摩擦试验

mó cā shì yàn
  • friction test
摩擦试验摩擦试验
  1. 采用X-光光电子能谱(XPS)仪测定了聚四氟乙烯基固体润滑剂烧结前后、在45钢表面摩擦试验前后,试样表面的元素组成及价态的变化。

    The change of element integrant and valence state was measured using the X-ray photoelectron spectrum ( XPS ) when the PTFE-based bonded solid lubricant was agglutinated and the friction test of the 45 # steel was finished .

  2. 本文描述了一台专用的真空摩擦试验装置,并给出了真空度为10~(-3)托下,PTFE-花岗石、PTFE镀铬铜和PTFE钢球三种摩擦副材料的f-v实验曲线;

    The paper describes a special equipment for vacuum friction test , and presents f-v test curves for combinations of PTFE-granite , PTFE-chromium plating steel and PTFE-steel ball in a vacuum of 10-3 Torr .

  3. 基于单神经元自适应PID的摩擦试验机电惯量系统的研究

    The Research of Electric Inertia System Based on Single Neuron Adaptive PID Controller in Frictional Tester

  4. 结果表明:在AFM摩擦试验中,压电陶瓷的滞后效应和非线性效应的影响比较显著;

    The results indicate that the effect of hysteresis and nonlinear of the piezo-tube are significant on the friction measurement with the AFM .

  5. 本文针对陶瓷基体材料,对CVD金刚石薄膜的沉积工艺、表面形貌、摩擦试验及实际应用进行了研究。

    In this paper , based on ceramic substrates , CVD diamond deposition process , surface topography , tribological properties and practical application will be studied .

  6. 研究非线性K.用力矩模型解释摩擦试验加载过程中的非线性变化

    In this paper , a finite difference scheme for the nonlinear K. THEORETIC STUDIES ON NONLINEARITY IN LOADING PROCESS OF FRICTIONAL EXPERIMENTS WITH MOMENT CONSIDERED

  7. 地质勘察时,宜根据沉降计算的需要,提供地基土的e~p曲线和持力层的基床系数,并提供桩、土直剪摩擦试验结果。

    The engineering geological exploration document should provide the e-p curves of soil , the subgrade coefficient of bearing stratum and the results of direct shear test between the pile and the soil according to the request of settlement calculation .

  8. MPV-1500型摩擦试验机在测量含油轴承摩擦系数和PV值中的应用

    Application of type MPV-1500 friction testing machine for measuring friction coefficient and PV value of oil-impregnated bearing

  9. 本文以Cu粉填充的PTFE基复合材料为下试样,45钢为上试样,在面接触条件下进行摩擦试验。

    In our work , the lower samples were made of PTFE composites filled with copper and the upper samples were made of 45 steel . The contact mode is surface contact during friction .

  10. 利用微摩擦试验机(UMT)测试了粘附阵列的切向粘附性能。

    Finally , use micro-friction testing machine ( UMT ) to have tested the tangent adhesion properties of the adhesion array .

  11. MM-1000摩擦试验机微型计算机系统

    Microcomputer System of MM-1000 Friction Tester

  12. 利用销-盘摩擦试验机测试半降解水凝胶的摩擦系数和连续摩擦性能,并用环境扫描电镜(ESEM)观察摩擦后水凝胶的表面形貌。

    Friction coefficient , continuous friction tested by a ball-plate tribometer and worn surface morphology was observed by Environmental Scanning Electron Microscopy ( ESEM ) .

  13. 通过摩擦试验得出碳纤维板表面摩擦系数可定为0.3.④圆柱型楔形夹具可以有效的对试验CFRP板施加预应力。

    Obtains the carbon fiber board surface friction coefficient through the friction test to be possible the theory to decide as 0.3 . ④ The column wedge-shaped jig may effective to experiment the CFRP board to exert the pre-stressed .

  14. 用球盘式摩擦试验机及原子力显微镜在大气中常温下对YBa2Cu3O7(YBCO)高温超导试样的宏观和微观摩擦学特性进行了研究,并与Cu基固体润滑复合材料进行比较。

    The micro and macro tribology characters of sintered YBa_2Cu_3O_7 ( YBCO ) in the air were investigated by using ball on disc tester and atomic force microscope ( AFM ), and a comparison with Cu based solid lubricant composite was prepared .

  15. 为了计算渠道边坡的稳定性,通过室内摩擦试验测得了SDM材料与基土、混凝土之间的摩擦特性参数。

    For calculating the stability of the slope sides of the channel , the friction coefficients in between SDM , the foundation soil and the concrete are obtained from the indoor test ;

  16. 在MM-1000型摩擦试验机上测试了铜基粉末冶金列车闸瓦材料在不同制动条件下的摩擦磨损性能。

    The experiment is conducted on MM-1000 friction test machine , which tests friction wear property of copper-based train brake materials by powder metallurgy at different brake condition .

  17. 采用Timken摩擦试验机,在不同合成润滑脂润滑下,对热等静压氮化硅工程陶瓷与Mo50钢系统进行了定量试验研究,并采用SEM扫描电镜对磨痕表面形貌进行了定性分析。

    The tribological properties of HIP-Si 3N 4 / Mo50 steel were quantitatively studied by means of Timken Tester under the lubrication of different synthetic Lithium-base greases . The morphology of the Scar is qualitatively analyzed with SEM .

  18. 采用DMS-150型定速式摩擦试验机及材料试验机等对汽车同步器齿环摩擦材料的摩擦磨损性能、胶粘剂拉伸剪切强度、洛氏硬度、抗冲击强度等性能进行了测试;

    The friction and wear behaviors , adhesive tensile shearing strength , Rockwell hardness , impact strength of automotive synchronizing ring friction material had been examined by DMS-150 constant speed friction tester and material tester .

  19. 给出了平面轴承滚动摩擦试验方案。

    It provides the testing program of planar bearing rolling friction .

  20. 纳米添加剂铁路轴承润滑脂摩擦试验数据分析

    Analysis of Friction Experiment Data of Nano-additive Railway-bearing Lubricating Grease

  21. 阵列微凹坑超声复合电加工及摩擦试验

    Ultrasonic Combined Electrical Micro-machining and Friction Test for Array Micro-pits

  22. 板材成形拉延摩擦试验机系统设计与实践

    Design and application of drawing-friction testing system used in sheet metal forming

  23. 文中介绍了现场锚固力测试与摩擦试验的结果。

    The results of field tests of anchorage and frictional force are given .

  24. 四球摩擦试验机新型液压加载装置的设计与应用

    Design and Application of New Hydraulic Loading Device for Four-Ball Friction Testing Machine

  25. 土工织物直剪摩擦试验研究

    Study of Direct Shear Friction Test of Geotextiles

  26. 花岗岩三轴摩擦试验

    Testing frictional experiment of granite using triaxial equipment

  27. 往复式摩擦试验机运动机构设计

    Design of Mechanism of Reciprocating Friction Test Machine

  28. 多功能摩擦试验机的研制与应用

    Development and Application of Multifunctional Wear Testing Machine

  29. 高速往复式摩擦试验机

    High speed reciprocating friction testing machine

  30. 汽车轮胎橡胶摩擦试验研究

    Experimental research on vehicle tire rubber