配制溶液

由多嵌段聚醚型聚氨酯（SPEU）溶液成型加工所得制品的本体形态和表面化学结构受到配制溶液所用溶剂的显著影响。

The bulk morphology and surface composition of biomedical devices of segmented polyether urethanes ( SPEU ) made hy the methods of solution molding are affected by the properties of solvents used .

离子交联剂钙离子的存在以及配制溶液时溶剂的极性都会对聚电解质膜的力学性能产生影响。

The ionic linker of calcium ions and the solvent polarity also can influence the mechanical properties of PEC membranes .

如果实验后没有明显的损坏或褪色，用水和洗洁精配制溶液，用来清洁整张桌子。

If there is no noticeable damage or discoloration to the table 's finish , create a solution of water and liquid detergent to clean the entire table .

研究了用水处理剂处理具一定矿化度的水再用其配制聚丙烯酰胺溶液，以提高PAM粘度。

A PAM solution which treated with water treatment agent is studied .

同时用HSA和HPB处理后的采出水配制HPAM溶液，粘损小于5%，并且与地层水有较好的配伍性。

Meanwhile , the viscosity loss of HPAM solution made up by treated water is no more than 5 % , showing better compatibility with ground water .

聚合物驱产出水配制聚合物溶液的粘度损失及影响因素研究

Viscosity loss of polymer solution prepared with produced water from polymer injection and its influencing factors

进一步分别配制染料溶液和电解质，热塑封装太阳能电池，研究其光电转换性能。

After dye sensitizing and thermoplastic packaging , the photo-to-electric conversion properties of the assembled DSSC were studied .

重复配制标准溶液（从纯溶液开始）直至逐次的标准曲线彼此偏差均在10%以内。

Repeat the preparation of standards starting with pure solutions until successive calibration curves agree within 10 % .

提出了配制空白溶液的原理及方法，通过在试液中加入适量聚异丁烯乳浊液，找出了与试液粘度相同的聚异丁烯空白溶液。乳浊液进样-火焰原子吸收光谱法测定润滑油添加剂中的锌、铅

Application of Emulsion Sampling Technique in the Determination of Zinc and Lead in Lube Additives by Flame Atomic Absorption Spectrometry

先将样品先进行消解，配制成溶液，然后采用流动注射氢化物发生-原子吸收光谱法测定雪莲果中微量硒的含量。

A method for the determination of micro Pb in snow by flow injection-hydride generation-atomic absorption spectrometry has been developed .

为保证聚驱效果，聚合物驱油过程中一般采用低矿化度清水配制聚合物溶液。

To ensure the effect of polymer flooding , polymer flooding process generally use low salinity water for preparation of polymer solution .

按该配方配制的溶液使水驱采收率由38.1%提高至65.9%，具有较好的应用前景。

This oil-displacement agent solutions can increase the water-flooding oil recovery from 38.1 % to 65.9 % , thus it possesses good applying prospect .

产水配制聚合物溶液粘度优于清水，完全可以代替清水回用于聚合物驱油。

The viscidity of the reused water is better than the fresh water , so it may be suitable for oil-extraction instead of fresh water .

该文利用大庆油田聚合物驱产出水配制聚合物溶液，对聚合物溶液的粘度损失及其影响因素进行了较为系统的研究。

Daqing oil field prepared polymer solution with produced water from polymer flooding , and systematically studied the viscosity loss of polymer and the influencing factors .

采用亚沸高纯水配制各种溶液，使用65%的工艺超纯硝酸消化，以降低空白，减少误差。

Sub boiling water was employed to make up of solution and ultra pure HNO 3 was used to digest samples in order to decrease blank and error .

依据矿场生产实际需求，利用现代物理模拟技术方法，对油田目前正在使用的三种聚合物配制聚合物溶液的段塞组合进行了实验研究。

According to the requirements of polymer pilot operation , modern physical simulating technique is used to study the slug combination of polymer solution prepared by the current-adopted three kinds of polymers .

