絮凝体

  • 网络FLOC;flocculate;flock
絮凝体絮凝体
  1. 在一定的化学条件下,絮凝体所受破碎力的大小与G值的变化成正比,G值对于絮凝体所受破碎力起着决定性的作用。

    Under a certain chemical condition , the breakage force of floc was proportional to the strength size and the velocity gradient change .

  2. G值过大会导致絮凝体破碎,造成上清液中小体积絮凝体增多。

    Oversized G value will lead to floc fragmentation , resulting in an increase in the supernatant of small and medium size floc .

  3. 电台3D仿真模拟系统的设计应用絮凝体分形仿真模拟

    The manufacture of the radio 3D simulation system A Study on the Simulation of Fractal Floc Structure

  4. 其除水色度比PFC好,除浊效果和絮凝体沉降性能又优于PAC。

    Its water leakage chromaticity is better than PFC and the flocculation body subsidence performance surpasses PAC .

  5. 絮凝体DLA模型仿真及其废水处理

    Simulation on flocs using DLA model and its application on wastewater treatment

  6. 大米草冠层通过影响底床剪切应力τb和水流紊动而对悬浮泥沙浓度、细颗粒泥沙絮凝体沉降速率产生作用。

    The canopy exerts a strong influence on the concentration , settling velocity of the flocs and deposition rate of the cohesive suspended sediment through effects on bed shear stress and turbulence of flow within the canopy .

  7. 锈蚀是加快极板钝化的重要因素,钝化速度还受电流密度,pH2Cr~(6+)浓度以及絮凝体吸附的影响。

    Rust corrosion is an important factor in accelerating electrode passivation , besides , current density , pH , Cr ~ ( 6 + ) content and the adsorption of floccules also have influence on the rate of passivation .

  8. 结果表明:SBR系统中的活性污泥对水流剪切力的变化较敏感;剪切力会影响活性污泥的微生物生态系统,改变絮凝体的结构;

    The results show that activated sludge in SBR system is sensitive to the variation of hydrodynamic shear stress , and that the shear stress has some influences on the microorganic ecosystem of activated sludge .

  9. 采用密度函数法、回转半径法、图像分析法分析比较了二维DLA仿真模拟絮凝体二维分形维数,得到的分形维数均随模拟絮凝体的尺寸增加而减小。

    With the help of density function method , radius of gyration method and image analyzing method , the fractal dimensions of the 2-dimensional DLA simulated floc were compared and all the fractal dimension reduce as the sizes augmented .

  10. 胞内聚合物在絮凝体与丝状菌污泥中的形成

    Formation of Intracellular Biopolymer by Aerobic Floc Sludge and Filamentous Microorganisms

  11. 腐殖酸絮凝体的形态学特征和混凝化学条件酱油废水混凝处理的特征及机理研究

    Study on characteristics and mechanisms of sauce wastewater 's flocculation treatment

  12. 在此基础上探讨了絮凝体的结构。

    The structure of activated sludge floc was further explored .

  13. 长江口悬浮细颗粒泥沙絮凝体特性研究

    The Characteristics of Suspended Fine Sediment Flocs in Changjiang Estuary

  14. 泥沙絮凝体结构具有广泛意义上的自相似性。

    Mudsands aggregates structure formed from different flocculation conditions have self-similar structure widely .

  15. 长江河口细颗粒泥沙絮凝体粒径的谱分析

    Spectrum analysis of flocs diameter in the Changjiang Estuary

  16. 絮凝体强度分析方法建立及腐殖酸絮凝体强度特征研究

    Study on the Method of Floc Strength Evaluation and Characteristics of Al-Humic Floc Strength

  17. 无机悬浮颗粒的混凝特性及絮凝体形态学研究

    A Study on the Mechanism of Coagulation of Inorganic Suspended Particles and There Morphological Characteristics

  18. 细菌絮凝体对滤食性鱼类饵料效果的研究

    Bacteria floccule as diet of filter-feeding fishes

  19. 黄河泥沙架桥絮凝体分形结构的动态演变研究

    Study on dynamic evolution of fractal structure of bridging flocculated sand aggregates in Yellow River

  20. 结团凝聚工艺的研究(二)&结团絮凝体形成过程的动力分析

    A STUDY ON PELLET COAGULATION PRQCESS (ⅱ) & Dynamic Analysis of pellet Floc Formation Process

  21. 原子力显微镜对聚合物絮凝体微观结构的研究

    AFM Study of Microstructure of Polymer-clay Floccule

  22. 絮凝体的分形特性研究

    Study on fractal properties of flocs

  23. 对絮凝体形态分析表明:絮凝体平均粒径和分形维数都随搅拌时间的延长而增大,并最终趋于稳定。

    The mean diameter and fractal dimension increase with agitation time , and finally reach a steady-state .

  24. 要得到良好的沉降性能,首先要形成良好的活性污泥絮凝体。

    To gain a good settleability , good activated sludge floc must be formed first of all .

  25. 腐殖酸铝盐絮凝体的动态特性

    Dynamic Properties of Al-humic Flocs

  26. 证明可以通过监测絮凝体的分形维数来控制絮凝过程。

    The results were certain that the flocculation process can be controled by meteraging of the flocs'fractal dimension .

  27. 长江口北槽细颗粒悬沙絮凝体的沉降速率的近似估算

    Approximate Estimations of Settling Velocities of Fine Suspended Mud Flocs at the North Passage of the Changjiang Estuary

  28. 实验结果证实了絮凝体存在由聚合物桥接吸附在粘土表面上所形成的网状结构;

    It has been confirmed that net structure originated from polymer bridging adsorption existed in AFM picture of floccule .

  29. 因此,絮凝体的形态学特征和强度是固液分离技术中重要的影响因素。

    Therefore , morphological characteristics and strength of the floc are very important factors in the process of liquid-solid separation .

  30. 添加适当高分子絮凝剂能改善絮凝体的沉降速率和过滤速率。

    Rates of settling and filtration of the flock could be improved by adding certain amount of suitable high molecular flocculants .