装料量

影响单晶成本的部分因素是单晶炉的性能和单晶炉的装料量。

The monocrystal cost is partially determined by the performance of the grower and the crucible charge .

合适的工艺条件：浆料比1.3∶1、黑曲霉接种量2%、装料量25g、自然pH值、发酵温度30~33℃、发酵周期5d。

The appropriate technological conditions were : pulp-material ratio 1.3 ∶ 1 , grafting amount of aspergillus niger 2 % , material loading 25 g , natural pH value , fermentation temperature 30 ~ 33 ℃, fermentation cycle 5 d.

方法：通过单因素试验，初步考察了初始含水量、pH值、装料量、接种量、种龄、补水方式、培养时间和培养温度8个因素对红曲霉荞麦固态发酵产monacolink的影响。

Methods : Through single-factor test , the effects of initial water content , initial pH , filling quantity , inoculum size , age of seed , methods of additional water , culture time and culture temperature on Monacolin K yield by Monascus solid-state fermentation were primarily discussed .

作者介绍了一台工作空间2400×1600×600mm、最大装料量4t的全液压传动电液压清砂设备的用途、特点、主要技术参数及设备的组成情况。

An introduction is made to the uses , distinguishing features , main technical parameters and formation of a full hydraulic transmission electro-hydraulic cleaning equipment which has a working space of 2400x1600 × 600mm and a maximum charg - ing volume of 4t .

在每次装料量为3kg绿麦芽，空气流量为100m3/h的条件下，研究了9种绿麦芽的喷动干燥工艺，并对干燥产品的质量进行了多指标的检测。

Nine experiments of drying green malt were carried out with the spouted bed on conditions that 3 kg green malt was charged and air flow rate was 100 m3 / h each time . The quality of malt was examined in terms of several indexes .

闭锁料斗中催化剂装料量在线估算和调整

Estimation and Adjustment of Catalyst Loading in the Lock Hopper on Line

用此方法估算的催化剂装料量的精度基本满足工艺生产要求。

The accuracy can meet the demand of production by applying this method .

结果表明，钨粉粒度与还原温度、舟装料量、氢气流量和推舟速度成线性关系。

The results of the experiment showed that tungsten powder particle-size depends on the ertempature , flow of hydrogen , bed depth and pushing rate of boat .

采用单因素试验，分别筛选出麸皮、豆粕粉、装料量、初始料水比、接种量为影响其抗菌脂肽产量的关键因子。

Bran , bean , medium account , initial ration of water and medium and inoculum size were chose as the key factors after single factor experiments .

由于罐内抽真空、罐外常压加热，还原罐的尺寸小，单罐装料量低，还原罐产能低，热效率不高，而且是间断生产，生产能力和劳动生产力低。

Since the retort is vacuumed inside and heated under the normal pressure outside , small-size retort , low forced filling rate , low production capacity and thermal efficiency , batch production and low productivity are lead to .

所考察的三个因素是空气流量、热空气温度和湿麦装料量。各因素的水平为：空气流量取42、54、71m3/h（20℃，101.3kPa）；

The factors were the air flow rate , the temperature of hot air and the load of wet wheat . The levels of the air flow rate were 42 , 54 , 71 m ~ 3 / h ( 20 ℃, 101.3 kPa );

基于固定床、积分柱塞流与微分混合流的假设建立了理论计算模型，使用这个模型可以根据装料量少耗时短的微分萃取试验结果来较为准确地计算出相同条件下积分萃取的过程。

A mathematical model based on the hypothesis of fixed bed , plug-flow in integral run and mixed-flow in differential run is set up . Using this model we can calculate the results of integral extraction on the base of differential extraction which uses small materiel and occupies less time .

自动装料装置大大提高了装料效率和装料量。

The loading efficiency and capacity was greatly improved .