干燥时间

ɡān zào shí jiān
  • drying time;time of drying
干燥时间干燥时间
  1. 花粉活力随干燥时间延长而增加,在24h达到相比较好的萌发率,干燥时间为36h,花粉萌发率开始出现下降。

    But when drying time reached 36h , pollen germination rates began to decrease .

  2. 以鲜乳为原料,研究在4.02kW的相同功率、不同的真空度条件下,干燥时间对乳干燥后的状态、质量、温度、维生素C的含量的影响。

    Taken milk as raw material of our experiment , we studied the effect of drying time on form , weight , temperature , content of vitamin C of dried milk with same microwave power and different degree of vacuum .

  3. 最佳工艺条件:盐析温度为0℃,pH值为5,转速为6000r/min,冷冻干燥时间为24h。

    The optimal extraction condition was that the salt deposition temperature was 0 ℃, the pH value 5 and 6 000 r / min and the freeze-drying time 24 h.

  4. 结果表明,利用微波照射替代电烘箱加热,可使沉淀物的干燥时间由12h缩短为12min。

    The drying time of the sediment decreased from 12 h of the traditional heating method to 12 min of the microwave radiation .

  5. 干燥时间15min;

    Drying time 15 min ;

  6. 在2-5小时内,干燥时间对原料芦丁的含量影响较小,最佳原料处理条件为:60℃,4h。

    Within 2-5 hours , drying time have a little effect on rutin content of the raw materials , best pretreatment condition is 60 ° C , 4h .

  7. 随着青刈黑麦干燥时间延后,其粗蛋白质含量不断降低,NDF、ADF含量不断增加,导致青刈黑麦营养价值下降。

    With the drying time of forage rye being extended , the CP content was decreasing , NDF and ADF content were increasing , causing the nutritional value decreased .

  8. 在本实验范围内的最佳条件为微波功率525W、干燥时间90s、物料重量15g。

    The optimum condition of this experiment was that the microwave power was 525 W , the dring time was 90 s , the materiel wight was 15 g.

  9. 基于催化剂的活性评价和BET、XRD、吡啶吸附红外光谱、TG等表征结果考察了载体干燥时间、制备方法、助剂Sn,K等对Pt纳米簇催化剂催化性能的影响。

    Based on the performance evaluation and BET , XRD , pyridine IR absorption spectrum , thermogravimetry characterizations of the catalysts , effects of the support dry time , the preparation method , the promoters Sn 、 K added were investigated .

  10. 用FS-30快干硅溶胶生产型壳,层间干燥时间仅2~5h,大大缩短了硅溶胶制壳周期。

    Using of FS_30 fast drying colloidal silica to make ceramic shell , the drying time is only 2-5 h between dips . The period of shell making with silica sol will be shorten .

  11. 利用闪光光解法和紫外可见光谱法研究了室温条件下,pH值的增加和干燥时间的延长对细菌视紫红质(bR)聚乙烯醇(PVA)薄膜光循环过程中M态衰减动力学的影响。

    The influence of increase of pH and dehydration time on the decay kinetics of M state in bacteriorhodopsin ( bR ) poly ( vinyl alcohol ) ( PVA ) films was studied by UV vis spectrophotometry and flash photolysis under room conditions .

  12. 在真空度为0.03~0.04MPa时,纸浆模塑制品的干燥时间能够满足工艺周期要求;

    The drying time will meet the technical requirement at 0.03 ~ 0.04MPa ;

  13. 实验结果表明,随着加热温度的上升,浆液料的不流挂时间tA和干燥时间tB都下降。不流挂时间tA控制着干燥时间tB的长短。

    Experimental results show that the non-flowing time t A and the drying time t B of the slurry decrease with the rise of the heating temperature and that the variation of the non-flowing time t A controls that of the drying time t B .

  14. 在相同室温下,LSR胶料用偶联剂的干燥时间为45min较合适;干燥条件相同、硫化温度不同的情况下,最佳硫化温度为120℃,硫化时间为30min~75min;

    The appropriate drying time for LSR coupling agent at the same room temperature is 45 min , the optimum vulcanizing temperature is 120 ℃ at same drying condition , with duration of 30 min ~ 75 min.

  15. 浆液滴的干燥时间为1.0~2.0秒。

    The drying time of the slurry droplet is 1.5-2 s.

  16. GB/T1728-1979漆膜、腻子膜干燥时间测定法

    Methods of test for drying time of coatings of paints and putties

  17. 最后建立数学模型验证干燥时间。

    A mathematical model was built to predict the vacuum freeze-drying time .

  18. 非恒定条件下连续顺流式干燥时间的计算

    Time Computation in Continuous Parallel Drying under Unsteady Condition

  19. 研究了冻干厚度与干燥时间、冻干发酵剂含水量的关系,确定了冷冻干燥工艺的基本技术参数;

    The basic factor of freeze-drying technology were determined .

  20. 用铺展系数和干燥时间来选择草甘膦助剂

    Selection of the Proper Surfactants for Glyphosate Ammonium with Spreading Coefficient and Drying time

  21. 文蛤肉真空冷冻干燥时间影响因素的实验研究

    Experimental study on Influencing Factors of vacuum freeze drying time of Meretrix Linnaeus meat

  22. 计算了冻结时间,干燥时间,并与实验值进行了比较。

    The freezing time , drying time were calculated , and contrasted by experimental value .

  23. 干燥时间随着最后水分含量接近其平衡值而迅速加长。

    The drying time increases rapidly as the final moisture content approaches its equilibrium value .

  24. 真空冷冻干燥时间的计算

    Resolving the Drying Time of Vacuum Freeze-drying

  25. 升温阶段阶段温度的变化主要取决于微波密度和干燥时间;变速干燥阶段温度的变化主要取决于微波密度、热风温度和干燥时间。

    In the warming-up period , the samples temperature depended on microwave power and drying time .

  26. 在相同的电场强度下,电介质核的损耗系数越大,所需干燥时间越短。

    Bigger loss factor results in a shorter drying time under the same electric field strength .

  27. 加德纳干燥时间记录器

    Gardner drying time recorder

  28. 通过碱液去蜡,1.5%浓度的碱液即可缩短干燥时间;

    Wax is peeled by alkali solution , dry time may be shorten by 1.5 % alkali solution ;

  29. 碘酒、乙醇组消毒效果肯定,但干燥时间较长;

    The same effect of tincture iodine and alcohol group was confirmed , but drying time was longer .

  30. 随着干燥时间增长,牙釉质表面的弹性模量减小,纳米压痕硬度增大。

    With the drying time increasing , the elastic modulus of enamel decreased , but its hardness increased .