表面温度

  • 网络Surface temperature;SST;LST;case temperature
表面温度表面温度
  1. 这颗恒星的表面温度估计在零下75摄氏度左右。

    The star 's surface temperature is reckoned to be minus 75 degrees Celsius

  2. H型连铸坯表面温度评析

    Analysis on the surface temperature of a beam blank

  3. 五段通汽烘干过程的优化与控制(二)&烘干表面温度的鲁棒H∞控制

    Optimizing and Control of Five Section Heating of Driers ( 2 ) Robust H_ ∞ Control for Surface Temperature of Drier

  4. 本文充分利用BP网结构简单和学习速度快的特点建立铸坯表面温度预测系统的模型,并利用现场数据进行仿真。

    By using characteristic of BP networks , this paper establishes a forecast model of casting billet 's exterior temperature , and to conduct simulated experiments with actual data .

  5. 测量结果显示,涂层经加热3s后,表面温度可达1000~1100℃,涂层内温度差ΔT(?)

    Measurement showed that the temperature on the coating surface after hea-ted for 3 s reached 1000 to 1100 ℃ .

  6. 将变分伴随数据同化技术应用于海表面温度(SST)数值预报。

    The variational adjoint method is used for assimilating the observed data into the sea surface temperature ( SST ) numerical models .

  7. 根据辐射测温原理,在12位AD的线阵CCD的基础上,设计并且实现了连铸铸坯的表面温度测量装置。

    On the bases of radiation theory , a temperature measurement equipment based on the 12 bit AD line-array CCD for measuring the surface temperature of casting blank is designed .

  8. 结果表明,使用Ansys和试验值是吻合的,说明使用有限元方法模拟工件表面温度场是可靠和可行的。

    The results show that there are good correlations between the values and it is reliable and feasible to simulate and predict the temperature distribution using FEM software Ansys .

  9. 以亚硫酸盐废液为物料,研究了蒸发器中流速、加热表面温度、溶液温度、固体含量、硫酸盐添加量及溶液的pH值等操作变量对结垢速率的影响。

    The effects of possible operating variable such as flow rate , surface temperature , bulk temperature , solids contents , sulfate addition and pH on the fouling of sulfite spent evaporators were studied .

  10. 通过对该数学模型的离散化,应用ANSYS软件进行数值求解,得出国产电热平板硫化机热板的工作表面温度误差。

    With a discrete approach , its temperature field is calculated by application of ANSYS software , and then we obtain numerical solution concerning the temperature difference of working surface of home product .

  11. 表面温度的升高,加速了3Y-TZP的磨损。

    The wear of 3Y-TZP ceramics was accelerated due to the elevated temperature of the wear surfaces .

  12. 然而,现实中的空间飞行器、导弹和卫星等由于表面温度的变化,导致它们外表面的BRDF与在常温时的不一样。

    But the surface temperature may be changed in reality , which results in the surface BRDFs different from the ones under room temperature .

  13. 利用MATLAB的计算和绘图功能,绘制了炉内辊磨损量和炉内辊外表面温度、热应力的实时动态关系曲线,表明炉内辊的使用过程的安全性;

    Using MATLAB calculation and drawing function , the real-time trends relation curve of the abrasion quantity and the outward surface temperature of the furnace roller and the thermal stress was drawn , and security in using the furnace roller was shown .

  14. 首先对历史光谱数据进行主成分分析(PCA)处理,再根据PCA特征数据与其表面温度的对应关系建立温度的估计模型,该模型是基于高斯核函数的。

    Firstly , the spectrum data is processed by principal component analysis ( PCA ), then , an estimating model based on a Gaussian kernel function is set up using the PCA data and their temperatures .

  15. 通过这些结果解释了GCM研究中发现的中综异常响应类型对ELNino成熟期海表面温度异常位置变化的不敏感性。

    These results could interpret the finding that the structure of the GCM 's midlatitude response is insensitive to the longitudinal position of the SST anomaly forcing during El Nino episode .

  16. 微孔硅酸钙保温材料实测总传热系数小于1.0W/(m2·K),但局部缝隙处表面温度和散热损失都较高。

    The measured total heat transfer coefficient of insulating material of microporosity calcium silicate is less than 1 . 0W / ( m2 · K ), but both the surface temperature in local cracks and the radiating heat loss are high .

