均流板

均流板均流板
  1. 对加均流板的SDA逆向喷射,与无喷射气相场相比,由于初始浆滴速度与气相间的速度差较大,浆滴对塔内烟气流场有明显扰动作用。

    Versus increasing flow equalization board in SDA under reverse injection comparied of the gas phase filed without injection . Since the initial speed difference is great between slurry and gas , the slurry play a obviously disturbed effect for flue gas flow on the tower .

  2. 结果表明:对于不同的过滤器模型,均流板的设计应有不同的方式,不能单独依照经验。

    The results show that : to different filter model , we should design different flow rectifier rather than only according to empirical .

  3. 当浆液喷射压力过大时,浆液冲到均流板上部;过小时喷射的射程不够充分,与烟气接触的时间短,这些都会影响脱硫效率。

    When too much injection pressure , the slurry will into the equalization board are the Department of the hour jet has a range insufficient , and the contact time is short , these will affect the desulfurization efficiency .

  4. 防磨改造的主要措施是在尾部烟道处安装均流孔板,以降低局部烟气流速,控制飞灰均匀分布,达到锅炉受热面防磨的效果。

    In the anti-attrition transformation of the boiler low-temperature heating surface , uniform flow orifice was mounted on the rear flue to reduce local flue gas velocity and control the even distribution of fly ash .