排液

pái yè
  • Drainage;tap;run;apocenosis;kick-off
排液排液
排液[pái yè]
  1. C组阴道排液量与D组无明显差别(Ρ005)。

    The quantity of vaginal discharge in group C was as same as in group D (Ρ 0.05 ) .

  2. 在实验室内通过加碳焙烧法对Fe/C微电解进行了改性研究,并以南阳油田探-23井压裂返排液的COD去除率作为评价指标。

    Modifying Fe / C micro - electrolysis by carbon - entraining roasting method is studied in the laboratory .

  3. 当分离器内液位达到H1时,集气站控制系统GCS发出开阀信号,开始排液;

    When liquid level in separator gets to H_1 , the control system of gas-gathering system sends out signal and starts to drain off water .

  4. 压裂返排液的主要成分是羟丙基胍胶及其它的有机添加剂,具有COD严重超标的污染特征。

    Hydroxypropylguar gum and other organic additives are the predominant components of fracturing fluid recovery , which have excessive CODCr , the most important polluting characteristic of the sewage .

  5. 在地面处理系统中必须安装一个U形管,可增加液气分离器的水封高度,防止气体从液气分离器排液口间歇喷出。

    Installing an " U " style pipe in surface treating system can increase the " water seal " level of the liquid-gas separator to prevent the intermittently ejecting of gas from fluid outlets .

  6. 在假设气井中的液滴是圆球形的前提下,1969年Turner导出了气井连续排液最小流速和产量计算公式。

    In 1969 , Turner put forward the formulae of minimum gas velocity and producing rate for continuous removal liquids from gas wells by supposing that the liquid is in spherical shape .

  7. 结论:LEEP治疗各类宫颈疾病操作简单、安全,手术时间短,出血少,术后阴道排液少,治疗效果佳;

    Conclusions : The advantages to use the LEEP to management of the cervical diseases include its simpleness , safety , short operative time , less bleeding , less vaginal discharge , and high cure rate .

  8. 生产井排液速度30t/d;最小井底流压2.0MPa。

    Unloading speed in production wells is 30 t / d , the minimum bottomhole flow pressure is 20 MPa .

  9. 考虑到压裂液滞留时间长,造成地层二次污染,影响改造效果,提出了采用JS-2型不动管柱压裂排液监测一体化技术。

    JS-2 model integrative tech of fracture by unmoving stem to unload fluid and monitor is provided with a view to long time of fracture fluid to resort to cause the second time of pollution and influence reform effect .

  10. 其次是液膜的排液阶段,此时液膜厚度约为10~4(?)

    The thicknesses of the membrane were about 10 ~ 4 (?)

  11. 生物法处理压裂返排液的实验研究

    Experiment Study on treating fracturing flow - back fluid by biochemistry

  12. 锥颅间断排液治疗慢性硬膜下血肿

    Treatment of chronic subdural hematomas by intermittent drainage with twist drill

  13. 压裂酸化排液影响因素分析

    Analyses of Factors Affecting Clean Up After Hydraulic Fracturing And Acidizing Treatment

  14. 激光熔覆甲胺泵进排液阀零件密封面

    Laser Cladding Sealing Face of In outlet Valve Part in Methylamine Pump

  15. 其中放大生产压差、提高油田排液量是强化开采过程的主要方法。

    Increasing producing pressure differential and improving discharge rate are mainly used .

  16. 排液自动计量系统研究初探

    An Initial Study about Automatic Metering System of Flowing Back

  17. 排液法测定多孔陶瓷材料开孔率的探讨

    Discussion on the opening porosity of porous ceramic materials by drainage method

  18. 采用先进的排液系统,可适合任何工况条件下使用。

    Advanced drainage system ensures application in any operating conditions .

  19. 深井新型气洗排液技术研究

    Study on New Technique of Gas Clean and Cleanup in Deep Well

  20. 低温液体储箱加压排液过程计算模型比较

    Comparison of numerical model for pressurization of cryogenic liquid tank

  21. 排液燃气发生器的设计及参数计算

    Design of Flowing Generator by Propellant Burning and Parameter Calculation

  22. 容器排液时涡流的产生及其防止

    Occurrence and Protection of Turbulence when Liquid Discharging from Vessels

  23. 长井段储层均匀布酸与排液联作工艺

    Combined process of uniform distribution acid and cleanup in long hole section reservoir

  24. 实现快速排液的纤维增强压裂工艺现场应用研究

    Field application of fracturing technique with fiber enhanced proppant to rapidly flow back

  25. 油田常规排液存在速度慢、不灵活、深度浅且安全性差等问题。

    Conventional oilfield fluid flowing is slow , inflexible , shallow and unsafe .

  26. 潜水泵扩张式喷嘴排液装置的优化设计与试验

    Optimization and experimental study of expansion liquid leaking excluder device for submersible pumps

  27. 生化处理压裂返排液的试验研究

    Experimental Study of Biochemical Treatment of Fracturing Fluid Recovery

  28. 带多孔排液芯的低肋管管外凝结换热

    Condensation heat transfer on the tube with low fins and porous drainage strip

  29. 压裂气举排液及完井一趟管柱

    One-trip string for fracturing , gas lift , fluid discharge and well completion

  30. 尿素生产工艺甲铵泵进排液阀优化设计

    Optimal design to combination valve of carbonate solution pump for urea production craft