可靠寿命

  • 网络Q-precentile life;reliable life
可靠寿命可靠寿命
  1. 双参数指数分布参数、可靠性、可靠寿命的Bayesian,Fiducial及经典精确限

    Exact Bayesian , Fiducial and Classical Limits of the Parameters , Reliability and Reliable Life for the Two Parameter Exponential Distribution

  2. L11飞机机翼1肋壁板对接区可靠寿命估算

    Reliable life estimation for butt-joint area of l_ ( 11 ) aircraft No.1 wing rib panel

  3. Weibull分布百分位值(安全强度、可靠寿命等)和百分率(破坏率、可靠度等)的检验问题长期以来没有得到解决,目前工程上存在大量急需处理的此类问题。

    The percentiles and percentages of Weibull distribution cannot be tested by the traditional methods , which is urgent to be solved in engineering .

  4. 用MonteCarlo统计模拟方法对火箭发动机固体推进剂随环境温度变化的力学性能进行了分析,提出了力学性能的可靠寿命仿真计算的方法,并对延伸率的老化可靠寿命进行了计算。

    The variation of mechanical properties of a solid-propellant in rocket motor with environmental temperature was analysed by means of Monte Carlo statistical simulation method in the paper . A reliability calculation model of properties for aging and a reliable life calculation method were suggested .

  5. 并以某型导弹为例,用矩阵法估计参数、用皮尔逊X2分布检验法拟合最优检验,估计其可靠寿命,确定检测周期。

    Taking certain type missile as an example , parameter was estimated with matrix method , optimal testing was fitted with X2 distributing test method , its reliable use life was estimated , and test cycle was determined in period .

  6. 正态分布可靠寿命经典近似限的改进

    The Improved Approximate Classical Limits of Reliable Life for Normal Distribution

  7. 吊车荷载作用下钢结构吊车梁的疲劳可靠寿命评估

    Fatigue reliable life assessment of steel crane structures under crane loading

  8. 轧机轴承寿命的预测滚动轴承的可靠寿命

    Prediction of rolling mill bearing life The Reliable Life of Bearing

  9. 水润滑推力滑动轴承的耐磨损可靠寿命研究

    On Wear Resistant Reliable Life of Sliding Thrust Bearings in Water

  10. 疲劳对比试验的可靠寿命假设检验

    A Assumption Test Method of The Reliable Life in Fatigue Comparative Test

  11. 可靠性下限与可靠寿命下限间的对称原理

    Symmetrical Principle between Lower Limits of Reliability and Lower Limits of Reliable Life

  12. 疲劳可靠寿命预测的应力寿命模型

    Stress Life Model on Predication of Reliable Fatigue Life

  13. 气缸套、活塞环的可靠寿命计算

    Reliable Life Calculating of Cylinder Liner and Piston Ring

  14. 天然气管道的疲劳可靠寿命计算

    Calculation of Fatigue Reliable Life of Natural Gas Pipeline

  15. 小子样零构件可靠寿命零故障试验评估方法

    Testing assessment method of reliable life by zero-failure experiments of small sample components

  16. 最后通过算例分析结果表明,提出的可靠寿命评估方法更加合理。

    It is shown that the reliable life assessment method is more reasonable .

  17. 3300m~3天然气球罐可靠寿命计算

    Calculation of Reliable Life of 3300 m ~ 3 Natural Gas Storage Sphere

  18. 船用中速柴油发动机可靠寿命的优化

    Optimization of Lifetime Reliability of Medium-Speed Marine Diesel Engines

  19. 基于应力-寿命模型的汽车前轴可靠寿命预测

    The Prediction of Reliable Life of Automobile Shaft on the Basis of Stress-life Model

  20. 刀具磨损耐用度分布及可靠寿命的预报

    Tool Life Distribution and Tool Reliability Life Prediction

  21. 由故障率推算其可靠寿命,确定分段检测周期。

    Use life is calculated with failure rate , and the test cycle is determined .

  22. 试验结果证明涡轮盘可靠寿命数值模拟结果与实验结果吻合良好。

    It was demonstrated that the numerical results of life fit well with the experimental ones .

  23. 采用此公式可建立任意置信度的可靠寿命抽样表。

    The sample table of reliability lives for any confidence can be built by adopting the formulas .

  24. 所得结果可平行地用于对数正态分布的可靠寿命及最大维修时间的区间估计。

    The interval estimation for the reliable life and the maximum maintain time of lognormal distribution is given .

  25. 当载荷服从对数正态分布时,滚动轴承的可靠寿命具有解析式。

    If obeying logarithmic normal distribution , the reliable life of rolling bearings presents in an analytic form .

  26. 估计威布尔分布参数、可靠寿命和可靠度的置信限的新方法

    A new approach to the estimation of confidence limits on parameters and reliable life and reliability for the weibull distribution

  27. 本文讨论了可靠性下限与可靠寿命下限间的关系,指出这种关系是对称关系,亦可称对称原理。

    In this paper the symmetrical principle between lower limits of reliability and lower limits of reliable life is introduced .

  28. 推导寿命符合二参数威布尔分布时小子样可靠寿命零故障试验设计方法的理论公式,并给出置信度为95%时的相应寿命试验设计系数表。

    The theoretical formulas of the design method were deduced for experimental assessment of reliable life by small samples with the two-parameter Weibull distribution .

  29. 齿轮可靠寿命是以点蚀为判断依据的,在试验中采用了加速度振动传感器来判断点蚀。

    The judge of reliable service life is based on pitting corrosion , in the test use vibration acceleration sensor to judge the pitting corrosion .

  30. 根据推力轴承磨损规律和可靠性理论,导出了推力轴承磨损的可靠寿命计算的数学模型。

    Based on the wear law and reliability theory of the thrust bearing , the mathematical model of reliability life calculation on the wear of the thrust bearing is derived .