketchs out characteristics of parallel oscillatory circuit and tune means of KGPS applied in Induction quenching .

  24. 在芯片的数字电路中,设计了外部RC环节配合片内环振构成的振荡电路,提供系统时钟、延迟时钟的振荡脉冲。

    In digital circuits , an outer RC circuit , combined with inter ring oscillator obtain series of oscillation pulses for system clock and delay clock .

  25. RC振荡器在集成电路应用领域具有很大的优势,可分为桥式振荡电路、双T型网络式和移相式等类型。

    RC oscillators have tremendous advantages in integrated circuit applications , which be divided into bridge oscillator , double-T type network and other types of phase-shifting .

  26. 本文研究了双向负阻晶体管(BidirectionalNegativeResistanceTransistor,简称BNRT)在张弛振荡电路中的动态伏安特性。

    Experimental investigation was carried out for the dynamic I-V characteris-tics of the bidirectional negative resistance transistor ( BNRT ) in the relaxation oscillation circuit .

  27. 硬件的设计中涉及了各类IC之间的接口,计数器或寄存器与发光二极管的接口,以及直流稳压电源输出和振荡电路输出的接口。

    Hardware involving various IC design of the interface between the counter or register with luminous diode interface , and output DC voltage power circuit and shocks export interfaces .

  28. 运用一阶单时间常数低通函数模拟运算放大器的开环增益,对RC桥式振荡电路进行线性分析,得出最大振荡频率为运算放大器增益带宽积的16.67%。

    The maximum frequency of RC-bridge oscillator is 16.67 % of gain bandwidth product of amplifier analyzed based on a first-order single time constant lowpass function model .

  29. 并根据LC正弦振荡电路基本原理,设计刀具接触传感系统和刀具进给策略,实现对刀具的高精度自动定位。

    According to the basic principle of LC oscillator , the cutter contact sensing system and locomotion strategy are designed to realize cutter location automatically .

  30. 可见在适当的电源电压和温度变化范围内,振荡电路的性能较好,可广泛应用在PWM等各种电子电路中。

    Because of the better performances with the change of appropriate supply voltage and temperature , this Oscillator Circuit can be widely used in many kinds of electronic circuits .