工程应用

  • 网络application;Engineering Application
工程应用工程应用
  1. 抗剪参数cφ与应力状态的关系及工程应用

    Relation between shear parameters c φ and stress state and its application in engineering

  2. 多学科TEAMWORK是并行工程应用、产品并行开发与设计的基础和关键。

    Multi-discipline Team Work is the key and foundation of concurrent engineering application , product concurrent development and design .

  3. 低温烧结的纳米级TiO2的脱硫性能良好,具有工程应用前景。

    Titanium dioxide which sintered at low temperature has well desulfurization charater and pretty good prospect in engineering application .

  4. Laplace小波及其工程应用

    Laplace Wavelet and its Engineering Application

  5. MSWindows系列以其友好的图形用户界面成为主流的各种应用软件的平台,提供工程应用软件的Windows版本成为一种趋势。

    Since MS Windows series have become the mainstream platforms of application software with friendly Graphic User Interface , it is a tendency to provide the Windows version of engineering application software .

  6. 充分说明以DSP为核心的数字式励磁调节器具有较快的动态响应速度,对斩控式励磁方式在同步发电机励磁控制系统的工程应用有一定的参考价值。

    At the same time , digital excitation regulator based on DSP has been fully testified , which has faster dynamic response speed and useful for engineering application with chopping control excitation approach .

  7. 但是从长远的眼光和工程应用的角度,N2、H2、NH3、N2H4以及H2O等作为MPT的推进工质,其潜在优势令人鼓舞。

    However , based on a long time viewpoint and the engineering application , MPT should apply such propellants as Nitrogen , Hydrogen , Ammonia , Hydrazine and Vapour .

  8. 结果表明:BP网络预测值和真实值之间的误差除了最大的只有0.47外,其它的误差都在0.2以内,这完全满足工程应用要求。

    The results showed that the largest error was only 0.47 between forecast value and factual true value ; the other errors are 0.2 % , which fully meet the application requirements of the project .

  9. 结构化数据和非结构化数据的统一管理是工程应用的要求,CORBA是当前分布异构对象计算的事实上的工业标准。

    It is the requirement of engineering , application to manage structured data and non-structured data conformably . CORBA is the current de facto industrial standard of distributed object computing .

  10. PC-104总线在工程应用中的关键技术

    Key Technique of PC-104 Bus in Application of engineering

  11. 优化结果与CAE模拟结果及实验验证的结果具有一致性.证明优化结果是正确的,表明基于混合神经网络与遗传算法方法的注塑工艺参数优化系统具有工程应用价值。

    The optimized outcome , being consistent with CAE simulated one and experiment tested one , is proved to be correct , which indicates that the optimization system is valuable in engineering application .

  12. 以上工作为后续R-T不稳定性的研究,和扩展SPH方法的工程应用奠定了基础。

    The current researches pave a way for us to continue investigating R-T instability and extend science and engineering applications of SPH technique .

  13. 这些准则均基于两个基本材料参数:抗拉强度σC和断裂韧度K(10c)因而,便于工程应用。

    They can be perfectly applied in engineering , because they are described only by two elementary parameters of the material : the tensile strength σ _c and the plane strain crack toughness K_ ( 10c ) .

  14. 空间对接动力学仿真软件DODASS及其工程应用

    Space docking dynamics simulation software dodass and its engineering application

  15. 附录部分还着重介绍了一种由本人牵头研制的,并已取得国家专利的新型墙体材料KGC复合轻质隔墙板,详细说明了该产品成型工艺,施工作法,安装构造、工程应用。

    It has been gotten the national patent . The molding arts , construction technique , install constitution and engineering application of this wallboard are demonstrated in detail .

  16. 用Petri网抽象描述了一系列代表性链路层协议模型,并借助Petri网模拟工具对模型进行修正和改进,得到可实际工程应用的协议模型。

    Then , a series of representative link layer protocol models using Petri net were described abstractly . By the direction of Petri net emulation tool , these models were modified and improved gradually . Finally , a protocol model which could be applied in the practical work was achieved .

  17. 布局优化问题是现代工程应用中广泛存在的一类组合优化问题,但在理论上它却属于NPC(NP-Complete)问题,如果需考虑性能约束,则问题将更难于求解。

    Layout optimization problems arise widely in modern engineering applications and are now recognized as an important category of combinatorial optimization problems . However most un constrained layout optimization problems are NP-Complete . The constrained layout optimization problems which typically arise in practice are usually equally difficult .

  18. 双向固定网格渐进结构优化方法及其工程应用

    Bi-directional Fixed Grid Evolutionary Structural Optimization Method and Its Engineering Application

  19. 建筑物隔震技术在日本的研究发展和工程应用

    Development and application of seismic isolation technology of buildings in Japan

  20. 数据和参数可供工程应用。

    The data and parameters can be used for engineering purposes .

  21. 快硬超早强混凝土的研究与工程应用

    Study and engineering application of fast hardening super early strength concrete

  22. 层状岩质边坡预应力锚索加固工程应用分析

    Engineering application analysis of prestressed anchor rope reinforcing layered rock slope

  23. 广义浅水方程及工程应用初步研究

    A Preliminary Study on Extended Shallow Water Equations and Its Application

  24. 变参数蠕变损伤本构模型及其工程应用

    Variable parameters-based creep damage constitutive model and its engineering application

  25. OI~2-SCR烟气脱硝技术及其工程应用

    Engineering Application of OI ~ 2-SCR Flue Gas Denitrification Technology

  26. 连云港软土蠕变特性及其工程应用

    Creep properties of Lianyungang soft clay and its engineering application

  27. 通过分析,为实际工程应用提供了参考。

    The analysis of tests give some advices to the practical engineering .

  28. 土石坝渗流计算模型的建立及工程应用

    Establishment and application of seepage calculation model for embankment dams

  29. 人防地下室结构设计方法与工程应用

    Structure Design and Engineering Application of Civil Air Defense Basement

  30. 声发射技术在工程应用中的若干问题及对策

    Several Problems on Engineering Application of Acoustic Emission Technique and the Solutions