测试探针

cè shì tàn zhēn
  • test probe
测试探针测试探针
  1. 而且如果使用本半导体测试探针,由于针尾部的特殊结构,我们可以将整个针模组放入超声波清洗机中清洗。

    Moreover , in order to clean the semiconductor test probe , the probe module group as a whole , due to the special structure of the tail part of the probe , can be placed into an ultrasonic cleaner .

  2. 本实用新型涉及一种半导体测试器件,尤其是半导体测试探针。

    The utility model relates to a semiconductor test device , in particular to a semiconductor test probe .

  3. 把测试探针连接到插头1和2,并记下欧姆表读数。

    Attach test leads to pins 1 and 2 and note ohmmeter reading .

  4. 测试探针是航空发动机内部工作状态的重要测试工具,主要用于测试发动机内部振动、气流温度、流速、压强的参数。

    The developments of the aero-engine testing probes are the main tools to test the conditions in the inner turbulent flow .

  5. 笔者论述了电弧加热器变参数运行的技术原理、试验设备改造、测试探针研制及原理性试验等。

    The author discussed the technique principle of the transient ablation technique in arc heater , and the experiment equipment reforming the prob production and the primary experiment etc.

  6. 用于微控制器晶片测试的探针卡

    Probe Card Used in Wafer Test of Microcontrollers

  7. 两种薄层电阻测试系统探针游移误差的对比分析

    The Contrasting and Analyzing of Probe Movement Error about Two Kinds of Measurement System of Sheet Resistance

  8. 能谱测试发现探针分子中含有稀土元素,说明稀土元素确实被掺入到探针分子中。

    EDS testing showed that analysis of probe molecule component found the rare earth elements that were doped in the probe molecules .

  9. 测试了探针PAHPN在不同极性溶剂中的紫外吸收光谱、荧光发射光谱、荧光量子产率、荧光寿命以及双光子性质,结果显示PAHPN光物理性质对环境极性敏感。

    Fundamental photophysical properties are also studied including absorbance and fluorescence spectrum , fluorescence quantum yield , fluorescence lifetime and two-photon absorption section in different solvents . The data exhibits its sensitive to the polarity of solvents .

  10. 导电原子力的测试结果说明探针与Pt薄膜之间属于欧姆接触。

    Test results of C-AFM shows that the probe and Pt thin film belong to the ohmic contact .

  11. MCM基板互连测试的单探针路径优化研究

    Research on single-probe traversal optimization for testing of MCM substrate interconnections

  12. 分析了在三种测试方式下探针的信号波形,通过比较,选择了其中两种测试方式进行测速实验。

    The probe voltage signal is calculated in three different measurement ways and two of them are adopted in experiments .

  13. 对熔敷层的组织观察、硬度测试、电子探针分析、磨损及冷热疲劳试验结果表明,材料的表面性能,包括硬度、耐磨性、抗冷热疲劳性能等都得到了很大地提高。

    The results show that the surface properties of the steel including hardness , wear resistance , heat cycle fatigue resistance are improved markedly .

  14. 连接测试设备和探针的导线来回的传递测试信号。针对这些测试数据的衡量基准,一直都有些误解。

    Wires running from the tester interface to the probes carry test signals back and forth . There have been some misunderstanding on these measurements .

  15. 前者为测试人员插入探针函数的程序框架,后者则是黑盒测试和白盒测试的应用。

    The former is a framework in which testers insert the probe functions and the latter is an application of the black box test or the white box test .

  16. 通过对HIV-1subtypes的测试显示,探针选择过程中需要计算的探针数目减少到候选探针数目的1/10,这充分说明了算法的有效性。

    When the algorithm is applied to the test data of HIV-1 subtypes , the result shows that the number of probes , which require calculating in the process of selecting probes , is reduced to the tenth of candidate probes , As can prove the algorithm is effective .

  17. 在传统的流场测试手段&多孔探针结合压力扫描阀的测压方法和热线风速仪等的流场校测的基础上,采用PIV方法对风速均匀性和风攻角等进行了校测。

    Based on the traditional flow field validation , which is the combination of pressure measuring method using parallel pitot tube plus pressure scanner system and velocity measurement method using hot wire anemometer , the velocity uniformity and wind attack angle are checked using PIV method .

  18. 研制了用于扫描近场光学显微镜的新型有源光纤探针,采用熔拉法和腐蚀法相结合,制作出掺Er3+光纤探针,实验测试了这种光纤探针的放大的自发辐射。

    A new active fiber probe used for scanning near field optical microscope ( SNOM ) is successfully fabricated . In combination of fused pulling with chemical etching , an Er 3 + doped fiber probe is produced , whose amplified spontaneous emission is tested experimentally .

  19. 测试结果给出了探针的强度和阻抗特性。

    The test result shows the performance characteristics of the probe .

  20. 在代理组件系统环境中执行测试用例时,探针会记录测试用例的方法执行信息,并保存在日志文件中。

    When the test suites executing in proxy component system , the probes record the invocation sequence of each method in a log file .

  21. 为了探明这一问题,这两位研究者给208位大学生做了一连串的电车测试并以四探针测试仪那样的精细程度检测他们反应的实用主义程度几何。

    To find out , the two researchers gave 208 undergraduates a battery of trolleyological tests and measured , on a four-point scale , how utilitarian their responses were .

  22. 目前探针测试仪采用多探针法测量电参数的方法应用比较广泛,而传统的探针测试仪测量效率较低、精度低和测量的参数较少。

    Currently , the multi-probe method is widely used to measure parameters , while the traditional probe station measure objects with the disadvantages of lower efficiency and accuracy , and also measure less parameter .

  23. 本课题将图像识别技术监控四探针测试微区的探针调整、定位问题,利用程序驱动步进电机自动定位以加速测试进程;

    To achieve supervising the four point probe adjustment and location in the micro-area by the image identification technique , a procedure was applied to drive the step-run motor to locate the probes automatically , so the measurement procedure was accelerated .

  24. 主要研究工作包括:1.构建了能对微探针性能与寿命进行自动测试的实验系统,该系统能实现压缩过程中对微探针电阻的高精度测试和对微探针压力的精确测试。

    The main research work includes : 1 . Constructed an experimental system can automatically test the performance and life of the microprobe , the system can achieve accurate testing for micro-probe resistance and pressure in compressing process .

  25. 进行类内方法测试时,将测试点分为四种,并分别论述适用于每种测试点位置的探针函数的设置。

    During the method testing inside the class , the testing points are divided into four kinds and the installation of each probe function which matches the location is discussed .