液相分离

  • 网络liquid phase separation;liquid-liquid phase separation
液相分离液相分离
  1. 通过电子显微镜观察了乳浊分散相的形貌,说明玻璃乳油是由液相分离引起。

    It is indicated by the morphology of the disperse phase under electron microscope that the opacity of glass is due to liquid-liquid phase separation .

  2. Al-In难混溶合金的液相分离过程及显微组织数值模拟

    Liquid-liquid Phase Separation Process and Numerical Simulation of Microstructure of Al-In Immiscible Alloys

  3. 液相分离球滴微相粒度分布的X射线小角散射研究方法

    An analytical method of small-angle X-ray scattering for determining the particle size distribution of liquid phase separation structure

  4. 主要工作有:(1)以制备液相分离柚皮苷和新橙皮苷为研究对象,建立了色谱分离的平衡驱动模型(ED模型)。对于其中吸附等温线的测定,本文采用了由G。

    First , an equilibrium-dispersive ( ED ) model was used to describe the chromatographic separation of Naringin and Neohesperidin .

  5. 随着冷却速率的增大,液相分离被抑制,晶粒尺寸变小,富(Pb)相分布更趋均匀。

    With the rise of cooling rate , the liquid separation is suppressed , the grain size decreases , the distribution of Pb-rich phase is more uniform .

  6. 从经典的形核理论出发,并结合采用MonteCarlo方法,给出了二元体系两液相分离过程的二维模型,其中包括形核、扩散及生长三部分。

    With the classical Nucleation theory and the combination of Monte Carlo method , the two dimensional model of liquid phases separation for binary system is present .

  7. 为了提高铝合金的表面强度,根据铜合金的液相分离性质,采用CO2激光熔覆方法在铝合金表面成功制备了铜基合金涂层。

    According to the liquid separation property of Cu-base alloy , the Cu-base coating is obtained on the aluminum alloy by CO2 laser cladding for improving the surface strength of aluminum alloy .

  8. M-Cu(M:Fe,Co)合金亚稳液相分离时液相间的界面能

    Interfacial Energy between two Liquids of Metastable Miscibility Gap in M-Cu ( M : Fe , Co ) Alloys

  9. Zn-Pb合金液相分离机制研究

    Investigation on liquid - liquid phase separation mechanism in Zn-Pb alloy

  10. 新的蛋白质组学技术如激光捕获显微切割(LCM),串联质谱、二维液相分离-质谱鉴定等加速了乳腺癌研究的进展。

    The research of breast cancer will be developed more quickly by means of newer proteomic technologies such as laser capture microdissect ( LCM ), tandem MS and 2D-LC-ESI-MS , etc.

  11. 研究得出,重力分离SHS合成过程经历燃烧合成、液相分离和陶瓷凝固三个基本过程,陶瓷层致密化贯穿于三个过程之中;

    It was obtained that synthesis process underwent three basic processes in the consequence of combustion synthesis , liquid liquid phase separation and ceramic solidification , and densification of ceramic layers run through the three processes .

  12. 利用Cu与Fe具有液相分离特性,以及母材与堆焊材料的冶金反应,采用聚焦光束堆焊制备了Fe3Si弥散分布的铜基合金复合堆焊层。

    Based on liquid separation characteristic between Cu and Fe , and the reaction within base metal and the surfacing material , the copper matrix composite coating dispersed with Fe_3Si reinforcement was obtained by light beam surfacing .

  13. 熔覆层金属较快的冷却速率导致液态金属发生Fe-Cu液相分离,从而形成富Fe颗粒相,随送丝速度的增大,球状富Fe颗粒相的半径增大,数量先增多后减少。

    The fast cooling rate of cladding metal led to the separation of Fe and Cu and the formation of Fe-rich particles . The radius of the Fe-rich particles rose and the quantity rose and then decreased with the increase of feeding speed .

  14. 结论:利用高效液相分离得到的蜂毒多肽BVI2具有一定的抗炎作用。

    Conclusion : BVI2 isolated by HPLC is a main component of anti inflammation of bee venom .

  15. 方法分别用溶剂浇铸/致孔剂溶出法、固-液相分离法、液-液相分离法,制得了PLLA的多孔支架,测定其孔隙率及平均孔径,并观察其微观结构。

    Methods The PLLA scaffolds were fabricated by solution casting / porogen leaching method , solid-liquid phase separation method and liquid-liquid phase separation method . The porosity and average pore diameter of the PLLA scaffold were measured and microstructure of the scaffolds was observed .

  16. C0在40~70%Cu成分范围内,液相分离被抑制,凝固组织呈现出明显的分区结构&辊面细晶区和自由面粗晶区。

    In the composition range of 40 ~ 70 % Cu , the phase separation is suppressed , solidification microstructure displays obviously tow kinds of crystal zones : fine crystal zone near wheel surface and course crystal zone in free surface .

  17. 钛硅分子筛/纳米碳纤维催化剂的制备及其液相分离性能

    Synthesis and separation properties of titanium silicate supported on carbon nanofiber

  18. 水采硝液相分离技术

    Liquid - phase separation technique of the aqueous solution mining mirabilite

  19. 研究结果表明:退火后的原始玻璃已存在液相分离结构。

    The results show that the parent glass is already two-phase separated .

  20. 应力场下固-液相分离制备微孔聚丙烯中空纤维膜

    Hollow Fiber Microporous Polypropylene Membranes Prepared from Solid-Liquid Phase Separation in a Stress Field

  21. 一些试样的釉还发生了第二次的二液相分离,其孤立相微滴的尺寸<100(?)

    Secondary phase-separation also occurs in some glaze samples with discrete droplets less than 100 (?)

  22. 液相分离及联用技术在药物分析和化妆品中限用禁用物质分析中的应用研究

    Application of Liquid Separation with Multiple Detection in Analysis of Pharmaceutical Preparations and Cosmetics Safety

  23. 蛋白质组学研究中的多维液相分离系统

    Multidimensional liquid-phase separation system in proteome research

  24. 根据液相分离技术,制定了甘肃高台县盐池芒硝无机盐伴生矿床的溶采方案。

    Based on the liquid-phase separation technique , the author designed a whole solution mining for multi-component mirabilite deposit .

  25. 本文介绍了泥浆快速聚沉而迅速使其固相与液相分离的简便方法。

    In the paper , simple method used to coagulate mud quickly and to separate water from mud is introduced .

  26. 将人工神经网络法应用于抗菌药物高效液相分离条件的优化。

    The artificial neural networks ( ANN ) was applied to the gradient separation of7 antibacterial agents in mixture by HPLC .

  27. 介绍了柴油生物脱硫机理、生物反应器及乳化液相分离,特别是生物催化剂等方面研究的最新进展。

    The new progress in diesel oil biodesulfurization , including bioreaction mechanisms , bioreactor , separation technology , especially biocatalysts was introduced .

  28. 首次发现钧釉有两液相分离的穿插结构和第二次液相分离的现象。

    It is found for the first time that there are interpenetrating phase-separation structure and secondary phase-separation phenomenon in the Jun glaze .

  29. 本文对无机膜的发展与特点,以及无机膜在液相分离和反应领域中的应用进行了综述。

    In present article , developments , characteristics and applications of inorganic membrane in the reaction and separation of liquid phase are reviewed respectively .

  30. 多维液相分离系统具有分离样品动态范围宽、分辨率高、峰容量大、分析速度快、自动化程度高等优点,因而近年来在蛋白质组学的研究中受到了越来越多的关注。

    Multidimensional liquid - phase separation systems with high resolution , high peak capacity , high speed and high automation , have been widely applied into the analysis of proteome .