缝隙腐蚀

  • 网络Crevice corrosion;point corrosion
缝隙腐蚀缝隙腐蚀
  1. 欠保护状态下,缝隙腐蚀会发生,缝隙内溶液pH值降低;

    Under unprotection condition , crevice corrosion can happen and the pH value of solution reduces in the crevice ;

  2. 离子注入Cr、Mo、Al对碳钢缝隙腐蚀行为的影响

    Effects of ion implantation of cr , Mo and Al on crevice corrosion behaviour of carbon steel

  3. Cu基形状记忆合金在生理盐水中的缝隙腐蚀

    Crevice corrosion of Cu based shape memory alloy in saline solution

  4. 提高污水的pH值,能降低碳钢的均匀腐蚀速度,但pH值过高易引起碳钢的缝隙腐蚀。因此,pH值应小于8.5。

    Increasing pH value can decrease the uniform corrosion rate on low carbon steel , but the crevice corrosion exacerbates when the pH value is too high ( over 8 . 5 ) .

  5. 但在厦门站潮差区暴露4a后,由于特殊的海水环境和试验设施,该合金局部发生海生物附着下的缝隙腐蚀。

    After exposure in Xiamen tide station for 4a , the alloy locally generated crevice corrosion by marine biofouling .

  6. 镀层在HCl溶液中的腐蚀属于点蚀,在H2SO4、H3PO4和FeCl3溶液中的腐蚀属于缝隙腐蚀。

    The coating corrosion was pitting corrosion in HCl solution and crevice corrosion in H_2SO_4 , H_3PO4 and FeCl_3 solutions .

  7. 结果表明,CO2使钢的腐蚀速度、点蚀倾向和缝隙腐蚀倾向增加,而增加的幅度则受到钢的成分、显微组织等冶金因素的影响。

    The result shows that CO2 makes the rate of corrosion , the tendency of pit and crevice corrosion increase , while the increased margin is influenced by the metallurgical parameters , including chemical composition , microstructure and so on .

  8. 结果表明:高速钢表面电弧离子镀TiN和(Ti,Cr)N复合膜均可提高其耐腐蚀性能,薄膜的腐蚀主要有小孔腐蚀、缝隙腐蚀及电偶腐蚀。

    The results show that the TiN and ( Ti , Cr ) N composite films significantly increase the corrosion-resistance of the steel and that pinhole corrosion dominates , along with seam corrosion and electrochemical corrosion in the film .

  9. MD-82型飞机货舱结构缝隙腐蚀原因分析及防腐蚀改进措施

    Crevice corrosion causes and improved anticorrosive measures of the lower structure of cargo compartment in MD-82 model airplane

  10. 采用电化学方法研究了Cu-Zn-Al形状记忆合金及其BTA钝化处理试样在Hank's人工体液中的缝隙腐蚀行为。

    The crevice corrosion of the benzotriazole ( BTA ) passive specimens of the shape memory alloy Cu Zn Al in Hank 's artificial body fluid has been studied using electrochemical tests .

  11. Na2SO4是中性溶液中铝的吸附型缓蚀剂,延缓了缝隙腐蚀的发生。

    It was suggested that Na_2SO_4 was an adsorption inhibitor for pure aluminium in neutral solution , and crevice corrosion of the pure aluminum was restrained availably .

  12. 结果表明:(1)缝隙腐蚀存在一个临界电位V(CREV);

    Laboratory date indicate : ( 1 ) There exists a critical potential V_ ( CREV ) for crevice corrosion . When a specimen is polarized to a potential more positive than V_ ( CREV ), crevice corrosion is likely to grow .

  13. 结果表明:在人工体液中,Cu-Zn-Al形状记忆合金的耐缝隙腐蚀性能优于未进行热处理的Cu-Zn-Al合金,其作用机理是单相马氏体组织改善了合金的电化学行为,抑制了活性溶解。

    The results show that the shape memory alloy Cu Zn Al exhibits better property than the annealed alloy Cu Zn Al . The reason is that the martensite single phase in the alloy Cu Zn Al improves electrochemical property and inhibits active solution .

  14. 缝隙腐蚀与电偶腐蚀的混合型腐蚀形态与防腐措施

    Anticorrosion measures for combinational type of galvanic corrosion with crevice corrosion

  15. 不锈钢密封面在醋酸中的缝隙腐蚀及对策

    Crevice Corrosion of Stainless Steel Seal Surface in Acetic Acid and Countermeasures

  16. 骨内种植体覆盖螺丝的缝隙腐蚀研究

    Studies on the Crevice Corrosion of Cover Screw of Implant in Endosseous

  17. GB/T10127-1988不锈钢三氯化铁缝隙腐蚀试验方法

    Stainless steels & Method of ferric chloride crevice corrosion test

  18. 合金元素铁对钛缝隙腐蚀性能的影响

    Influence of iron as alloying element on crevice corrosion behavior of titanium

  19. 阴极保护防止绝缘覆盖层下金属的缝隙腐蚀

    Cathodic protection against crevice corrosion of metals beneath insulating coatings

  20. 钛制换热器缝隙腐蚀研究与探讨

    Study and discussion on crack corrosion of titanium heat exchanger

  21. 金属缝隙腐蚀时缝内电化学行为的研究

    A Study on the Electrochemistry Behavior of the Alloys in the Manmade Crevices

  22. 不锈钢太阳能贮热水箱的缝隙腐蚀

    Crevice corrosion on stainless steel solar hot water tank

  23. 这一过程与经典的金属缝隙腐蚀机理相吻合。

    This process was coincident with classic theory of crevice corrosion of metal .

  24. 缝隙腐蚀的发生是由于形成了金属离子浓差电池。

    The occurring of crevice corrosion is attributed to the metal ions concentration cell .

  25. 液氯钢瓶缝隙腐蚀的机理分析及防范措施

    Mechanism Analysis of the Crevice Corrosion of Liquid Chlorine Steel Cylinders and Protection Methods

  26. 铝合金在飞溅区的缝隙腐蚀比点蚀严重。

    Crevice corrosion of aluminium alloys in splash zone was more serious than pitting .

  27. GB/T13671-1992不锈钢缝隙腐蚀电化学试验方法

    Stainless steels-Method of electrochemical test for crevice corrosion

  28. 海洋环境中两种铝合金缝隙腐蚀缓蚀剂及缓蚀机理的研究

    Research on Inhibitors for the Crevice Corrosion and Mechanism of Two Aluminium Alloys in Seawater

  29. 在潮汐区暴露的不锈钢受点蚀和缝隙腐蚀破坏。

    The stainless steels exposed to tidal zone were attacked by pitting and crevice corrosion .

  30. 工业纯钛的缝隙腐蚀探讨

    Crevice corrosion discussion of commercial pure titanium