  17. 火焰喷涂尼龙1010涂层在不同试验条件下的摩擦磨损性能同pv值密切相关;这是由于尼龙1010涂层的粘弹性因摩擦表面温度不同而明显不同所致;

    The friction and wear behavior of the flame-sprayed nylon-1010 coating under different test conditions was closely related to the PV value , which was because the visco-elasticity of the coating varied with the variation of the sliding surface temperature .

  18. 在宽板拉伸试验中,首次研制和开发了由EVA板、自动环境温度控制系统、自动液氮灌注系统和试样表面温度传感器相结合的低温环境箱。

    In the wide plate tensile test , the low-temperature environment box is researched and development firstly which combination of the EVA board , automatic temperature control system , automatic liquid nitrogen irrigation system and temperature measure sensor of the sample surface .

  19. 本研究对晚粳稻经60Coγ射线辐照预处理后进行低温热风干燥,探索了辐照剂量、热风温度和初始含水率对干燥过程及稻谷表面温度的影响。

    Hot-air influence of different doses of irradiation , temperature of hot air , initial moisture content of rice ( late-cropping season japonica rice ) on the rates of dehydration and surface temperature were studied .

  20. 文中利用作者确定的热带太平洋4个海温信息区SST(海水表面温度)资料,探讨了厄尔尼诺期间和反厄尔尼诺期间SST和SOI(南方涛动指数)的变化特点及其相互影响的规律。

    Based on the sea surface temperature ( SST ) of four information regions in the tropical Pacific Ocean , the characteristics and mutual influence between the SST and Southern Oscillation Indes ( SOI ) during El-Nino events are discussed .

  21. 冬季亚欧500hPa高度与下表面温度异常的大尺度相关型

    Large scale patterns of correlation between the 500 hPa geopotential height and the skin temperature anomaly in Eurasia area during boreal winter

  22. 但足当Al/TiC合金表面温度达到铝熔点时,铝开始熔化,铝的熔化导致TiC颗粒的脱落。脱落下来的TiC颗粒不断向锌液内部传输,最终将均匀分布在锌液中。

    When temperature of the Al / TiC alloy surface layer reaches to the temperature of zinc melt , aluminum melts and TiC particles drop together with it from the Al / TiC alloy and then transfer into the zinc melt and finally distribute uniformly in it .

  23. 通过与同期观测记录的海洋表面温度、海洋表层盐度进行比较分析,提出珊瑚δ18O对环境条件变化的响应特征。

    We have assessed the characteristics of coral δ ~ ( 18 ) O signals responding to environmental conditions by comparing coral δ ~ ( 18 ) O variation with a local record of sea surface temperature ( SST ) and sea surface salinity ( SSS ), respectively .

  24. 本研究基于有限元法,通过求解Pennes生物传热方程,只需提取生物体的表面温度来重构三维生物体温度分布。

    In this paper , 3-D temperature field can be reconstructed through solving Pennes bio-heat transfer inverse equation relating to the date of surface temperature , by taking advantage of the FEM ( finite element method , FEM ) .

  25. 结论:(1)在使用合适的耦合水袋时,中心温度比表面温度晚约4min达到设定温度,而水袋温度平均每4min上升1℃。

    Conclusions : For an appropriate coupled water bag - the temperature rising time at center of phantom is 4 min latter than that of the superficial temperature ascending . As for superficial temperature - the rising speed is 1 ℃ / 4 min.

  26. 内燃机气缸盖表面温度波的测试

    Surface Temperature Variation Measurement of Internal Combustion Engine 's Cylinder Head

  27. 夏玉米农田表面温度影响因素分析

    Analysis of the Factors Influencing Surface Temperature in Summer Maize Field

  28. 用4波段红外辐射计现场测量海表面温度

    Measuring the Sea Surface Temperature with the Four-Band Thermal Infrared Radiometer

  29. 模糊理论在板坯连铸机铸坯表面温度控制中的应用

    Application of fuzzy principle on surface temperature control for slab caster

  30. 红外和微波辐射计反演海表面温度的比较(英文)中清晰度红外线辐射计

    Comparison between Infrared and Microwave Radiometers for Retrieving Sea Surface Temperature