灯丝

dēng sī
  • filament;filamentary cathode;glower;directly heated cathode;electron-tube heater;filament-type cathode
灯丝灯丝
灯丝 [dēng sī]
  • [filament] 微细的导体(如碳或金属导体),电流通过时将呈现白炽状态

灯丝[dēng sī]
  1. 三极管接法):中Mu小型灯丝结构

    U4 triode connected : Medium MU small mass filamentary heating structure .

  2. 低Mu敷钍灯丝结构

    Low MU Thoriated Tungsten filamentary heating structure .

  3. 电灯光亮来自白热的灯丝

    A fine wire heated electrically to incandescence in an electric lamp .

  4. 灯丝在电灯中电加时成白炽状态

    A fine wire is heated electrically to incandescence in an electric lamp .

  5. 本文以CT机高压发生器灯丝驱动电源为主要研究对象,重点研究并设计灯丝驱动电源。

    This paper is based on High Voltage Generator , focuses on the filament driving power supply .

  6. 热丝CVD法沉积金刚石薄膜用灯丝研究现状及改进

    Research and improvement of filaments for deposition of diamond thin films

  7. 负衬底偏压热灯丝CVD金刚石膜成核的研究

    Nucleation of Diamond by Biased Hot Filament Chemical Vapor Deposition

  8. 热灯丝CVD金刚石膜硼掺杂效应研究

    Study of boron doped diamond films by hot filament CVD

  9. 根据相对聚焦强度公式,分析了灯丝上发出的光线在通过旋转抛物面反射到测试屏幕上的B,C两点时所具有的完全聚焦现象,并说明了这种聚焦的现象是一阶的。

    In this article , based on the relative focusing formula , we discuss the sharp focusing phenomenon and point out that it is one order .

  10. 针对灯丝模型计算的繁杂,利用Visualc++编程环境,自行开发灯丝设计的软件系统。

    Considering the complicated calculation of filament model , the computer aided design software system of the filament is developed based on Visual C + + .

  11. 热灯丝辅助射频等离子体CVD法生长立方氮化硼膜的研究

    Study on cubic boron nitride films deposited by thermal filament assisted RF plasma CVD

  12. 于是,电流通过C1、Rt形成回路预热灯丝。

    Then current through C1 , RT forms the return circuit-preheating filament .

  13. 在谐振变换器分析的基础上,阐述了高压发生器灯丝电源通过脉宽调制PWM方式调节灯丝输出电流的原理与实现方法。

    Based on the resonant converter analysis , expounds the filament power supply theory and its realization method with PWM mode .

  14. 研究了多壁碳纳米管(MWNTs)薄膜的湿敏特性,实验所用的多壁碳纳米管是用热灯丝化学气相沉积法(CVD)合成的。

    The humidity sensitive properties of multiwalled carbon nanotubes ( MWNTs ) films have been studied .

  15. 仅仅考虑灯丝高能电子对电子温度测量误差的影响,传统的方法求出的Te误差可达80%&200%。

    The error of electron temperature distorted by high energy electrons is as large as 80 % - 200 % .

  16. 聚醚型氨纶裸丝染色性的探索负衬底偏压热灯丝CVD金刚石膜成核的研究

    Study on the Dyeability of Bare Filament of Polyether Urethane Fibre Nucleation of Diamond by Biased Hot Filament Chemical Vapor Deposition

  17. 灯丝结构本身所产生的HUM。

    Hum produced from within the filamentary structure .

  18. 对利用热灯丝CVD沉积金刚石膜时负衬底偏压增强金刚石的核化过程进行了分析。

    In the paper , the enhancing process of diamond nucleation by negative substrate bias in hot filament CVD system was analyzed .

  19. 基于Cuk变换器的行波管灯丝电源

    Travelling Wave Tube Filament Power Supply Based on Cuk Converter

  20. 本文研究了热灯丝射频等离子体CVD法合成的立方氮化硼薄膜(c-BN),反应气体是8_2H_6和NH_3,衬底材料为Si单晶。

    The cubic boron nitride films have been synthesized by hot filament assisted RF plasma chemical vapor deposition ( CVD ) from the reactive gases of B_2H_6 and NH_3 on silicon substrate .

  21. LED是一种半导体发光器件,由于其结构特点,因此它不会和传统灯泡一样容易产生灯丝发光易烧、热沉积、光衰等情况。

    LED is a semiconductor light-emitting device , because of its structural features , it will not like the traditional light bulb to produce heat deposition and filament light easy to burn , the light fades and so on .

  22. 在位于翠贝卡区(TriBeCa)的SchoolhouseElectricSupplyCo.,她对橱窗里的离子C系列(IonC-Series)灯具喜爱有加:裸灯泡和暴露在外的灯丝,拧在色彩鲜艳、五颜六色的基座上。

    At the Schoolhouse Electric Supply Co. showroom in TriBeCa , she admired the Ion C-Series lamps in the window : bare bulbs with exposed filaments on brightly colored bases .

  23. 该IC包括灯点燃失败保护、灯丝失效保护、过温保护、灯在正常工作过程中熄灭的保护以及自动重启功能。

    Protection from failure of a lamp-striking , filament failure , thermal overload , or lamp failure during normal operation , as well as an automatic restart function , have been included in the design .

  24. 在位于翠贝卡区(TriBeCa)的SchoolhouseElectric&SupplyCo.,她对橱窗里的离子C系列(IonC-Series)灯具喜爱有加:裸灯泡和暴露在外的灯丝,拧在色彩鲜艳、五颜六色的基座上。

    At the Schoolhouse Electric & Supply Co. showroom in TriBeCa , she admired the Ion C-Series lamps in the window : bare bulbs with exposed filaments on brightly colored bases .

  25. 采用热灯丝CVD法在硅上制备金刚石薄膜,采用三氧化二硼制备硼掺杂金刚石膜.利用拉曼光谱分析硼掺杂金刚石膜的生长情况。

    We use hot-filament-assisted chemical vapor deposition ( HF-CVD ) to prepare boron-doped diamond film on Si with B 2O 3 . BDD film 's growth condition was studied with Raman spectroscopy .

  26. 研究用热灯丝化学气相沉积(HFCVD)法在M0衬底上生长多晶金刚石膜。

    In this paper , the growth of polycrystalline diamond films on M 0 substrate by HFCVD was studied .

  27. 用热灯丝铺助化学汽相沉积(HFACVD)法,以H2十CH4为原料在钼基板上沉积出了金刚石膜。

    Diamond thin films were deposited on molybdenum substrate by Hot Filament Assisted Chemical Vapour Deposition ( HFACVD ) method in H2 plus CH4 mixture precursor .

  28. 介绍了一种基于Cuk变换器的行波管灯丝电源。

    A travelling wave tube ( TWT ) filament power supply based on Cuk converter is introduced in this paper .

  29. 采用灯丝放电和射频(RF)辉光放电等离子体浸没离子注入(PIII)工艺对45钢表面进行了氮离子注入强化处理。

    Surface modification of 45 steel was investigated by hot filament gas discharge and radio-frequency ( RF ) glow discharge nitrogen plasma immersion ion implantation ( PIII ) techniques .

  30. 分析比较了灯丝放电PIII和射频辉光放电PIII对基体表面进行氮离子注入后的改性效果。

    Modification effect of hot filament gas discharge PIII was compared with that of radio-frequency ( RF ) glow discharge PIII .