对经生化方法处理过的含聚污水与普通物化方法处理过的含聚污水配制聚合物溶液的初始粘度、粘度稳定性、储能模量、耗能模量、抗剪切性、流变性进行分析对比。

Analyzed and compared the initial viscosity , viscosity stability , storage modulus , loss modulus , shear resistance , rheology of poly-containing sewage treated by biochemical methods with poly-containing sewage treated by ordinary methods .

处理后的污水由于油含量、悬浮物含量、矿化度较高，不能用于配制聚合物溶液，只能回注水驱的中、高渗透层。

The treated oily sewage can not be used to make the solution of polymer because of having the higher content of oil 、 suspended solid and salinity , and to inject into the middle and high permeable layer only .

在大庆油田利用暴氧污水配制聚合物溶液有效地解决了污水排放问题，但这也引起了有关氧对聚合物溶液性质影响的争论。

In Daqing Oilfield , using the sewage full of oxygen to prepare the polymer solution has already resolved the problem of the sewage drainge effectively , but it also caused the dispute about the influence of the oxygen on the polymer solution property .

氢酿AR由上海凌峰化学试剂有限公司提供，灭菌双蒸水配制成原溶液。

Hydroquinone AR from shanghai LingFeng chemical agent Ltd , prepare solution with distilled water .

pH值控制在7~9、温度在10~18℃、搅拌速度在80r／min以下时，配制的聚合物溶液具有较高的粘度；

Polymer solutions made up at a pH between 7 and 9 , a temperature between 10 and 1 ℃, and a stirring rate under 80 r / min have relatively high viscosity .

本文研究了一种新型烷基膦酸酯萃取剂（5208）从人工配制的模拟溶液中萃取硝酸铀酰及分离杂质的性能，并与现在广泛使用的TBP萃取剂作了对比。

The extraction properties of uranyl nitrate from simulated solutions and its separation from impurities with a new type alkylphosphonate ester extractant were studied in the paper . It was compared with the widely used TBP .

着重探讨了交联剂浓度、pH值对污水配制HPAM聚合物溶液在80℃、隔氧条件下、长期老化后粘度的影响情况。

The paper especially discussed how pH value , the concentration of crosslink affect the viscosity of HPAM polymer solution at 80 ℃ antioxygen and long aged . When polymer flood takes enhanced oil recovery the study may give rise to great economy and society benefit .

本文用人工配制的Gamble溶液和三个酸度系列，研究了6对粉尘在模拟人体环境下96d的溶解特征和生物持久性。

The dissolving characters and bio_resistance of 6 pairs of mineral dusts in a simulated human body environment for 96 days were studied by using Gamble solution and three acid series .

以硼同位素标准参考物质NISTSRM951配制的标准溶液，在优化的操作条件下对电感耦合等离子体质谱（ICP-MS）测定的硼同位素质量进行校正，求出校正因子，确定了样品的线性浓度范围。

The boron isotope abundance measured by the inductively coupled plasma mass spectrometry ( ICP-MS ) was corrected under the optimal instrument conditions using standard solution of the boron isotope standard reference NIST SRM 951 , and both the correction factor and the linear concentration range were determined .

工业级药品配制化学镀镍溶液的研究及其应用

Study on the Preparation of Electroless Ni-plating Solution from Industrial Chemicals and the Application

配制硫化钠标准溶液存在问题的研究

The Research of Sodium Sulfide Standard Solution

配制混合标准溶液时，需注意和避免元素相互间产生的干扰；

When preparing and mixing standard solution , please notice and avoid producing interference between the elements ;

使用硅烷对花岗岩集料进行改性时，应先将硅烷配制成水解溶液。

Using silane to granite aggregates when a modification is made , it should first be silane hydrolysis solution preparation .

与光度法相比，该法简便、快速、灵敏、准确，且不受试样颜色、混浊度及沉淀的影响，无需配制任何标准溶液，可在同一电解液中连续测定十个以上试样。

It can be performed without standards , and used for the determination of a series of samples in one electrolyte continuously .