红外探头

  • 网络Infrared probe;infrared sensor;PIR Sensor
红外探头红外探头
  1. 每个红外探头内由数个红外传感器组成的阵列分别挂接在两个单片机上构成下位机子系统,空气预热器内安装数个红外探头并通过双总线结构和上位机进行实时通信。

    Each infrared probe consists of a few infrared sensors which mounted on two separate MCU . Air preheater has a number of infrared probes . Through dual bus structure , the host computer for real-time communication uses IPC data processing and final decision-making .

  2. 红外探头检测温度后,经测量放大器将温度信号转变成电压信号,经A/D转换后传输到单片机中进行分析计算。

    Then it can eliminate the interrupting of smoke and sinter of casting infrared thermometer . When the probe gets the temperature , the temperature signal is transferred into volt signal by the amplifier . Then transfer it to the single-chip to make the analysis and calculation .

  3. 使用带近红外光纤探头附件红外光谱仪鉴定翡翠B货

    Identification of B jade by FTIR spectrometer with near-IR fibre-optic probe accessory

  4. 介绍了符合热电偶热电势的红外测温探头、复合管型铠装热电偶等新型温度传感器。

    Some of the novel temperature transducers which meet the thermal potential of thermocouples , e.g. the infrared temperature probe and compound armored thermocouple are introduced .

  5. 红外轴温探头自动测试与特性分析研究

    Analysis & Research on Infrared Sensor Auto Test

  6. 采用热释电红外传感器作为探头检测人体的出现,从而实现整个红外自动门控制流程智能化。

    Using the pyroelectric infrared sensor as scanner to get information about the human body , and achieve controlling of the whole infrared automatic control system intelligence process .

  7. 建立水果的内部品质自动检测系统由光源、迈克尔逊干涉仪、近红外漫反射光纤探头组件、铟镓砷检测器、数据采集卡和水果样品室等部件组成。

    The system consisted of light source , interferometer , fiber optical sensor , InGaAs detector , data collection card and fruit holder .

  8. 热释电红外检测技术是利用热释电红外传感器作为探头,来检测人体所发出的特定波长红外线信号,进行非接触式距离较远的检测。

    For pyroelectric infrared detection technology , the pyroelectric infrared sensor is used as a probe to detect the specific-wavelength infrared signal emitted from human body for detection in a non-contact further distance .