斜面
- obliquity;bevel;bezel;angular surface;inclined plane;bevel face;oblique plane;slant;side
-
[inclined plane;bevel face;oblique plane] 力学名词。倾斜的平面
-
光滑斜面上的弹簧振子运动分析
A Analysis of Spring Vibrator on a Smooth Bevel
-
斜面齿轮执行机构具有最广泛的用途和良好的操作效率。
Bevel Gears are the most versatile in that they have good efficiency .
-
屋顶的两面斜面都有破瓦片
On both slopes of the roof there are broken tiles .
-
V型全斜面六面顶超高压装置的研制
Investigation and manufacture of a V-type all-sliding cubic anvil super high pressure apparatus
-
关节结节后斜面角度明显大于正常人(p<0.01)。
The angles of posterior joint node bevel were actually bigger than that of normal persons ( p < 0.01 ) .
-
动态斜面(DIP)式溢油回收技术
Dynamic Inclined Plane Technology for Oil Spill Recovery
-
三维Z形斜面圆弧井眼轨迹控制技术
Control Technology for Borehole Trajectory on Three-dimensional " Z " Shaped Circular Arc with Inclined Planes
-
发现在26℃斜面静置培养12天后可产生ST。
ST production was detected on slant of such media at 26 ℃ for 12-day stationary cultivation .
-
利用STM观察Si(100)微斜面的表面结构
Observation of Surface Structure on Vicinal Surface of Si ( 100 ) by STM
-
胎面(包括功能尖斜面)的平均切削力(0.45N)小于4个轴面的平均切削力(1.71N),差异有统计学意义(P<0.01)。
The average cutting force ( 1.71 N ) of four axial surfaces was higher than that ( 0.45 N ) of occlusal surface ( including functional cusp inclines ) ( P < 0.01 ) .
-
基于Haralick斜面模型进行图像分割,提出了一种改进JPEG图像压缩算法。
This paper proposes an improved JPEG compression algorithm based on Haralick sloped-facet model .
-
采用基于N-S方程的CFD方法,研究矩形、斜面台阶形、圆弧形、三角形、多圆弧形以及正弦形织构表面的动压润滑性能。
The hydrodynamic lubrication performance of rectangle , inclined plane , circular-arc , triangle , multi-arc and sine surface texture was researched with CFD method based on N-S equation .
-
其次,基于CFD技术数值模拟了设计状态和沿飞行轨迹非设计状态下单膨胀斜面喷管内外流场,计算了喷管在各种飞行状态下的性能参数,并对喷管的综合性能变化规律进行了分析。
Secondly , the numerical simulation of flow for nozzle designed is conducted on design point and along flight trajectory , Parameters of performance under different flight state is computed to investigate the change of nozzle performance .
-
该机采用V形摆动臂来驱动磨耗部分沿斜面作往复磨耗运动,V形摆动臂通过连接杆与减速电机轴上的偏心轮连接。
The dental abrasive testing machine applies a V-like swing arm to driving the wearing part to move along the slope back and forth , which is connected with an eccentric wheel fixed on the crankshaft of the gear motor through a connecting rod .
-
将网格划分后的有限元模型导入到FLUENT软件中,对所建立的模型进行数值分析,进行承载力和润滑特性的分析,同时对比斜面轴承的波形波形曲面瓦轴承的润滑特性。
The finite element model after meshing into FLUENT software , the model established numerical analysis , capacity analysis and lubrication properties , while the lubricating properties of sine wave contrast slope tile bearing surface of the bearing .
-
用差动共焦光学系统作为瞄准传感器、用电容传感器进行位移监测,对倾角为10°的角规的斜面进行测量,得到分辨率小于20nm的表面形貌图。
The slope of 10 ° angle block gauge is profiled with resolution of 20 nanometer with the differential confocal microscopic system .
-
采用粘弹剂软壳(soft-shell)技术、乳化针头斜面朝下超声乳化和高负压脉冲超声模式,减少了角膜内皮细胞的损伤;
Aimed to reducing the damage to corneal endothelium , soft-shell technique , bevel-down technique and high vacuum pulse phaco mode should be chosen ;
-
种子质量的控制:斜面孢子29℃培养5d,采用冰箱(4℃)保存时间不大于60d。
The seed quality controlling was studied . The slope was cultivated at 29 for 5d and the conservative time in the refrigerator ( 4 ) was not more than 60d .
-
对典型的平面类三维面形&斜面进行了仿真实验,得到系统在Z轴(深度方向)、X轴、Y轴方向的测量误差分别为0.31%,0.22%,0.23%,达到了系统的预期要求。
The simulation experiments for typical 3-D profile ? inclined plane show that the measuring errors of the system in axis Z ( depth direction ), axis X and axis Y are 0.31 % , 0.22 % and 0.23 % , respectively , which meet with the prospected demands .
-
本论文依据EOS电子光学模拟器对收集极进行了几个方面的优化:调整各极电压,改变收集极各电极的入口半径,增加磁场值,调整收集极各极位置,加入非对称斜面等。
Collector has been optimized using electron optical simulator , EOS in several aspects : adjusting the voltage , changing the collector radius , increasing the magnetic field values , adjusting the location of collector , inclusion of non-symmetrical slope , etc. .
-
本文基于斜面法原理搭建出测试织物弯曲刚度Bz的装置,通过标准温湿度下的对比实验讨论了斜面法测得的弯曲刚度Bz与KES弯曲刚度Bk的相关性。
A device , based on cantilever method , was built to test bending stiffness . The relevance of the bending stiffness measured by device and KES was discussed by comparative experiments in standard temperature and humidity .
-
在改扩建工程中遇到在倾斜度近60°的斜面经过凿毛的老混凝土表面上,浇筑厚度仅20cm的钢筋混凝土的施工问题。
During the course of project rebuilding and extension , construction problems in pouring a layer of reinforced concrete of 2 ? cm in thickness on the old one are often encountered on the 60 ° slope .
-
又考虑到环境变化和外力干扰都有可能导致机器人行走的不稳定,基于模型的预测控制被应用于斜面行走,最终实现了斜面0.5km/h的快速稳定步行。
Considering the disturbing of unknown force , predictive control is proposed and stable walking on slopes is realized in the real robot .
-
采用最小二乘法计算系统中光伏阵列的最佳安装倾角,用Perez模型计算倾斜面上的小时太阳辐射量,建立了光伏发电系统的数学模型。
We calculate the optimal angle for installation photovoltaic arrays of the system with the using of least square method , calculate hourly solar radiation of tilted surface with the Perez model , then establish mathematical model of PV generation system .
-
经过10代PDA斜面继代培养及其摇瓶试验和连续3次3t罐的中试试验,表明所得诱变株为比原始菌株更优秀的稳定高产、高多糖含量的灵芝生产菌株。
Results of continued cultivation for 10 generation on PDA slants and successive tests of shaking bottles , and successive 3 time pilot scale tests at 3 tons , showed that these two mutants are excellent strains with steady properties , high production and high content of polysaccharides .
-
斜面结构上二维冰力计算模型的物理模拟实验研究
Physical model study of two-dimensions ice forces model on inclined structures
-
竹材胶合板铣斜面机的研制
The preparation of the bevel milling machine for processing bamboo plywood
-
微型圆盘斜面式矿物分选仪的工作原理及应用
The principle of operation of the small disc inclined mineral separator
-
关节窝前、后斜面倾斜角;
Angles of anterior slope and posterior slope of glenoid fossa ;
-
固定斜面导板打开咬合前后的模型测量研究
Measurement of pre - and post bite-opening cast with inclined biteplate